cregit-Linux how code gets into the kernel

Release 4.14 drivers/ata/pata_efar.c

Directory: drivers/ata
/*
 *    pata_efar.c - EFAR PIIX clone controller driver
 *
 *      (C) 2005 Red Hat
 *      (C) 2009-2010 Bartlomiej Zolnierkiewicz
 *
 *    Some parts based on ata_piix.c by Jeff Garzik and others.
 *
 *    The EFAR is a PIIX4 clone with UDMA66 support. Unlike the later
 *    Intel ICH controllers the EFAR widened the UDMA mode register bits
 *    and doesn't require the funky clock selection.
 */

#include <linux/kernel.h>
#include <linux/module.h>
#include <linux/pci.h>
#include <linux/blkdev.h>
#include <linux/delay.h>
#include <linux/device.h>
#include <scsi/scsi_host.h>
#include <linux/libata.h>
#include <linux/ata.h>


#define DRV_NAME	"pata_efar"

#define DRV_VERSION	"0.4.5"

/**
 *      efar_pre_reset  -       Enable bits
 *      @link: ATA link
 *      @deadline: deadline jiffies for the operation
 *
 *      Perform cable detection for the EFAR ATA interface. This is
 *      different to the PIIX arrangement
 */


static int efar_pre_reset(struct ata_link *link, unsigned long deadline) { static const struct pci_bits efar_enable_bits[] = { { 0x41U, 1U, 0x80UL, 0x80UL }, /* port 0 */ { 0x43U, 1U, 0x80UL, 0x80UL }, /* port 1 */ }; struct ata_port *ap = link->ap; struct pci_dev *pdev = to_pci_dev(ap->host->dev); if (!pci_test_config_bits(pdev, &efar_enable_bits[ap->port_no])) return -ENOENT; return ata_sff_prereset(link, deadline); }

Contributors

PersonTokensPropCommitsCommitProp
Jeff Garzik7778.57%120.00%
Tejun Heo1919.39%360.00%
Alan Cox22.04%120.00%
Total98100.00%5100.00%

/** * efar_cable_detect - check for 40/80 pin * @ap: Port * * Perform cable detection for the EFAR ATA interface. This is * different to the PIIX arrangement */
static int efar_cable_detect(struct ata_port *ap) { struct pci_dev *pdev = to_pci_dev(ap->host->dev); u8 tmp; pci_read_config_byte(pdev, 0x47, &tmp); if (tmp & (2 >> ap->port_no)) return ATA_CBL_PATA40; return ATA_CBL_PATA80; }

Contributors

PersonTokensPropCommitsCommitProp
Alan Cox56100.00%1100.00%
Total56100.00%1100.00%

static DEFINE_SPINLOCK(efar_lock); /** * efar_set_piomode - Initialize host controller PATA PIO timings * @ap: Port whose timings we are configuring * @adev: Device to program * * Set PIO mode for device, in host controller PCI config space. * * LOCKING: * None (inherited from caller). */
static void efar_set_piomode (struct ata_port *ap, struct ata_device *adev) { unsigned int pio = adev->pio_mode - XFER_PIO_0; struct pci_dev *dev = to_pci_dev(ap->host->dev); unsigned int master_port = ap->port_no ? 0x42 : 0x40; unsigned long flags; u16 master_data; u8 udma_enable; int control = 0; /* * See Intel Document 298600-004 for the timing programing rules * for PIIX/ICH. The EFAR is a clone so very similar */ static const /* ISP RTC */ u8 timings[][2] = { { 0, 0 }, { 0, 0 }, { 1, 0 }, { 2, 1 }, { 2, 3 }, }; if (pio > 1) control |= 1; /* TIME */ if (ata_pio_need_iordy(adev)) /* PIO 3/4 require IORDY */ control |= 2; /* IE */ /* Intel specifies that the prefetch/posting is for disk only */ if (adev->class == ATA_DEV_ATA) control |= 4; /* PPE */ spin_lock_irqsave(&efar_lock, flags); pci_read_config_word(dev, master_port, &master_data); /* Set PPE, IE, and TIME as appropriate */ if (adev->devno == 0) { master_data &= 0xCCF0; master_data |= control; master_data |= (timings[pio][0] << 12) | (timings[pio][1] << 8); } else { int shift = 4 * ap->port_no; u8 slave_data; master_data &= 0xFF0F; master_data |= (control << 4); /* Slave timing in separate register */ pci_read_config_byte(dev, 0x44, &slave_data); slave_data &= ap->port_no ? 0x0F : 0xF0; slave_data |= ((timings[pio][0] << 2) | timings[pio][1]) << shift; pci_write_config_byte(dev, 0x44, slave_data); } master_data |= 0x4000; /* Ensure SITRE is set */ pci_write_config_word(dev, master_port, master_data); pci_read_config_byte(dev, 0x48, &udma_enable); udma_enable &= ~(1 << (2 * ap->port_no + adev->devno)); pci_write_config_byte(dev, 0x48, udma_enable); spin_unlock_irqrestore(&efar_lock, flags); }

