cregit-Linux how code gets into the kernel

Release 4.11 drivers/scsi/a3000.c

Directory: drivers/scsi
#include <linux/types.h>
#include <linux/mm.h>
#include <linux/ioport.h>
#include <linux/init.h>
#include <linux/slab.h>
#include <linux/spinlock.h>
#include <linux/interrupt.h>
#include <linux/platform_device.h>
#include <linux/module.h>

#include <asm/page.h>
#include <asm/pgtable.h>
#include <asm/amigaints.h>
#include <asm/amigahw.h>

#include "scsi.h"
#include "wd33c93.h"
#include "a3000.h"



struct a3000_hostdata {
	
struct WD33C93_hostdata wh;
	
struct a3000_scsiregs *regs;
};


static irqreturn_t a3000_intr(int irq, void *data) { struct Scsi_Host *instance = data; struct a3000_hostdata *hdata = shost_priv(instance); unsigned int status = hdata->regs->ISTR; unsigned long flags; if (!(status & ISTR_INT_P)) return IRQ_NONE; if (status & ISTR_INTS) { spin_lock_irqsave(instance->host_lock, flags); wd33c93_intr(instance); spin_unlock_irqrestore(instance->host_lock, flags); return IRQ_HANDLED; } pr_warning("Non-serviced A3000 SCSI-interrupt? ISTR = %02x\n", status); return IRQ_NONE; }

Contributors

PersonTokensPropCommitsCommitProp
Linus Torvalds (pre-git)5858.00%436.36%
Geert Uytterhoeven3838.00%654.55%
Linus Torvalds44.00%19.09%
Total100100.00%11100.00%


static int dma_setup(struct scsi_cmnd *cmd, int dir_in) { struct Scsi_Host *instance = cmd->device->host; struct a3000_hostdata *hdata = shost_priv(instance); struct WD33C93_hostdata *wh = &hdata->wh; struct a3000_scsiregs *regs = hdata->regs; unsigned short cntr = CNTR_PDMD | CNTR_INTEN; unsigned long addr = virt_to_bus(cmd->SCp.ptr); /* * if the physical address has the wrong alignment, or if * physical address is bad, or if it is a write and at the * end of a physical memory chunk, then allocate a bounce * buffer */ if (addr & A3000_XFER_MASK) { wh->dma_bounce_len = (cmd->SCp.this_residual + 511) & ~0x1ff; wh->dma_bounce_buffer = kmalloc(wh->dma_bounce_len, GFP_KERNEL); /* can't allocate memory; use PIO */ if (!wh->dma_bounce_buffer) { wh->dma_bounce_len = 0; return 1; } if (!dir_in) { /* copy to bounce buffer for a write */ memcpy(wh->dma_bounce_buffer, cmd->SCp.ptr, cmd->SCp.this_residual); } addr = virt_to_bus(wh->dma_bounce_buffer); } /* setup dma direction */ if (!dir_in) cntr |= CNTR_DDIR; /* remember direction */ wh->dma_dir = dir_in; regs->CNTR = cntr; /* setup DMA *physical* address */ regs->ACR = addr; if (dir_in) { /* invalidate any cache */ cache_clear(addr, cmd->SCp.this_residual); } else { /* push any dirty cache */ cache_push(addr, cmd->SCp.this_residual); } /* start DMA */ mb(); /* make sure setup is completed */ regs->ST_DMA = 1; mb(); /* make sure DMA has started before next IO */ /* return success */ return 0; }

Contributors

PersonTokensPropCommitsCommitProp
Linus Torvalds (pre-git)19075.70%327.27%
Geert Uytterhoeven5622.31%654.55%
Roman Zippel31.20%19.09%
Henrik Kretzschmar20.80%19.09%
Total251100.00%11100.00%


static void dma_stop(struct Scsi_Host *instance, struct scsi_cmnd *SCpnt, int status) { struct a3000_hostdata *hdata = shost_priv(instance); struct WD33C93_hostdata *wh = &hdata->wh; struct a3000_scsiregs *regs = hdata->regs; /* disable SCSI interrupts */ unsigned short cntr = CNTR_PDMD; if (!wh->dma_dir) cntr |= CNTR_DDIR; regs->CNTR = cntr; mb(); /* make sure CNTR is updated before next IO */ /* flush if we were reading */ if (wh->dma_dir) { regs->FLUSH = 1; mb(); /* don't allow prefetch */ while (!(regs->ISTR & ISTR_FE_FLG)) barrier(); mb(); /* no IO until FLUSH is done */ } /* clear a possible interrupt */ /* I think that this CINT is only necessary if you are * using the terminal count features. HM 7 Mar 1994 */ regs->CINT = 1; /* stop DMA */ regs->SP_DMA = 1; mb(); /* make sure DMA is stopped before next IO */ /* restore the CONTROL bits (minus the direction flag) */ regs->CNTR = CNTR_PDMD | CNTR_INTEN; mb(); /* make sure CNTR is updated before next IO */ /* copy from a bounce buffer, if necessary */ if (status && wh->dma_bounce_buffer) { if (SCpnt) { if (wh->dma_dir && SCpnt) memcpy(SCpnt->SCp.ptr, wh->dma_bounce_buffer, SCpnt->SCp.this_residual); kfree(wh->dma_bounce_buffer); wh->dma_bounce_buffer = NULL; wh->dma_bounce_len = 0; } else { kfree(wh->dma_bounce_buffer); wh->dma_bounce_buffer = NULL; wh->dma_bounce_len = 0; } } }

