cregit-Linux how code gets into the kernel

Release 4.11 arch/avr32/boards/merisc/setup.c

/*
 * Board-specific setup code for the Merisc
 *
 * Copyright (C) 2008 Martinsson Elektronik AB
 *
 * This program is free software; you can redistribute it and/or modify
 * it under the terms of the GNU General Public License version 2 as
 * published by the Free Software Foundation.
 */
#include <linux/clk.h>
#include <linux/etherdevice.h>
#include <linux/i2c.h>
#include <linux/i2c-gpio.h>
#include <linux/gpio.h>
#include <linux/init.h>
#include <linux/linkage.h>
#include <linux/platform_device.h>
#include <linux/types.h>
#include <linux/leds.h>
#include <linux/spi/spi.h>
#include <linux/spi/ads7846.h>
#include <linux/irq.h>
#include <linux/fb.h>
#include <linux/atmel-mci.h>
#include <linux/pwm.h>
#include <linux/leds_pwm.h>

#include <asm/io.h>
#include <asm/setup.h>

#include <mach/at32ap700x.h>
#include <mach/board.h>
#include <mach/init.h>
#include <mach/portmux.h>

#include "merisc.h"

/* Holds the autodetected board model and revision */

static int merisc_board_id;

/* Initialized by bootloader-specific startup code. */

struct tag *bootloader_tags __initdata;

/* Oscillator frequencies. These are board specific */

unsigned long at32_board_osc_rates[3] = {
	[0]	= 32768,	/* 32.768 kHz on RTC osc */
	[1]	= 20000000,	/* 20 MHz on osc0 */
	[2]	= 12000000,	/* 12 MHz on osc1 */
};


struct eth_addr {
	
u8 addr[6];
};


static struct eth_addr __initdata hw_addr[2];

static struct macb_platform_data __initdata eth_data[2];


static int ads7846_get_pendown_state_PB26(void) { return !gpio_get_value(GPIO_PIN_PB(26)); }

Contributors

PersonTokensPropCommitsCommitProp
Jonas Larsson18100.00%1100.00%
Total18100.00%1100.00%


static int ads7846_get_pendown_state_PB28(void) { return !gpio_get_value(GPIO_PIN_PB(28)); }

Contributors

PersonTokensPropCommitsCommitProp
Jonas Larsson18100.00%1100.00%
Total18100.00%1100.00%

static struct ads7846_platform_data __initdata ads7846_data = { .model = 7846, .vref_delay_usecs = 100, .vref_mv = 0, .keep_vref_on = 0, .settle_delay_usecs = 150, .penirq_recheck_delay_usecs = 1, .x_plate_ohms = 800, .debounce_rep = 4, .debounce_max = 10, .debounce_tol = 50, .get_pendown_state = ads7846_get_pendown_state_PB26, .filter_init = NULL, .filter = NULL, .filter_cleanup = NULL, }; static struct spi_board_info __initdata spi0_board_info[] = { { .modalias = "ads7846", .max_speed_hz = 3250000, .chip_select = 0, .bus_num = 0, .platform_data = &ads7846_data, .mode = SPI_MODE_0, }, }; static struct mci_platform_data __initdata mci0_data = { .slot[0] = { .bus_width = 4, .detect_pin = GPIO_PIN_PE(19), .wp_pin = GPIO_PIN_PE(20), .detect_is_active_high = true, }, };
static int __init parse_tag_ethernet(struct tag *tag) { int i; i = tag->u.ethernet.mac_index; if (i < ARRAY_SIZE(hw_addr)) { memcpy(hw_addr[i].addr, tag->u.ethernet.hw_address, sizeof(hw_addr[i].addr)); } return 0; }

Contributors

PersonTokensPropCommitsCommitProp
Jonas Larsson67100.00%1100.00%
Total67100.00%1100.00%

__tagtable(ATAG_ETHERNET, parse_tag_ethernet);
static void __init set_hw_addr(struct platform_device *pdev) { struct resource *res = platform_get_resource(pdev, IORESOURCE_MEM, 0); const u8 *addr; void __iomem *regs; struct clk *pclk; if (!res) return; if (pdev->id >= ARRAY_SIZE(hw_addr)) return; addr = hw_addr[pdev->id].addr; if (!is_valid_ether_addr(addr)) return; regs = (void __iomem __force *)res->start; pclk = clk_get(&pdev->dev, "pclk"); if (IS_ERR(pclk)) return; clk_enable(pclk); __raw_writel((addr[3] << 24) | (addr[2] << 16) | (addr[1] << 8) | addr[0], regs + 0x98); __raw_writel((addr[5] << 8) | addr[4], regs + 0x9c); clk_disable(pclk); clk_put(pclk); }

Contributors

PersonTokensPropCommitsCommitProp
Jonas Larsson18398.39%150.00%
Vasiliy Kulikov31.61%150.00%
Total186100.00%2100.00%

static struct i2c_gpio_platform_data i2c_gpio_data = { .sda_pin = GPIO_PIN_PA(6), .scl_pin = GPIO_PIN_PA(7), .sda_is_open_drain = 1, .scl_is_open_drain = 1, .udelay = 2, }; static struct platform_device i2c_gpio_device = { .name = "i2c-gpio", .id = 0, .dev = { .platform_data = &i2c_gpio_data, }, }; static struct i2c_board_info __initdata i2c_info[] = { { I2C_BOARD_INFO("pcf8563", 0x51) }, }; #if IS_ENABLED(CONFIG_LEDS_PWM) static struct pwm_lookup pwm_lookup[] = { PWM_LOOKUP("at91sam9rl-pwm", 0, "leds_pwm", "backlight", 5000, PWM_POLARITY_NORMAL), }; static struct led_pwm pwm_leds[] = { { .name = "backlight", .max_brightness = 255, }, }; static struct led_pwm_platform_data pwm_data = { .num_leds = ARRAY_SIZE(pwm_leds), .leds = pwm_leds, }; static struct platform_device leds_pwm = { .name = "leds_pwm", .id = -1, .dev = { .platform_data = &pwm_data, }, }; #endif
const char *merisc_model(void) { switch (merisc_board_id) { case 0: case 1: return "500-01"; case 2: return "BT"; default: return "Unknown"; } }