Contributors

PersonTokensPropCommitsCommitProp
Jeff Garzik26675.14%116.67%
Bartlomiej Zolnierkiewicz8022.60%350.00%
Sergei Shtylyov71.98%116.67%
Joe Perches10.28%116.67%
Total354100.00%6100.00%

/** * efar_set_dmamode - Initialize host controller PATA DMA timings * @ap: Port whose timings we are configuring * @adev: Device to program * * Set UDMA/MWDMA mode for device, in host controller PCI config space. * * LOCKING: * None (inherited from caller). */
static void efar_set_dmamode (struct ata_port *ap, struct ata_device *adev) { struct pci_dev *dev = to_pci_dev(ap->host->dev); u8 master_port = ap->port_no ? 0x42 : 0x40; u16 master_data; u8 speed = adev->dma_mode; int devid = adev->devno + 2 * ap->port_no; unsigned long flags; u8 udma_enable; static const /* ISP RTC */ u8 timings[][2] = { { 0, 0 }, { 0, 0 }, { 1, 0 }, { 2, 1 }, { 2, 3 }, }; spin_lock_irqsave(&efar_lock, flags); pci_read_config_word(dev, master_port, &master_data); pci_read_config_byte(dev, 0x48, &udma_enable); if (speed >= XFER_UDMA_0) { unsigned int udma = adev->dma_mode - XFER_UDMA_0; u16 udma_timing; udma_enable |= (1 << devid); /* Load the UDMA mode number */ pci_read_config_word(dev, 0x4A, &udma_timing); udma_timing &= ~(7 << (4 * devid)); udma_timing |= udma << (4 * devid); pci_write_config_word(dev, 0x4A, udma_timing); } else { /* * MWDMA is driven by the PIO timings. We must also enable * IORDY unconditionally along with TIME1. PPE has already * been set when the PIO timing was set. */ unsigned int mwdma = adev->dma_mode - XFER_MW_DMA_0; unsigned int control; u8 slave_data; const unsigned int needed_pio[3] = { XFER_PIO_0, XFER_PIO_3, XFER_PIO_4 }; int pio = needed_pio[mwdma] - XFER_PIO_0; control = 3; /* IORDY|TIME1 */ /* If the drive MWDMA is faster than it can do PIO then we must force PIO into PIO0 */ if (adev->pio_mode < needed_pio[mwdma]) /* Enable DMA timing only */ control |= 8; /* PIO cycles in PIO0 */ if (adev->devno) { /* Slave */ master_data &= 0xFF4F; /* Mask out IORDY|TIME1|DMAONLY */ master_data |= control << 4; pci_read_config_byte(dev, 0x44, &slave_data); slave_data &= ap->port_no ? 0x0F : 0xF0; /* Load the matching timing */ slave_data |= ((timings[pio][0] << 2) | timings[pio][1]) << (ap->port_no ? 4 : 0); pci_write_config_byte(dev, 0x44, slave_data); } else { /* Master */ master_data &= 0xCCF4; /* Mask out IORDY|TIME1|DMAONLY and master timing bits */ master_data |= control; master_data |= (timings[pio][0] << 12) | (timings[pio][1] << 8); } udma_enable &= ~(1 << devid); pci_write_config_word(dev, master_port, master_data); } pci_write_config_byte(dev, 0x48, udma_enable); spin_unlock_irqrestore(&efar_lock, flags); }

