cregit-Linux how code gets into the kernel

Release 4.11 drivers/ide/tc86c001.c

Directory: drivers/ide
/*
 * Copyright (C) 2002 Toshiba Corporation
 * Copyright (C) 2005-2006 MontaVista Software, Inc. <source@mvista.com>
 *
 * This file is licensed under the terms of the GNU General Public
 * License version 2.  This program is licensed "as is" without any
 * warranty of any kind, whether express or implied.
 */

#include <linux/types.h>
#include <linux/pci.h>
#include <linux/ide.h>
#include <linux/module.h>


#define DRV_NAME "tc86c001"


static void tc86c001_set_mode(ide_hwif_t *hwif, ide_drive_t *drive) { unsigned long scr_port = hwif->config_data + (drive->dn ? 0x02 : 0x00); u16 mode, scr = inw(scr_port); const u8 speed = drive->dma_mode; switch (speed) { case XFER_UDMA_4: mode = 0x00c0; break; case XFER_UDMA_3: mode = 0x00b0; break; case XFER_UDMA_2: mode = 0x00a0; break; case XFER_UDMA_1: mode = 0x0090; break; case XFER_UDMA_0: mode = 0x0080; break; case XFER_MW_DMA_2: mode = 0x0070; break; case XFER_MW_DMA_1: mode = 0x0060; break; case XFER_MW_DMA_0: mode = 0x0050; break; case XFER_PIO_4: mode = 0x0400; break; case XFER_PIO_3: mode = 0x0300; break; case XFER_PIO_2: mode = 0x0200; break; case XFER_PIO_1: mode = 0x0100; break; case XFER_PIO_0: default: mode = 0x0000; break; } scr &= (speed < XFER_MW_DMA_0) ? 0xf8ff : 0xff0f; scr |= mode; outw(scr, scr_port); }

Contributors

PersonTokensPropCommitsCommitProp
Sergei Shtylyov16891.30%120.00%
Bartlomiej Zolnierkiewicz168.70%480.00%
Total184100.00%5100.00%


static void tc86c001_set_pio_mode(ide_hwif_t *hwif, ide_drive_t *drive) { drive->dma_mode = drive->pio_mode; tc86c001_set_mode(hwif, drive); }

Contributors

PersonTokensPropCommitsCommitProp
Bartlomiej Zolnierkiewicz1758.62%375.00%
Sergei Shtylyov1241.38%125.00%
Total29100.00%4100.00%

/* * HACKITY HACK * * This is a workaround for the limitation 5 of the TC86C001 IDE controller: * if a DMA transfer terminates prematurely, the controller leaves the device's * interrupt request (INTRQ) pending and does not generate a PCI interrupt (or * set the interrupt bit in the DMA status register), thus no PCI interrupt * will occur until a DMA transfer has been successfully completed. * * We work around this by initiating dummy, zero-length DMA transfer on * a DMA timeout expiration. I found no better way to do this with the current * IDE core than to temporarily replace a higher level driver's timer expiry * handler with our own backing up to that handler in case our recovery fails. */
static int tc86c001_timer_expiry(ide_drive_t *drive) { ide_hwif_t *hwif = drive->hwif; ide_expiry_t *expiry = ide_get_hwifdata(hwif); u8 dma_stat = inb(hwif->dma_base + ATA_DMA_STATUS); /* Restore a higher level driver's expiry handler first. */ hwif->expiry = expiry; if ((dma_stat & 5) == 1) { /* DMA active and no interrupt */ unsigned long sc_base = hwif->config_data; unsigned long twcr_port = sc_base + (drive->dn ? 0x06 : 0x04); u8 dma_cmd = inb(hwif->dma_base + ATA_DMA_CMD); printk(KERN_WARNING "%s: DMA interrupt possibly stuck, " "attempting recovery...\n", drive->name); /* Stop DMA */ outb(dma_cmd & ~0x01, hwif->dma_base + ATA_DMA_CMD); /* Setup the dummy DMA transfer */ outw(0, sc_base + 0x0a); /* Sector Count */ outw(0, twcr_port); /* Transfer Word Count 1 or 2 */ /* Start the dummy DMA transfer */ /* clear R_OR_WCTR for write */ outb(0x00, hwif->dma_base + ATA_DMA_CMD); /* set START_STOPBM */ outb(0x01, hwif->dma_base + ATA_DMA_CMD); /* * If an interrupt was pending, it should come thru shortly. * If not, a higher level driver's expiry handler should * eventually cause some kind of recovery from the DMA stall. */ return WAIT_MIN_SLEEP; } /* Chain to the restored expiry handler if DMA wasn't active. */ if (likely(expiry != NULL)) return expiry(drive); /* If there was no handler, "emulate" that for ide_timer_expiry()... */ return -1; }