Contributors

PersonTokensPropCommitsCommitProp
Linus Torvalds (pre-git)17977.83%222.22%
Geert Uytterhoeven4720.43%555.56%
Roman Zippel20.87%111.11%
Henrik Kretzschmar20.87%111.11%
Total230100.00%9100.00%


static int a3000_bus_reset(struct scsi_cmnd *cmd) { struct Scsi_Host *instance = cmd->device->host; /* FIXME perform bus-specific reset */ /* FIXME 2: kill this entire function, which should cause mid-layer to call wd33c93_host_reset anyway? */ spin_lock_irq(instance->host_lock); wd33c93_host_reset(cmd); spin_unlock_irq(instance->host_lock); return SUCCESS; }

Contributors

PersonTokensPropCommitsCommitProp
Geert Uytterhoeven4291.30%125.00%
Linus Torvalds (pre-git)24.35%125.00%
Christoph Hellwig12.17%125.00%
Adrian Bunk12.17%125.00%
Total46100.00%4100.00%

static struct scsi_host_template amiga_a3000_scsi_template = { .module = THIS_MODULE, .name = "Amiga 3000 built-in SCSI", .show_info = wd33c93_show_info, .write_info = wd33c93_write_info, .proc_name = "A3000", .queuecommand = wd33c93_queuecommand, .eh_abort_handler = wd33c93_abort, .eh_bus_reset_handler = a3000_bus_reset, .eh_host_reset_handler = wd33c93_host_reset, .can_queue = CAN_QUEUE, .this_id = 7, .sg_tablesize = SG_ALL, .cmd_per_lun = CMD_PER_LUN, .use_clustering = ENABLE_CLUSTERING };
static int __init amiga_a3000_scsi_probe(struct platform_device *pdev) { struct resource *res; struct Scsi_Host *instance; int error; struct a3000_scsiregs *regs; wd33c93_regs wdregs; struct a3000_hostdata *hdata; res = platform_get_resource(pdev, IORESOURCE_MEM, 0); if (!res) return -ENODEV; if (!request_mem_region(res->start, resource_size(res), "wd33c93")) return -EBUSY; instance = scsi_host_alloc(&amiga_a3000_scsi_template, sizeof(struct a3000_hostdata)); if (!instance) { error = -ENOMEM; goto fail_alloc; } instance->irq = IRQ_AMIGA_PORTS; regs = ZTWO_VADDR(res->start); regs->DAWR = DAWR_A3000; wdregs.SASR = &regs->SASR; wdregs.SCMD = &regs->SCMD; hdata = shost_priv(instance); hdata->wh.no_sync = 0xff; hdata->wh.fast = 0; hdata->wh.dma_mode = CTRL_DMA; hdata->regs = regs; wd33c93_init(instance, wdregs, dma_setup, dma_stop, WD33C93_FS_12_15); error = request_irq(IRQ_AMIGA_PORTS, a3000_intr, IRQF_SHARED, "A3000 SCSI", instance); if (error) goto fail_irq; regs->CNTR = CNTR_PDMD | CNTR_INTEN; error = scsi_add_host(instance, NULL); if (error) goto fail_host; platform_set_drvdata(pdev, instance); scsi_scan_host(instance); return 0; fail_host: free_irq(IRQ_AMIGA_PORTS, instance); fail_irq: scsi_host_put(instance); fail_alloc: release_mem_region(res->start, resource_size(res)); return error; }

Contributors

PersonTokensPropCommitsCommitProp
Geert Uytterhoeven16456.36%642.86%
Linus Torvalds (pre-git)7525.77%535.71%
Linus Torvalds3411.68%17.14%
Thomas Bogendoerfer175.84%17.14%
Thomas Gleixner10.34%17.14%
Total291100.00%14100.00%


static int __exit amiga_a3000_scsi_remove(struct platform_device *pdev) { struct Scsi_Host *instance = platform_get_drvdata(pdev); struct a3000_hostdata *hdata = shost_priv(instance); struct resource *res = platform_get_resource(pdev, IORESOURCE_MEM, 0); hdata->regs->CNTR = 0; scsi_remove_host(instance); free_irq(IRQ_AMIGA_PORTS, instance); scsi_host_put(instance); release_mem_region(res->start, resource_size(res)); return 0; }

Contributors

PersonTokensPropCommitsCommitProp
Geert Uytterhoeven7789.53%360.00%
Jeff Garzik89.30%120.00%
Henrik Kretzschmar11.16%120.00%
Total86100.00%5100.00%

static struct platform_driver amiga_a3000_scsi_driver = { .remove = __exit_p(amiga_a3000_scsi_remove), .driver = { .name = "amiga-a3000-scsi", }, }; module_platform_driver_probe(amiga_a3000_scsi_driver, amiga_a3000_scsi_probe); MODULE_DESCRIPTION("Amiga 3000 built-in SCSI"); MODULE_LICENSE("GPL"); MODULE_ALIAS("platform:amiga-a3000-scsi");

Overall Contributors

PersonTokensPropCommitsCommitProp
Geert Uytterhoeven54946.13%1134.38%
Linus Torvalds (pre-git)54745.97%928.12%
Linus Torvalds383.19%26.25%
Thomas Bogendoerfer171.43%13.12%
Roman Zippel100.84%13.12%
Jeff Garzik80.67%13.12%
Al Viro70.59%13.12%
Henrik Kretzschmar50.42%13.12%
Christoph Hellwig30.25%13.12%
Paul Gortmaker30.25%13.12%
Thomas Gleixner10.08%13.12%
Adrian Bunk10.08%13.12%
Jingoo Han10.08%13.12%
Total1190100.00%32100.00%
Directory: drivers/scsi
Information contained on this website is for historical information purposes only and does not indicate or represent copyright ownership.
Created with cregit.