Contributors

PersonTokensPropCommitsCommitProp
Jeff Garzik41794.56%133.33%
Bartlomiej Zolnierkiewicz245.44%266.67%
Total441100.00%3100.00%

static struct scsi_host_template efar_sht = { ATA_BMDMA_SHT(DRV_NAME), }; static struct ata_port_operations efar_ops = { .inherits = &ata_bmdma_port_ops, .cable_detect = efar_cable_detect, .set_piomode = efar_set_piomode, .set_dmamode = efar_set_dmamode, .prereset = efar_pre_reset, }; /** * efar_init_one - Register EFAR ATA PCI device with kernel services * @pdev: PCI device to register * @ent: Entry in efar_pci_tbl matching with @pdev * * Called from kernel PCI layer. * * LOCKING: * Inherited from PCI layer (may sleep). * * RETURNS: * Zero on success, or -ERRNO value. */
static int efar_init_one (struct pci_dev *pdev, const struct pci_device_id *ent) { static const struct ata_port_info info = { .flags = ATA_FLAG_SLAVE_POSS, .pio_mask = ATA_PIO4, .mwdma_mask = ATA_MWDMA12_ONLY, .udma_mask = ATA_UDMA4, .port_ops = &efar_ops, }; const struct ata_port_info *ppi[] = { &info, &info }; ata_print_version_once(&pdev->dev, DRV_VERSION); return ata_pci_bmdma_init_one(pdev, ppi, &efar_sht, NULL, ATA_HOST_PARALLEL_SCAN); }

Contributors

PersonTokensPropCommitsCommitProp
Jeff Garzik7279.12%18.33%
Tejun Heo1112.09%433.33%
Bartlomiej Zolnierkiewicz33.30%216.67%
Alan Cox22.20%216.67%
Erik Inge Bolsö22.20%216.67%
Joe Perches11.10%18.33%
Total91100.00%12100.00%

static const struct pci_device_id efar_pci_tbl[] = { { PCI_VDEVICE(EFAR, 0x9130), }, { } /* terminate list */ }; static struct pci_driver efar_pci_driver = { .name = DRV_NAME, .id_table = efar_pci_tbl, .probe = efar_init_one, .remove = ata_pci_remove_one, #ifdef CONFIG_PM_SLEEP .suspend = ata_pci_device_suspend, .resume = ata_pci_device_resume, #endif }; module_pci_driver(efar_pci_driver); MODULE_AUTHOR("Alan Cox"); MODULE_DESCRIPTION("SCSI low-level driver for EFAR PIIX clones"); MODULE_LICENSE("GPL"); MODULE_DEVICE_TABLE(pci, efar_pci_tbl); MODULE_VERSION(DRV_VERSION);

Overall Contributors

PersonTokensPropCommitsCommitProp
Jeff Garzik96978.91%26.06%
Bartlomiej Zolnierkiewicz1169.45%721.21%
Alan Cox766.19%515.15%
Tejun Heo504.07%1236.36%
Sergei Shtylyov80.65%13.03%
Akira Iguchi30.24%13.03%
Joe Perches20.16%26.06%
Axel Lin20.16%13.03%
Erik Inge Bolsö20.16%26.06%
Total1228100.00%33100.00%
Directory: drivers/ata
Information contained on this website is for historical information purposes only and does not indicate or represent copyright ownership.
Created with cregit.