Contributors

PersonTokensPropCommitsCommitProp
Sergei Shtylyov16385.79%116.67%
Bartlomiej Zolnierkiewicz2714.21%583.33%
Total190100.00%6100.00%


static void tc86c001_dma_start(ide_drive_t *drive) { ide_hwif_t *hwif = drive->hwif; unsigned long sc_base = hwif->config_data; unsigned long twcr_port = sc_base + (drive->dn ? 0x06 : 0x04); unsigned long nsectors = blk_rq_sectors(hwif->rq); /* * We have to manually load the sector count and size into * the appropriate system control registers for DMA to work * with LBA48 and ATAPI devices... */ outw(nsectors, sc_base + 0x0a); /* Sector Count */ outw(SECTOR_SIZE / 2, twcr_port); /* Transfer Word Count 1/2 */ /* Install our timeout expiry hook, saving the current handler... */ ide_set_hwifdata(hwif, hwif->expiry); hwif->expiry = &tc86c001_timer_expiry; ide_dma_start(drive); }

Contributors

PersonTokensPropCommitsCommitProp
Sergei Shtylyov8689.58%120.00%
Bartlomiej Zolnierkiewicz77.29%360.00%
Tejun Heo33.12%120.00%
Total96100.00%5100.00%


static u8 tc86c001_cable_detect(ide_hwif_t *hwif) { struct pci_dev *dev = to_pci_dev(hwif->dev); unsigned long sc_base = pci_resource_start(dev, 5); u16 scr1 = inw(sc_base + 0x00); /* * System Control 1 Register bit 13 (PDIAGN): * 0=80-pin cable, 1=40-pin cable */ return (scr1 & 0x2000) ? ATA_CBL_PATA40 : ATA_CBL_PATA80; }

Contributors

PersonTokensPropCommitsCommitProp
Bartlomiej Zolnierkiewicz55100.00%1100.00%
Total55100.00%1100.00%


static void init_hwif_tc86c001(ide_hwif_t *hwif) { struct pci_dev *dev = to_pci_dev(hwif->dev); unsigned long sc_base = pci_resource_start(dev, 5); u16 scr1 = inw(sc_base + 0x00); /* System Control 1 Register bit 15 (Soft Reset) set */ outw(scr1 | 0x8000, sc_base + 0x00); /* System Control 1 Register bit 14 (FIFO Reset) set */ outw(scr1 | 0x4000, sc_base + 0x00); /* System Control 1 Register: reset clear */ outw(scr1 & ~0xc000, sc_base + 0x00); /* Store the system control register base for convenience... */ hwif->config_data = sc_base; if (!hwif->dma_base) return; /* * Sector Count Control Register bits 0 and 1 set: * software sets Sector Count Register for master and slave device */ outw(0x0003, sc_base + 0x0c); /* Sector Count Register limit */ hwif->rqsize = 0xffff; }

