Release 4.11 drivers/ata/pata_cmd640.c
/*
* pata_cmd640.c - CMD640 PCI PATA for new ATA layer
* (C) 2007 Red Hat Inc
*
* Based upon
* linux/drivers/ide/pci/cmd640.c Version 1.02 Sep 01, 1996
*
* Copyright (C) 1995-1996 Linus Torvalds & authors (see driver)
*
* This drives only the PCI version of the controller. If you have a
* VLB one then we have enough docs to support it but you can write
* your own code.
*/
#include <linux/kernel.h>
#include <linux/module.h>
#include <linux/pci.h>
#include <linux/blkdev.h>
#include <linux/delay.h>
#include <linux/gfp.h>
#include <scsi/scsi_host.h>
#include <linux/libata.h>
#define DRV_NAME "pata_cmd640"
#define DRV_VERSION "0.0.5"
struct cmd640_reg {
int last;
u8 reg58[ATA_MAX_DEVICES];
};
enum {
CFR = 0x50,
CNTRL = 0x51,
CMDTIM = 0x52,
ARTIM0 = 0x53,
DRWTIM0 = 0x54,
ARTIM23 = 0x57,
DRWTIM23 = 0x58,
BRST = 0x59
};
/**
* cmd640_set_piomode - set initial PIO mode data
* @ap: ATA port
* @adev: ATA device
*
* Called to do the PIO mode setup.
*/
static void cmd640_set_piomode(struct ata_port *ap, struct ata_device *adev)
{
struct cmd640_reg *timing = ap->private_data;
struct pci_dev *pdev = to_pci_dev(ap->host->dev);
struct ata_timing t;
const unsigned long T = 1000000 / 33;
const u8 setup_data[] = { 0x40, 0x40, 0x40, 0x80, 0x00 };
u8 reg;
int arttim = ARTIM0 + 2 * adev->devno;
struct ata_device *pair = ata_dev_pair(adev);
if (ata_timing_compute(adev, adev->pio_mode, &t, T, 0) < 0) {
printk(KERN_ERR DRV_NAME ": mode computation failed.\n");
return;
}
/* The second channel has shared timings and the setup timing is
messy to switch to merge it for worst case */
if (ap->port_no && pair) {
struct ata_timing p;
ata_timing_compute(pair, pair->pio_mode, &p, T, 1);
ata_timing_merge(&p, &t, &t, ATA_TIMING_SETUP);
}
/* Make the timings fit */
if (t.recover > 16) {
t.active += t.recover - 16;
t.recover = 16;
}
if (t.active > 16)
t.active = 16;
/* Now convert the clocks into values we can actually stuff into
the chip */
if (t.recover > 1)
t.recover--; /* 640B only */
else
t.recover = 15;
if (t.setup > 4)
t.setup = 0xC0;
else
t.setup = setup_data[t.setup];
if (ap->port_no == 0) {
t.active &= 0x0F; /* 0 = 16 */
/* Load setup timing */
pci_read_config_byte(pdev, arttim, ®);
reg &= 0x3F;
reg |= t.setup;
pci_write_config_byte(pdev, arttim, reg);
/* Load active/recovery */
pci_write_config_byte(pdev, arttim + 1, (t.active << 4) | t.recover);
} else {
/* Save the shared timings for channel, they will be loaded
by qc_issue. Reloading the setup time is expensive so we
keep a merged one loaded */
pci_read_config_byte(pdev, ARTIM23, ®);
reg &= 0x3F;
reg |= t.setup;
pci_write_config_byte(pdev, ARTIM23, reg);
timing->reg58[adev->devno] = (t.active << 4) | t.recover;
}
}
Contributors
| Person | Tokens | Prop | Commits | CommitProp |
| Alan Cox | 378 | 99.74% | 1 | 50.00% |
| Tejun Heo | 1 | 0.26% | 1 | 50.00% |
| Total | 379 | 100.00% | 2 | 100.00% |
/**
* cmd640_qc_issue - command preparation hook
* @qc: Command to be issued
*
* Channel 1 has shared timings. We must reprogram the
* clock each drive 2/3 switch we do.
