Release 4.11 arch/arm/mach-sa1100/include/mach/assabet.h
/*
* arch/arm/mach-sa1100/include/mach/assabet.h
*
* Created 2000/06/05 by Nicolas Pitre <nico@fluxnic.net>
*
* This file contains the hardware specific definitions for Assabet
* Only include this file from SA1100-specific files.
*
* 2000/05/23 John Dorsey <john+@cs.cmu.edu>
* Definitions for Neponset added.
*/
#ifndef __ASM_ARCH_ASSABET_H
#define __ASM_ARCH_ASSABET_H
/* System Configuration Register flags */
#define ASSABET_SCR_SDRAM_LOW (1<<2)
/* SDRAM size (low bit) */
#define ASSABET_SCR_SDRAM_HIGH (1<<3)
/* SDRAM size (high bit) */
#define ASSABET_SCR_FLASH_LOW (1<<4)
/* Flash size (low bit) */
#define ASSABET_SCR_FLASH_HIGH (1<<5)
/* Flash size (high bit) */
#define ASSABET_SCR_GFX (1<<8)
/* Graphics Accelerator (0 = present) */
#define ASSABET_SCR_SA1111 (1<<9)
/* Neponset (0 = present) */
#define ASSABET_SCR_INIT -1
extern unsigned long SCR_value;
#ifdef CONFIG_ASSABET_NEPONSET
#define machine_has_neponset() ((SCR_value & ASSABET_SCR_SA1111) == 0)
#else
#define machine_has_neponset() (0)
#endif
/* Board Control Register */
#define ASSABET_BCR_BASE 0xf1000000
#define ASSABET_BCR (*(volatile unsigned int *)(ASSABET_BCR_BASE))
#define ASSABET_BCR_CF_PWR (1<<0)
/* Compact Flash Power (1 = 3.3v, 0 = off) */
#define ASSABET_BCR_CF_RST (1<<1)
/* Compact Flash Reset (1 = power up reset) */
#define ASSABET_BCR_NGFX_RST (1<<1)
/* Graphics Accelerator Reset (0 = hold reset) */
#define ASSABET_BCR_NCODEC_RST (1<<2)
/* 0 = Holds UCB1300, ADI7171, and UDA1341 in reset */
#define ASSABET_BCR_IRDA_FSEL (1<<3)
/* IRDA Frequency select (0 = SIR, 1 = MIR/ FIR) */
#define ASSABET_BCR_IRDA_MD0 (1<<4)
/* Range/Power select */
#define ASSABET_BCR_IRDA_MD1 (1<<5)
/* Range/Power select */
#define ASSABET_BCR_STEREO_LB (1<<6)
/* Stereo Loopback */
#define ASSABET_BCR_CF_BUS_OFF (1<<7)
/* Compact Flash bus (0 = on, 1 = off (float)) */
#define ASSABET_BCR_AUDIO_ON (1<<8)
/* Audio power on */
#define ASSABET_BCR_LIGHT_ON (1<<9)
/* Backlight */
#define ASSABET_BCR_LCD_12RGB (1<<10)
/* 0 = 16RGB, 1 = 12RGB */
#define ASSABET_BCR_LCD_ON (1<<11)
/* LCD power on */
#define ASSABET_BCR_RS232EN (1<<12)
/* RS232 transceiver enable */
#define ASSABET_BCR_LED_RED (1<<13)
/* D9 (0 = on, 1 = off) */
#define ASSABET_BCR_LED_GREEN (1<<14)
/* D8 (0 = on, 1 = off) */
#define ASSABET_BCR_VIB_ON (1<<15)
/* Vibration motor (quiet alert) */
#define ASSABET_BCR_COM_DTR (1<<16)
/* COMport Data Terminal Ready */
#define ASSABET_BCR_COM_RTS (1<<17)
/* COMport Request To Send */
#define ASSABET_BCR_RAD_WU (1<<18)
/* Radio wake up interrupt */
#define ASSABET_BCR_SMB_EN (1<<19)
/* System management bus enable */
#define ASSABET_BCR_TV_IR_DEC (1<<20)
/* TV IR Decode Enable (not implemented) */
#define ASSABET_BCR_QMUTE (1<<21)
/* Quick Mute */
#define ASSABET_BCR_RAD_ON (1<<22)
/* Radio Power On */
#define ASSABET_BCR_SPK_OFF (1<<23)
/* 1 = Speaker amplifier power off */
#ifdef CONFIG_SA1100_ASSABET
extern void ASSABET_BCR_frob(unsigned int mask, unsigned int set);
#else
#define ASSABET_BCR_frob(x,y) do { } while (0)
#endif
extern void assabet_uda1341_reset(int set);
#define ASSABET_BCR_set(x) ASSABET_BCR_frob((x), (x))
#define ASSABET_BCR_clear(x) ASSABET_BCR_frob((x), 0)
#define ASSABET_BSR_BASE 0xf1000000
#define ASSABET_BSR (*(volatile unsigned int*)(ASSABET_BSR_BASE))
#define ASSABET_BSR_RS232_VALID (1 << 24)
#define ASSABET_BSR_COM_DCD (1 << 25)
#define ASSABET_BSR_COM_CTS (1 << 26)
#define ASSABET_BSR_COM_DSR (1 << 27)
#define ASSABET_BSR_RAD_CTS (1 << 28)
#define ASSABET_BSR_RAD_DSR (1 << 29)
#define ASSABET_BSR_RAD_DCD (1 << 30)
#define ASSABET_BSR_RAD_RI (1 << 31)
/* GPIOs (bitmasks) for which the generic definition doesn't say much */
#define ASSABET_GPIO_RADIO_IRQ GPIO_GPIO (14)
/* Radio interrupt request */
#define ASSABET_GPIO_PS_MODE_SYNC GPIO_GPIO (16)
/* Power supply mode/sync */
#define ASSABET_GPIO_STEREO_64FS_CLK GPIO_GPIO (19)
/* SSP UDA1341 clock input */
#define ASSABET_GPIO_GFX_IRQ GPIO_GPIO (24)
/* Graphics IRQ */
#define ASSABET_GPIO_BATT_LOW GPIO_GPIO (26)
/* Low battery */
#define ASSABET_GPIO_RCLK GPIO_GPIO (26)
/* CCLK/2 */
/* These are gpiolib GPIO numbers, not bitmasks */
#define ASSABET_GPIO_CF_IRQ 21
/* CF IRQ */
#define ASSABET_GPIO_CF_CD 22
/* CF CD */
#define ASSABET_GPIO_CF_BVD2 24
/* CF BVD / IOSPKR */
#define ASSABET_GPIO_CF_BVD1 25
/* CF BVD / IOSTSCHG */
#endif
Overall Contributors
| Person | Tokens | Prop | Commits | CommitProp |
| Linus Torvalds (pre-git) | 181 | 52.77% | 2 | 20.00% |
| Linus Torvalds | 113 | 32.94% | 3 | 30.00% |
| Russell King | 48 | 13.99% | 4 | 40.00% |
| Nico Pitre | 1 | 0.29% | 1 | 10.00% |
| Total | 343 | 100.00% | 10 | 100.00% |
Information contained on this website is for historical information purposes only and does not indicate or represent copyright ownership.