Contributors

PersonTokensPropCommitsCommitProp
Sergei Shtylyov9383.04%120.00%
Bartlomiej Zolnierkiewicz1816.07%360.00%
Adrian Bunk10.89%120.00%
Total112100.00%5100.00%

static const struct ide_port_ops tc86c001_port_ops = { .set_pio_mode = tc86c001_set_pio_mode, .set_dma_mode = tc86c001_set_mode, .cable_detect = tc86c001_cable_detect, }; static const struct ide_dma_ops tc86c001_dma_ops = { .dma_host_set = ide_dma_host_set, .dma_setup = ide_dma_setup, .dma_start = tc86c001_dma_start, .dma_end = ide_dma_end, .dma_test_irq = ide_dma_test_irq, .dma_lost_irq = ide_dma_lost_irq, .dma_timer_expiry = ide_dma_sff_timer_expiry, .dma_sff_read_status = ide_dma_sff_read_status, }; static const struct ide_port_info tc86c001_chipset = { .name = DRV_NAME, .init_hwif = init_hwif_tc86c001, .port_ops = &tc86c001_port_ops, .dma_ops = &tc86c001_dma_ops, .host_flags = IDE_HFLAG_SINGLE | IDE_HFLAG_OFF_BOARD, .pio_mask = ATA_PIO4, .mwdma_mask = ATA_MWDMA2, .udma_mask = ATA_UDMA4, };
static int tc86c001_init_one(struct pci_dev *dev, const struct pci_device_id *id) { int rc; rc = pci_enable_device(dev); if (rc) goto out; rc = pci_request_region(dev, 5, DRV_NAME); if (rc) { printk(KERN_ERR DRV_NAME ": system control regs already in use"); goto out_disable; } rc = ide_pci_init_one(dev, &tc86c001_chipset, NULL); if (rc) goto out_release; goto out; out_release: pci_release_region(dev, 5); out_disable: pci_disable_device(dev); out: return rc; }

Contributors

PersonTokensPropCommitsCommitProp
Bartlomiej Zolnierkiewicz7976.70%266.67%
Sergei Shtylyov2423.30%133.33%
Total103100.00%3100.00%


static void tc86c001_remove(struct pci_dev *dev) { ide_pci_remove(dev); pci_release_region(dev, 5); pci_disable_device(dev); }

Contributors

PersonTokensPropCommitsCommitProp
Bartlomiej Zolnierkiewicz28100.00%1100.00%
Total28100.00%1100.00%

static const struct pci_device_id tc86c001_pci_tbl[] = { { PCI_VDEVICE(TOSHIBA_2, PCI_DEVICE_ID_TOSHIBA_TC86C001_IDE), 0 }, { 0, } }; MODULE_DEVICE_TABLE(pci, tc86c001_pci_tbl); static struct pci_driver tc86c001_pci_driver = { .name = "TC86C001", .id_table = tc86c001_pci_tbl, .probe = tc86c001_init_one, .remove = tc86c001_remove, };
static int __init tc86c001_ide_init(void) { return ide_pci_register_driver(&tc86c001_pci_driver); }

Contributors

PersonTokensPropCommitsCommitProp
Sergei Shtylyov1487.50%133.33%
Bartlomiej Zolnierkiewicz212.50%266.67%
Total16100.00%3100.00%


static void __exit tc86c001_ide_exit(void) { pci_unregister_driver(&tc86c001_pci_driver); }

Contributors

PersonTokensPropCommitsCommitProp
Bartlomiej Zolnierkiewicz15100.00%2100.00%
Total15100.00%2100.00%

module_init(tc86c001_ide_init); module_exit(tc86c001_ide_exit); MODULE_AUTHOR("MontaVista Software, Inc. <source@mvista.com>"); MODULE_DESCRIPTION("PCI driver module for TC86C001 IDE"); MODULE_LICENSE("GPL");

Overall Contributors

PersonTokensPropCommitsCommitProp
Sergei Shtylyov65362.07%25.71%
Bartlomiej Zolnierkiewicz39237.26%3085.71%
Paul Gortmaker30.29%12.86%
Tejun Heo30.29%12.86%
Adrian Bunk10.10%12.86%
Greg Kroah-Hartman0.00%00.00%
Total1052100.00%35100.00%
Directory: drivers/ide
Information contained on this website is for historical information purposes only and does not indicate or represent copyright ownership.
Created with cregit.