Release 4.11 drivers/memstick/host/r592.h
/*
* Copyright (C) 2010 - Maxim Levitsky
* driver for Ricoh memstick readers
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*/
#ifndef R592_H
#include <linux/memstick.h>
#include <linux/spinlock.h>
#include <linux/interrupt.h>
#include <linux/workqueue.h>
#include <linux/kfifo.h>
#include <linux/ctype.h>
/* write to this reg (number,len) triggers TPC execution */
#define R592_TPC_EXEC 0x00
#define R592_TPC_EXEC_LEN_SHIFT 16
/* Bits 16..25 are TPC len */
#define R592_TPC_EXEC_BIG_FIFO (1 << 26)
/* If bit 26 is set, large fifo is used (reg 48) */
#define R592_TPC_EXEC_TPC_SHIFT 28
/* Bits 28..31 are the TPC number */
/* Window for small TPC fifo (big endian)*/
/* reads and writes always are done in 8 byte chunks */
/* Not used in driver, because large fifo does better job */
#define R592_SFIFO 0x08
/* Status register (ms int, small fifo, IO)*/
#define R592_STATUS 0x10
/* Parallel INT bits */
#define R592_STATUS_P_CMDNACK (1 << 16)
/* INT reg: NACK (parallel mode) */
#define R592_STATUS_P_BREQ (1 << 17)
/* INT reg: card ready (parallel mode)*/
#define R592_STATUS_P_INTERR (1 << 18)
/* INT reg: int error (parallel mode)*/
#define R592_STATUS_P_CED (1 << 19)
/* INT reg: command done (parallel mode) */
/* Fifo status */
#define R592_STATUS_SFIFO_FULL (1 << 20)
/* Small Fifo almost full (last chunk is written) */
#define R592_STATUS_SFIFO_EMPTY (1 << 21)
/* Small Fifo empty */
/* Error detection via CRC */
#define R592_STATUS_SEND_ERR (1 << 24)
/* Send failed */
#define R592_STATUS_RECV_ERR (1 << 25)
/* Receive failed */
/* Card state */
#define R592_STATUS_RDY (1 << 28)
/* RDY signal received */
#define R592_STATUS_CED (1 << 29)
/* INT: Command done (serial mode)*/
#define R592_STATUS_SFIFO_INPUT (1 << 30)
/* Small fifo received data*/
#define R592_SFIFO_SIZE 32
/* total size of small fifo is 32 bytes */
#define R592_SFIFO_PACKET 8
/* packet size of small fifo */
/* IO control */
#define R592_IO 0x18
#define R592_IO_16 (1 << 16)
/* Set by default, can be cleared */
#define R592_IO_18 (1 << 18)
/* Set by default, can be cleared */
#define R592_IO_SERIAL1 (1 << 20)
/* Set by default, can be cleared, (cleared on parallel) */
#define R592_IO_22 (1 << 22)
/* Set by default, can be cleared */
#define R592_IO_DIRECTION (1 << 24)
/* TPC direction (1 write 0 read) */
#define R592_IO_26 (1 << 26)
/* Set by default, can be cleared */
#define R592_IO_SERIAL2 (1 << 30)
/* Set by default, can be cleared (cleared on parallel), serial doesn't work if unset */
#define R592_IO_RESET (1 << 31)
/* Reset, sets defaults*/
/* Turns hardware on/off */
#define R592_POWER 0x20
/* bits 0-7 writeable */
#define R592_POWER_0 (1 << 0)
/* set on start, cleared on stop - must be set*/
#define R592_POWER_1 (1 << 1)
/* set on start, cleared on stop - must be set*/
#define R592_POWER_3 (1 << 3)
/* must be clear */
#define R592_POWER_20 (1 << 5)
/* set before switch to parallel */
/* IO mode*/
#define R592_IO_MODE 0x24
#define R592_IO_MODE_SERIAL 1
#define R592_IO_MODE_PARALLEL 3
/* IRQ,card detection,large fifo (first word irq status, second enable) */
/* IRQs are ACKed by clearing the bits */
#define R592_REG_MSC 0x28
#define R592_REG_MSC_PRSNT (1 << 1)
