cregit-Linux how code gets into the kernel

Release 4.11 arch/x86/math-emu/fpu_system.h

/*---------------------------------------------------------------------------+
 |  fpu_system.h                                                             |
 |                                                                           |
 | Copyright (C) 1992,1994,1997                                              |
 |                       W. Metzenthen, 22 Parker St, Ormond, Vic 3163,      |
 |                       Australia.  E-mail   billm@suburbia.net             |
 |                                                                           |
 +---------------------------------------------------------------------------*/

#ifndef _FPU_SYSTEM_H

#define _FPU_SYSTEM_H

/* system dependent definitions */

#include <linux/sched.h>
#include <linux/kernel.h>
#include <linux/mm.h>

#include <asm/desc.h>
#include <asm/mmu_context.h>


static inline struct desc_struct FPU_get_ldt_descriptor(unsigned seg) { static struct desc_struct zero_desc; struct desc_struct ret = zero_desc; #ifdef CONFIG_MODIFY_LDT_SYSCALL seg >>= 3; mutex_lock(&current->mm->context.lock); if (current->mm->context.ldt && seg < current->mm->context.ldt->size) ret = current->mm->context.ldt->entries[seg]; mutex_unlock(&current->mm->context.lock); #endif return ret; }

Contributors

PersonTokensPropCommitsCommitProp
Juergen Gross9397.89%150.00%
Linus Torvalds (pre-git)22.11%150.00%
Total95100.00%2100.00%

#define SEG_D_SIZE(x) ((x).b & (3 << 21)) #define SEG_G_BIT(x) ((x).b & (1 << 23)) #define SEG_GRANULARITY(x) (((x).b & (1 << 23)) ? 4096 : 1) #define SEG_286_MODE(x) ((x).b & ( 0xff000000 | 0xf0000 | (1 << 23))) #define SEG_BASE_ADDR(s) (((s).b & 0xff000000) \ | (((s).b & 0xff) << 16) | ((s).a >> 16)) #define SEG_LIMIT(s) (((s).b & 0xff0000) | ((s).a & 0xffff)) #define SEG_EXECUTE_ONLY(s) (((s).b & ((1 << 11) | (1 << 9))) == (1 << 11)) #define SEG_WRITE_PERM(s) (((s).b & ((1 << 11) | (1 << 9))) == (1 << 9)) #define SEG_EXPAND_DOWN(s) (((s).b & ((1 << 11) | (1 << 10))) \ == (1 << 10)) #define I387 (&current->thread.fpu.state) #define FPU_info (I387->soft.info) #define FPU_CS (*(unsigned short *) &(FPU_info->regs->cs)) #define FPU_SS (*(unsigned short *) &(FPU_info->regs->ss)) #define FPU_DS (*(unsigned short *) &(FPU_info->regs->ds)) #define FPU_EAX (FPU_info->regs->ax) #define FPU_EFLAGS (FPU_info->regs->flags) #define FPU_EIP (FPU_info->regs->ip) #define FPU_ORIG_EIP (FPU_info->___orig_eip) #define FPU_lookahead (I387->soft.lookahead) /* nz if ip_offset and cs_selector are not to be set for the current instruction. */ #define no_ip_update (*(u_char *)&(I387->soft.no_update)) #define FPU_rm (*(u_char *)&(I387->soft.rm)) /* Number of bytes of data which can be legally accessed by the current instruction. This only needs to hold a number <= 108, so a byte will do. */ #define access_limit (*(u_char *)&(I387->soft.alimit)) #define partial_status (I387->soft.swd) #define control_word (I387->soft.cwd) #define fpu_tag_word (I387->soft.twd) #define registers (I387->soft.st_space) #define top (I387->soft.ftop) #define instruction_address (*(struct address *)&I387->soft.fip) #define operand_address (*(struct address *)&I387->soft.foo) #define FPU_access_ok(x,y,z) if ( !access_ok(x,y,z) ) \ math_abort(FPU_info,SIGSEGV) #define FPU_abort math_abort(FPU_info, SIGSEGV) #undef FPU_IGNORE_CODE_SEGV #ifdef FPU_IGNORE_CODE_SEGV /* access_ok() is very expensive, and causes the emulator to run about 20% slower if applied to the code. Anyway, errors due to bad code addresses should be much rarer than errors due to bad data addresses. */ #define FPU_code_access_ok(z) #else /* A simpler test than access_ok() can probably be done for FPU_code_access_ok() because the only possible error is to step past the upper boundary of a legal code area. */ #define FPU_code_access_ok(z) FPU_access_ok(VERIFY_READ,(void __user *)FPU_EIP,z) #endif #define FPU_get_user(x,y) get_user((x),(y)) #define FPU_put_user(x,y) put_user((x),(y)) #endif

Overall Contributors

PersonTokensPropCommitsCommitProp
Linus Torvalds (pre-git)19460.06%956.25%
Juergen Gross9930.65%16.25%
Suresh B. Siddha123.72%16.25%
Jesper Juhl72.17%212.50%
Tejun Heo61.86%16.25%
Randy Dunlap41.24%16.25%
Ingo Molnar10.31%16.25%
Total323100.00%16100.00%
Information contained on this website is for historical information purposes only and does not indicate or represent copyright ownership.
Created with cregit.