cregit-Linux how code gets into the kernel

Release 4.11 drivers/block/cciss_cmd.h

Directory: drivers/block
#ifndef CCISS_CMD_H

#define CCISS_CMD_H

#include <linux/cciss_defs.h>

/* DEFINES */

#define CISS_VERSION "1.00"

/* general boundary definitions */

#define MAXSGENTRIES            32

#define CCISS_SG_CHAIN          0x80000000

#define MAXREPLYQS              256

/* Unit Attentions ASC's as defined for the MSA2012sa */

#define POWER_OR_RESET			0x29

#define STATE_CHANGED			0x2a

#define UNIT_ATTENTION_CLEARED		0x2f

#define LUN_FAILED			0x3e

#define REPORT_LUNS_CHANGED		0x3f

/* Unit Attentions ASCQ's as defined for the MSA2012sa */

	/* These ASCQ's defined for ASC = POWER_OR_RESET */

#define POWER_ON_RESET			0x00

#define POWER_ON_REBOOT			0x01

#define SCSI_BUS_RESET			0x02

#define MSA_TARGET_RESET		0x03

#define CONTROLLER_FAILOVER		0x04

#define TRANSCEIVER_SE			0x05

#define TRANSCEIVER_LVD			0x06

	/* These ASCQ's defined for ASC = STATE_CHANGED */

#define RESERVATION_PREEMPTED		0x03

#define ASYM_ACCESS_CHANGED		0x06

#define LUN_CAPACITY_CHANGED		0x09

/* config space register offsets */

#define CFG_VENDORID            0x00

#define CFG_DEVICEID            0x02

#define CFG_I2OBAR              0x10

#define CFG_MEM1BAR             0x14

/* i2o space register offsets */

#define I2O_IBDB_SET            0x20

#define I2O_IBDB_CLEAR          0x70

#define I2O_INT_STATUS          0x30

#define I2O_INT_MASK            0x34

#define I2O_IBPOST_Q            0x40

#define I2O_OBPOST_Q            0x44

#define I2O_DMA1_CFG		0x214

/* Configuration Table */

#define CFGTBL_ChangeReq        0x00000001l

#define CFGTBL_AccCmds          0x00000001l

#define DOORBELL_CTLR_RESET     0x00000004l

#define DOORBELL_CTLR_RESET2    0x00000020l


#define CFGTBL_Trans_Simple     0x00000002l

#define CFGTBL_Trans_Performant 0x00000004l

#define CFGTBL_Trans_use_short_tags 0x20000000l


#define CFGTBL_BusType_Ultra2   0x00000001l

#define CFGTBL_BusType_Ultra3   0x00000002l

#define CFGTBL_BusType_Fibre1G  0x00000100l

#define CFGTBL_BusType_Fibre2G  0x00000200l

typedef struct _vals32
{
        
__u32   lower;
        
__u32   upper;
} 
vals32;


typedef union _u64bit
{
   
vals32	val32;
   
__u64	val;
} 
u64bit;

/* Type defs used in the following structs */

#define QWORD vals32 

/* STRUCTURES */

#define CISS_MAX_PHYS_LUN	1024
/* SCSI-3 Cmmands */

#pragma pack(1)	


#define CISS_INQUIRY 0x12
/* Date returned */

typedef struct _InquiryData_struct
{
  
BYTE data_byte[36];
} 
InquiryData_struct;


#define CISS_REPORT_LOG 0xc2    
/* Report Logical LUNs */

#define CISS_REPORT_PHYS 0xc3   
/* Report Physical LUNs */
/* Data returned */

typedef struct _ReportLUNdata_struct
{
  
BYTE LUNListLength[4];
  
DWORD reserved;
  
BYTE LUN[CISS_MAX_LUN][8];
} 
ReportLunData_struct;


#define CCISS_READ_CAPACITY 0x25 
/* Read Capacity */ 

typedef struct _ReadCapdata_struct
{
  
BYTE total_size[4];	/* Total size in blocks */
  
BYTE block_size[4];	/* Size of blocks in bytes */
} 
ReadCapdata_struct;


#define CCISS_READ_CAPACITY_16 0x9e 
/* Read Capacity 16 */

/* service action to differentiate a 16 byte read capacity from
   other commands that use the 0x9e SCSI op code */


#define CCISS_READ_CAPACITY_16_SERVICE_ACT 0x10


typedef struct _ReadCapdata_struct_16
{
	
BYTE total_size[8];   /* Total size in blocks */
	
BYTE block_size[4];   /* Size of blocks in bytes */
	
BYTE prot_en:1;       /* protection enable bit */
	
BYTE rto_en:1;        /* reference tag own enable bit */
	
BYTE reserved:6;      /* reserved bits */
	
BYTE reserved2[18];   /* reserved bytes per spec */
} 
ReadCapdata_struct_16;

/* Define the supported read/write commands for cciss based controllers */


#define CCISS_READ_10   0x28    
/* Read(10)  */

#define CCISS_WRITE_10  0x2a    
/* Write(10) */

#define CCISS_READ_16   0x88    
/* Read(16)  */

#define CCISS_WRITE_16  0x8a    
/* Write(16) */

/* Define the CDB lengths supported by cciss based controllers */


#define CDB_LEN10	10

#define CDB_LEN16	16

/* BMIC commands */

#define BMIC_READ 0x26

#define BMIC_WRITE 0x27

#define BMIC_CACHE_FLUSH 0xc2

#define CCISS_CACHE_FLUSH 0x01	
/* C2 was already being used by CCISS */


#define CCISS_ABORT_MSG 0x00

#define CCISS_RESET_MSG 0x01

#define CCISS_RESET_TYPE_CONTROLLER 0x00

#define CCISS_RESET_TYPE_BUS 0x01

#define CCISS_RESET_TYPE_TARGET 0x03

#define CCISS_RESET_TYPE_LUN 0x04

#define CCISS_NOOP_MSG 0x03

/* Command List Structure */

#define CTLR_LUNID "\0\0\0\0\0\0\0\0"


typedef struct _CommandListHeader_struct {
  
BYTE              ReplyQueue;
  