Contributors

PersonTokensPropCommitsCommitProp
Jonas Larsson34100.00%1100.00%
Total34100.00%1100.00%


const char *merisc_revision(void) { switch (merisc_board_id) { case 0: return "B"; case 1: return "D"; case 2: return "A"; default: return "Unknown"; } }

Contributors

PersonTokensPropCommitsCommitProp
Jonas Larsson37100.00%1100.00%
Total37100.00%1100.00%


static void detect_merisc_board_id(void) { /* Board ID pins MUST be set as input or the board may be damaged */ at32_select_gpio(GPIO_PIN_PA(24), AT32_GPIOF_PULLUP); at32_select_gpio(GPIO_PIN_PA(25), AT32_GPIOF_PULLUP); at32_select_gpio(GPIO_PIN_PA(26), AT32_GPIOF_PULLUP); at32_select_gpio(GPIO_PIN_PA(27), AT32_GPIOF_PULLUP); merisc_board_id = !gpio_get_value(GPIO_PIN_PA(24)) + !gpio_get_value(GPIO_PIN_PA(25)) * 2 + !gpio_get_value(GPIO_PIN_PA(26)) * 4 + !gpio_get_value(GPIO_PIN_PA(27)) * 8; }

Contributors

PersonTokensPropCommitsCommitProp
Jonas Larsson93100.00%1100.00%
Total93100.00%1100.00%


void __init setup_board(void) { at32_map_usart(0, 0, 0); at32_map_usart(1, 1, 0); at32_map_usart(3, 3, 0); at32_setup_serial_console(1); }

Contributors

PersonTokensPropCommitsCommitProp
Jonas Larsson3485.00%150.00%
Peter Ma615.00%150.00%
Total40100.00%2100.00%


static int __init merisc_init(void) { detect_merisc_board_id(); printk(KERN_NOTICE "BOARD: Merisc %s revision %s\n", merisc_model(), merisc_revision()); /* Reserve pins for SDRAM */ at32_reserve_pin(GPIO_PIOE_BASE, ATMEL_EBI_PE_DATA_ALL | (1 << 26)); if (merisc_board_id >= 1) at32_map_usart(2, 2, 0); at32_add_device_usart(0); at32_add_device_usart(1); if (merisc_board_id >= 1) at32_add_device_usart(2); at32_add_device_usart(3); set_hw_addr(at32_add_device_eth(0, &eth_data[0])); /* ADS7846 PENIRQ */ if (merisc_board_id == 0) { ads7846_data.get_pendown_state = ads7846_get_pendown_state_PB26; at32_select_periph(GPIO_PIOB_BASE, 1 << 26, GPIO_PERIPH_A, AT32_GPIOF_PULLUP); spi0_board_info[0].irq = AT32_EXTINT(1); } else { ads7846_data.get_pendown_state = ads7846_get_pendown_state_PB28; at32_select_periph(GPIO_PIOB_BASE, 1 << 28, GPIO_PERIPH_A, AT32_GPIOF_PULLUP); spi0_board_info[0].irq = AT32_EXTINT(3); } /* ADS7846 busy pin */ at32_select_gpio(GPIO_PIN_PA(4), AT32_GPIOF_PULLUP); at32_add_device_spi(0, spi0_board_info, ARRAY_SIZE(spi0_board_info)); at32_add_device_mci(0, &mci0_data); #if IS_ENABLED(CONFIG_LEDS_PWM) pwm_add_table(pwm_lookup, ARRAY_SIZE(pwm_lookup)); at32_add_device_pwm((1 << 0) | (1 << 2)); platform_device_register(&leds_pwm); #else at32_add_device_pwm((1 << 2)); #endif at32_select_gpio(i2c_gpio_data.sda_pin, AT32_GPIOF_MULTIDRV | AT32_GPIOF_OUTPUT | AT32_GPIOF_HIGH); at32_select_gpio(i2c_gpio_data.scl_pin, AT32_GPIOF_MULTIDRV | AT32_GPIOF_OUTPUT | AT32_GPIOF_HIGH); platform_device_register(&i2c_gpio_device); i2c_register_board_info(0, i2c_info, ARRAY_SIZE(i2c_info)); return 0; }

Contributors

PersonTokensPropCommitsCommitProp
Jonas Larsson27693.56%250.00%
Alexandre Belloni175.76%125.00%
Peter Ma20.68%125.00%
Total295100.00%4100.00%

postcore_initcall(merisc_init);

Overall Contributors

PersonTokensPropCommitsCommitProp
Jonas Larsson121694.12%342.86%
Alexandre Belloni644.95%114.29%
Peter Ma80.62%114.29%
Vasiliy Kulikov30.23%114.29%
Jamie Iles10.08%114.29%
Total1292100.00%7100.00%
Information contained on this website is for historical information purposes only and does not indicate or represent copyright ownership.
Created with cregit.