Release 4.14 drivers/iio/adc/ep93xx_adc.c
/*
* Driver for ADC module on the Cirrus Logic EP93xx series of SoCs
*
* Copyright (C) 2015 Alexander Sverdlin
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*
* The driver uses polling to get the conversion status. According to EP93xx
* datasheets, reading ADCResult register starts the conversion, but user is also
* responsible for ensuring that delay between adjacent conversion triggers is
* long enough so that maximum allowed conversion rate is not exceeded. This
* basically renders IRQ mode unusable.
*/
#include <linux/clk.h>
#include <linux/delay.h>
#include <linux/device.h>
#include <linux/err.h>
#include <linux/iio/iio.h>
#include <linux/io.h>
#include <linux/irqflags.h>
#include <linux/module.h>
#include <linux/mutex.h>
#include <linux/platform_device.h>
/*
* This code could benefit from real HR Timers, but jiffy granularity would
* lower ADC conversion rate down to CONFIG_HZ, so we fallback to busy wait
* in such case.
*
* HR Timers-based version loads CPU only up to 10% during back to back ADC
* conversion, while busy wait-based version consumes whole CPU power.
*/
#ifdef CONFIG_HIGH_RES_TIMERS
#define ep93xx_adc_delay(usmin, usmax) usleep_range(usmin, usmax)
#else
#define ep93xx_adc_delay(usmin, usmax) udelay(usmin)
#endif
#define EP93XX_ADC_RESULT 0x08
#define EP93XX_ADC_SDR BIT(31)
#define EP93XX_ADC_SWITCH 0x18
#define EP93XX_ADC_SW_LOCK 0x20
struct ep93xx_adc_priv {
struct clk *clk;
void __iomem *base;
int lastch;
struct mutex lock;
};
#define EP93XX_ADC_CH(index, dname, swcfg) { \
.type = IIO_VOLTAGE, \
.indexed = 1, \
.channel = index, \
.address = swcfg, \
.datasheet_name = dname, \
.info_mask_separate = BIT(IIO_CHAN_INFO_RAW), \
.info_mask_shared_by_all = BIT(IIO_CHAN_INFO_SCALE) | \
BIT(IIO_CHAN_INFO_OFFSET), \
}
/*
* Numbering scheme for channels 0..4 is defined in EP9301 and EP9302 datasheets.
* EP9307, EP9312 and EP9312 have 3 channels more (total 8), but the numbering is
* not defined. So the last three are numbered randomly, let's say.
*/
static const struct iio_chan_spec ep93xx_adc_channels[8] = {
EP93XX_ADC_CH(0, "YM", 0x608),
EP93XX_ADC_CH(1, "SXP", 0x680),
EP93XX_ADC_CH(2, "SXM", 0x640),
EP93XX_ADC_CH(3, "SYP", 0x620),
EP93XX_ADC_CH(4, "SYM", 0x610),
EP93XX_ADC_CH(5, "XP", 0x601),
EP93XX_ADC_CH(6, "XM", 0x602),
EP93XX_ADC_CH(7, "YP", 0x604),
};
static int ep93xx_read_raw(struct iio_dev *iiodev,
struct iio_chan_spec const *channel, int *value,
int *shift, long mask)
{
struct ep93xx_adc_priv *priv = iio_priv(iiodev);
unsigned long timeout;
int ret;
switch (mask) {
case IIO_CHAN_INFO_RAW:
mutex_lock(&priv->lock);
if (priv->lastch != channel->channel) {
priv->lastch = channel->channel;
/*
* Switch register is software-locked, unlocking must be
* immediately followed by write
*/
local_irq_disable();
writel_relaxed(0xAA, priv->base + EP93XX_ADC_SW_LOCK);
writel_relaxed(channel->address,
priv->base + EP93XX_ADC_SWITCH);
local_irq_enable();
/*
* Settling delay depends on module clock and could be
* 2ms or 500us
*/
ep93xx_adc_delay(2000, 2000);
}
/* Start the conversion, eventually discarding old result */
readl_relaxed(priv->base + EP93XX_ADC_RESULT);
/* Ensure maximum conversion rate is not exceeded */
ep93xx_adc_delay(DIV_ROUND_UP(1000000, 925),
DIV_ROUND_UP(1000000, 925));
/* At this point conversion must be completed, but anyway... */
ret = IIO_VAL_INT;
timeout = jiffies + msecs_to_jiffies(1) + 1;
while (1) {
u32 t;
t = readl_relaxed(priv->base + EP93XX_ADC_RESULT);
if (t & EP93XX_ADC_SDR) {
*value = sign_extend32(t, 15);
break;
}
if (time_after(jiffies, timeout)) {
dev_err(&iiodev->dev, "Conversion timeout\n");