*/
static unsigned int cmd640_qc_issue(struct ata_queued_cmd *qc)
{
struct ata_port *ap = qc->ap;
struct ata_device *adev = qc->dev;
struct pci_dev *pdev = to_pci_dev(ap->host->dev);
struct cmd640_reg *timing = ap->private_data;
if (ap->port_no != 0 && adev->devno != timing->last) {
pci_write_config_byte(pdev, DRWTIM23, timing->reg58[adev->devno]);
timing->last = adev->devno;
}
return ata_sff_qc_issue(qc);
}
Contributors
| Person | Tokens | Prop | Commits | CommitProp |
| Alan Cox | 99 | 98.02% | 1 | 50.00% |
| Tejun Heo | 2 | 1.98% | 1 | 50.00% |
| Total | 101 | 100.00% | 2 | 100.00% |
/**
* cmd640_port_start - port setup
* @ap: ATA port being set up
*
* The CMD640 needs to maintain private data structures so we
* allocate space here.
*/
static int cmd640_port_start(struct ata_port *ap)
{
struct pci_dev *pdev = to_pci_dev(ap->host->dev);
struct cmd640_reg *timing;
timing = devm_kzalloc(&pdev->dev, sizeof(struct cmd640_reg), GFP_KERNEL);
if (timing == NULL)
return -ENOMEM;
timing->last = -1; /* Force a load */
ap->private_data = timing;
return 0;
}
Contributors
| Person | Tokens | Prop | Commits | CommitProp |
| Alan Cox | 74 | 98.67% | 1 | 50.00% |
| Tejun Heo | 1 | 1.33% | 1 | 50.00% |
| Total | 75 | 100.00% | 2 | 100.00% |
static bool cmd640_sff_irq_check(struct ata_port *ap)
{
struct pci_dev *pdev = to_pci_dev(ap->host->dev);
int irq_reg = ap->port_no ? ARTIM23 : CFR;
u8 irq_stat, irq_mask = ap->port_no ? 0x10 : 0x04;
pci_read_config_byte(pdev, irq_reg, &irq_stat);
return irq_stat & irq_mask;
}
Contributors
| Person | Tokens | Prop | Commits | CommitProp |
| Sergei Shtylyov | 64 | 100.00% | 1 | 100.00% |
| Total | 64 | 100.00% | 1 | 100.00% |
static struct scsi_host_template cmd640_sht = {
ATA_PIO_SHT(DRV_NAME),
};
static struct ata_port_operations cmd640_port_ops = {
.inherits = &ata_sff_port_ops,
/* In theory xfer_noirq is not needed once we kill the prefetcher */
.sff_data_xfer = ata_sff_data_xfer_noirq,
.sff_irq_check = cmd640_sff_irq_check,
.qc_issue = cmd640_qc_issue,
.cable_detect = ata_cable_40wire,
.set_piomode = cmd640_set_piomode,
.port_start = cmd640_port_start,
};
static void cmd640_hardware_init(struct pci_dev *pdev)
{
u8 ctrl;
/* CMD640 detected, commiserations */
pci_write_config_byte(pdev, 0x5B, 0x00);
/* PIO0 command cycles */
pci_write_config_byte(pdev, CMDTIM, 0);
/* 512 byte bursts (sector) */
pci_write_config_byte(pdev, BRST, 0x40);
/*
* A reporter a long time ago
* Had problems with the data fifo
* So don't run the risk
* Of putting crap on the disk
* For its better just to go slow
*/
/* Do channel 0 */
pci_read_config_byte(pdev, CNTRL, &ctrl);
pci_write_config_byte(pdev, CNTRL, ctrl | 0xC0);