/* card present (only status)*/
#define R592_REG_MSC_IRQ_INSERT (1 << 8)
/* detect insert / card insered */
#define R592_REG_MSC_IRQ_REMOVE (1 << 9)
/* detect removal / card removed */
#define R592_REG_MSC_FIFO_EMPTY (1 << 10)
/* fifo is empty */
#define R592_REG_MSC_FIFO_DMA_DONE (1 << 11)
/* dma enable / dma done */
#define R592_REG_MSC_FIFO_USER_ORN (1 << 12)
/* set if software reads empty fifo (if R592_REG_MSC_FIFO_EMPTY is set) */
#define R592_REG_MSC_FIFO_MISMATH (1 << 13)
/* set if amount of data in fifo doesn't match amount in TPC */
#define R592_REG_MSC_FIFO_DMA_ERR (1 << 14)
/* IO failure */
#define R592_REG_MSC_LED (1 << 15)
/* clear to turn led off (only status)*/
#define DMA_IRQ_ACK_MASK \
(R592_REG_MSC_FIFO_DMA_DONE | R592_REG_MSC_FIFO_DMA_ERR)
#define DMA_IRQ_EN_MASK (DMA_IRQ_ACK_MASK << 16)
#define IRQ_ALL_ACK_MASK 0x00007F00
#define IRQ_ALL_EN_MASK (IRQ_ALL_ACK_MASK << 16)
/* DMA address for large FIFO read/writes*/
#define R592_FIFO_DMA 0x2C
/* PIO access to large FIFO (512 bytes) (big endian)*/
#define R592_FIFO_PIO 0x30
#define R592_LFIFO_SIZE 512
/* large fifo size */
/* large FIFO DMA settings */
#define R592_FIFO_DMA_SETTINGS 0x34
#define R592_FIFO_DMA_SETTINGS_EN (1 << 0)
/* DMA enabled */
#define R592_FIFO_DMA_SETTINGS_DIR (1 << 1)
/* Dma direction (1 read, 0 write) */
#define R592_FIFO_DMA_SETTINGS_CAP (1 << 24)
/* Dma is aviable */
/* Maybe just an delay */
/* Bits 17..19 are just number */
/* bit 16 is set, then bit 20 is waited */
/* time to wait is about 50 spins * 2 ^ (bits 17..19) */
/* seems to be possible just to ignore */
/* Probably debug register */
#define R592_REG38 0x38
#define R592_REG38_CHANGE (1 << 16)
/* Start bit */
#define R592_REG38_DONE (1 << 20)
/* HW set this after the delay */
#define R592_REG38_SHIFT 17
/* Debug register, written (0xABCDEF00) when error happens - not used*/
#define R592_REG_3C 0x3C
struct r592_device {
struct pci_dev *pci_dev;
struct memstick_host *host; /* host backpointer */
struct memstick_request *req; /* current request */
/* Registers, IRQ */
void __iomem *mmio;
int irq;
spinlock_t irq_lock;
spinlock_t io_thread_lock;
struct timer_list detect_timer;
struct task_struct *io_thread;
bool parallel_mode;
DECLARE_KFIFO(pio_fifo, u8, sizeof(u32));
/* DMA area */
int dma_capable;
int dma_error;
struct completion dma_done;
void *dummy_dma_page;
dma_addr_t dummy_dma_page_physical_address;
};
#define DRV_NAME "r592"
#define message(format, ...) \
printk(KERN_INFO DRV_NAME ": " format "\n", ## __VA_ARGS__)
#define __dbg(level, format, ...) \
do { \
if (debug >= level) \
printk(KERN_DEBUG DRV_NAME \
": " format "\n", ## __VA_ARGS__); \
} while (0)
#define dbg(format, ...) __dbg(1, format, ## __VA_ARGS__)
#define dbg_verbose(format, ...) __dbg(2, format, ## __VA_ARGS__)
#define dbg_reg(format, ...) __dbg(3, format, ## __VA_ARGS__)
#endif
Overall Contributors
| Person | Tokens | Prop | Commits | CommitProp |
| Maxim Levitsky | 470 | 99.37% | 1 | 50.00% |
| Lucas De Marchi | 3 | 0.63% | 1 | 50.00% |
| Total | 473 | 100.00% | 2 | 100.00% |
Information contained on this website is for historical information purposes only and does not indicate or represent copyright ownership.