BYTE              SGList;
  
HWORD             SGTotal;
  
QWORD             Tag;
  
LUNAddr_struct    LUN;
} 
CommandListHeader_struct;

typedef struct _ErrDescriptor_struct {
  
QWORD  Addr;
  
DWORD  Len;
} 
ErrDescriptor_struct;

typedef struct _SGDescriptor_struct {
  
QWORD  Addr;
  
DWORD  Len;
  
DWORD  Ext;
} 
SGDescriptor_struct;

/* Command types */

#define CMD_RWREQ       0x00

#define CMD_IOCTL_PEND  0x01

#define CMD_SCSI	0x03

#define CMD_MSG_DONE	0x04

#define CMD_MSG_TIMEOUT 0x05

#define CMD_MSG_STALE	0xff

/* This structure needs to be divisible by COMMANDLIST_ALIGNMENT
 * because low bits of the address are used to to indicate that
 * whether the tag contains an index or an address.  PAD_32 and
 * PAD_64 can be adjusted independently as needed for 32-bit
 * and 64-bits systems.
 */

#define COMMANDLIST_ALIGNMENT (32)

#define IS_64_BIT ((sizeof(long) - 4)/4)

#define IS_32_BIT (!IS_64_BIT)

#define PAD_32 (0)

#define PAD_64 (4)

#define PADSIZE (IS_32_BIT * PAD_32 + IS_64_BIT * PAD_64)

#define DIRECT_LOOKUP_BIT 0x10

#define DIRECT_LOOKUP_SHIFT 5


typedef struct _CommandList_struct {
  
CommandListHeader_struct Header;
  
RequestBlock_struct      Request;
  
ErrDescriptor_struct     ErrDesc;
  
SGDescriptor_struct      SG[MAXSGENTRIES];
	/* information associated with the command */ 
  
__u32			   busaddr; /* physical address of this record */
  
ErrorInfo_struct * 	   err_info; /* pointer to the allocated mem */ 
  
int			   ctlr;
  
int			   cmd_type; 
  
long			   cmdindex;
  
struct list_head list;
  
struct request *	   rq;
  
struct completion *waiting;
  
int	 retry_count;
  
void * scsi_cmd;
  
char pad[PADSIZE];
} 
CommandList_struct;

/* Configuration Table Structure */

typedef struct _HostWrite_struct {
  
DWORD TransportRequest;
  
DWORD Reserved;
  
DWORD CoalIntDelay;
  
DWORD CoalIntCount;
} 
HostWrite_struct;


typedef struct _CfgTable_struct {
  
BYTE             Signature[4];
  
DWORD            SpecValence;

#define SIMPLE_MODE	0x02

#define PERFORMANT_MODE	0x04

#define MEMQ_MODE	0x08
  
DWORD            TransportSupport;
  
DWORD            TransportActive;
  
HostWrite_struct HostWrite;
  
DWORD            CmdsOutMax;
  
DWORD            BusTypes;
  
DWORD            TransMethodOffset;
  
BYTE             ServerName[16];
  
DWORD            HeartBeat;
  
DWORD            SCSI_Prefetch;
  
DWORD            MaxSGElements;
  
DWORD            MaxLogicalUnits;
  
DWORD            MaxPhysicalDrives;
  
DWORD            MaxPhysicalDrivesPerLogicalUnit;
  
DWORD            MaxPerformantModeCommands;
  
u8		   reserved[0x78 - 0x58];
  
u32		   misc_fw_support; /* offset 0x78 */

#define MISC_FW_DOORBELL_RESET (0x02)

#define MISC_FW_DOORBELL_RESET2 (0x10)
	
u8	   driver_version[32];
} 
CfgTable_struct;


struct TransTable_struct {
  
u32 BlockFetch0;
  
u32 BlockFetch1;
  
u32 BlockFetch2;
  
u32 BlockFetch3;
  
u32 BlockFetch4;
  
u32 BlockFetch5;
  
u32 BlockFetch6;
  
u32 BlockFetch7;
  
u32 RepQSize;
  
u32 RepQCount;
  
u32 RepQCtrAddrLow32;
  
u32 RepQCtrAddrHigh32;
  
u32 RepQAddr0Low32;
  
u32 RepQAddr0High32;
};

#pragma pack()	 
#endif /* CCISS_CMD_H */

Overall Contributors

PersonTokensPropCommitsCommitProp
Linus Torvalds (pre-git)36546.03%13.45%
Mike Miller23729.89%620.69%
Stephen M. Cameron9011.35%827.59%
Linus Torvalds475.93%517.24%
dann frazier202.52%26.90%
Don Brace172.14%13.45%
Jens Axboe70.88%310.34%
Andrew Morton60.76%26.90%
Hannes Reinecke40.50%13.45%
Total793100.00%29100.00%
Directory: drivers/block
Information contained on this website is for historical information purposes only and does not indicate or represent copyright ownership.
Created with cregit.