/* Ditto for channel 1 */
pci_read_config_byte(pdev, ARTIM23, &ctrl);
ctrl |= 0x0C;
pci_write_config_byte(pdev, ARTIM23, ctrl);
}
Contributors
| Person | Tokens | Prop | Commits | CommitProp |
| Alan Cox | 90 | 98.90% | 2 | 66.67% |
| Jeff Garzik | 1 | 1.10% | 1 | 33.33% |
| Total | 91 | 100.00% | 3 | 100.00% |
static int cmd640_init_one(struct pci_dev *pdev, const struct pci_device_id *id)
{
static const struct ata_port_info info = {
.flags = ATA_FLAG_SLAVE_POSS,
.pio_mask = ATA_PIO4,
.port_ops = &cmd640_port_ops
};
const struct ata_port_info *ppi[] = { &info, NULL };
int rc;
rc = pcim_enable_device(pdev);
if (rc)
return rc;
cmd640_hardware_init(pdev);
return ata_pci_sff_init_one(pdev, ppi, &cmd640_sht, NULL, 0);
}
Contributors
| Person | Tokens | Prop | Commits | CommitProp |
| Alan Cox | 62 | 67.39% | 3 | 33.33% |
| Tejun Heo | 29 | 31.52% | 5 | 55.56% |
| Erik Inge Bolsö | 1 | 1.09% | 1 | 11.11% |
| Total | 92 | 100.00% | 9 | 100.00% |
#ifdef CONFIG_PM_SLEEP
static int cmd640_reinit_one(struct pci_dev *pdev)
{
struct ata_host *host = pci_get_drvdata(pdev);
int rc;
rc = ata_pci_device_do_resume(pdev);
if (rc)
return rc;
cmd640_hardware_init(pdev);
ata_host_resume(host);
return 0;
}
Contributors
| Person | Tokens | Prop | Commits | CommitProp |
| Tejun Heo | 28 | 54.90% | 1 | 20.00% |
| Alan Cox | 19 | 37.25% | 2 | 40.00% |
| Andrew Morton | 3 | 5.88% | 1 | 20.00% |
| Jingoo Han | 1 | 1.96% | 1 | 20.00% |
| Total | 51 | 100.00% | 5 | 100.00% |
#endif
static const struct pci_device_id cmd640[] = {
{ PCI_VDEVICE(CMD, 0x640), 0 },
{ },
};
static struct pci_driver cmd640_pci_driver = {
.name = DRV_NAME,
.id_table = cmd640,
.probe = cmd640_init_one,
.remove = ata_pci_remove_one,
#ifdef CONFIG_PM_SLEEP
.suspend = ata_pci_device_suspend,
.resume = cmd640_reinit_one,
#endif
};
module_pci_driver(cmd640_pci_driver);
MODULE_AUTHOR("Alan Cox");
MODULE_DESCRIPTION("low-level driver for CMD640 PATA controllers");
MODULE_LICENSE("GPL");
MODULE_DEVICE_TABLE(pci, cmd640);
MODULE_VERSION(DRV_VERSION);
Overall Contributors
| Person | Tokens | Prop | Commits | CommitProp |
| Alan Cox | 927 | 84.58% | 4 | 17.39% |
| Tejun Heo | 89 | 8.12% | 12 | 52.17% |
| Sergei Shtylyov | 69 | 6.30% | 1 | 4.35% |
| Andrew Morton | 5 | 0.46% | 1 | 4.35% |
| Bartlomiej Zolnierkiewicz | 2 | 0.18% | 1 | 4.35% |
| Jeff Garzik | 1 | 0.09% | 1 | 4.35% |
| Erik Inge Bolsö | 1 | 0.09% | 1 | 4.35% |
| Jingoo Han | 1 | 0.09% | 1 | 4.35% |
| Axel Lin | 1 | 0.09% | 1 | 4.35% |
| Total | 1096 | 100.00% | 23 | 100.00% |
Information contained on this website is for historical information purposes only and does not indicate or represent copyright ownership.