ret = -ETIMEDOUT;
break;
}
cpu_relax();
}
mutex_unlock(&priv->lock);
return ret;
case IIO_CHAN_INFO_OFFSET:
/* According to datasheet, range is -25000..25000 */
*value = 25000;
return IIO_VAL_INT;
case IIO_CHAN_INFO_SCALE:
/* Typical supply voltage is 3.3v */
*value = (1ULL << 32) * 3300 / 50000;
*shift = 32;
return IIO_VAL_FRACTIONAL_LOG2;
}
return -EINVAL;
}
Contributors
| Person | Tokens | Prop | Commits | CommitProp |
| Alexander Sverdlin | 286 | 100.00% | 1 | 100.00% |
| Total | 286 | 100.00% | 1 | 100.00% |
static const struct iio_info ep93xx_adc_info = {
.driver_module = THIS_MODULE,
.read_raw = ep93xx_read_raw,
};
static int ep93xx_adc_probe(struct platform_device *pdev)
{
int ret;
struct iio_dev *iiodev;
struct ep93xx_adc_priv *priv;
struct clk *pclk;
struct resource *res;
iiodev = devm_iio_device_alloc(&pdev->dev, sizeof(*priv));
if (!iiodev)
return -ENOMEM;
priv = iio_priv(iiodev);
res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
if (!res) {
dev_err(&pdev->dev, "Cannot obtain memory resource\n");
return -ENXIO;
}
priv->base = devm_ioremap_resource(&pdev->dev, res);
if (IS_ERR(priv->base)) {
dev_err(&pdev->dev, "Cannot map memory resource\n");
return PTR_ERR(priv->base);
}
iiodev->dev.parent = &pdev->dev;
iiodev->name = dev_name(&pdev->dev);
iiodev->modes = INDIO_DIRECT_MODE;
iiodev->info = &ep93xx_adc_info;
iiodev->num_channels = ARRAY_SIZE(ep93xx_adc_channels);
iiodev->channels = ep93xx_adc_channels;
priv->lastch = -1;
mutex_init(&priv->lock);
platform_set_drvdata(pdev, iiodev);
priv->clk = devm_clk_get(&pdev->dev, NULL);
if (IS_ERR(priv->clk)) {
dev_err(&pdev->dev, "Cannot obtain clock\n");
return PTR_ERR(priv->clk);
}
pclk = clk_get_parent(priv->clk);
if (!pclk) {
dev_warn(&pdev->dev, "Cannot obtain parent clock\n");
} else {
/*
* This is actually a place for improvement:
* EP93xx ADC supports two clock divisors -- 4 and 16,
* resulting in conversion rates 3750 and 925 samples per second
* with 500us or 2ms settling time respectively.
* One might find this interesting enough to be configurable.
*/
ret = clk_set_rate(priv->clk, clk_get_rate(pclk) / 16);
if (ret)
dev_warn(&pdev->dev, "Cannot set clock rate\n");
/*
* We can tolerate rate setting failure because the module should
* work in any case.
*/
}
ret = clk_enable(priv->clk);
if (ret) {
dev_err(&pdev->dev, "Cannot enable clock\n");
return ret;
}
ret = iio_device_register(iiodev);
if (ret)
clk_disable(priv->clk);
return ret;
}
Contributors
| Person | Tokens | Prop | Commits | CommitProp |
| Alexander Sverdlin | 367 | 100.00% | 1 | 100.00% |
| Total | 367 | 100.00% | 1 | 100.00% |
static int ep93xx_adc_remove(struct platform_device *pdev)
{
struct iio_dev *iiodev = platform_get_drvdata(pdev);
struct ep93xx_adc_priv *priv = iio_priv(iiodev);
iio_device_unregister(iiodev);
clk_disable(priv->clk);
return 0;
}
Contributors
| Person | Tokens | Prop | Commits | CommitProp |
| Alexander Sverdlin | 46 | 100.00% | 1 | 100.00% |
| Total | 46 | 100.00% | 1 | 100.00% |
static struct platform_driver ep93xx_adc_driver = {
.driver = {
.name = "ep93xx-adc",
},
.probe = ep93xx_adc_probe,
.remove = ep93xx_adc_remove,
};
module_platform_driver(ep93xx_adc_driver);
MODULE_AUTHOR("Alexander Sverdlin <alexander.sverdlin@gmail.com>");
MODULE_DESCRIPTION("Cirrus Logic EP93XX ADC driver");
MODULE_LICENSE("GPL");
MODULE_ALIAS("platform:ep93xx-adc");
Overall Contributors
| Person | Tokens | Prop | Commits | CommitProp |
| Alexander Sverdlin | 959 | 100.00% | 1 | 100.00% |
| Total | 959 | 100.00% | 1 | 100.00% |
Information contained on this website is for historical information purposes only and does not indicate or represent copyright ownership.