cregit-Linux how code gets into the kernel

Release 4.16 include/linux/smsc911x.h

Directory: include/linux
/***************************************************************************
 *
 * Copyright (C) 2004-2008 SMSC
 * Copyright (C) 2005-2008 ARM
 *
 * This program is free software; you can redistribute it and/or
 * modify it under the terms of the GNU General Public License
 * as published by the Free Software Foundation; either version 2
 * of the License, or (at your option) any later version.
 *
 * This program is distributed in the hope that it will be useful,
 * but WITHOUT ANY WARRANTY; without even the implied warranty of
 * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
 * GNU General Public License for more details.
 *
 * You should have received a copy of the GNU General Public License
 * along with this program; if not, write to the Free Software
 * Foundation, Inc., 59 Temple Place - Suite 330, Boston, MA  02111-1307, USA.
 *
 ***************************************************************************/
#ifndef __LINUX_SMSC911X_H__

#define __LINUX_SMSC911X_H__

#include <linux/phy.h>
#include <linux/if_ether.h>

/* platform_device configuration data, should be assigned to
 * the platform_device's dev.platform_data */

struct smsc911x_platform_config {
	
unsigned int irq_polarity;
	
unsigned int irq_type;
	
unsigned int flags;
	
unsigned int shift;
	
phy_interface_t phy_interface;
	
unsigned char mac[ETH_ALEN];
};

/* Constants for platform_device irq polarity configuration */

#define SMSC911X_IRQ_POLARITY_ACTIVE_LOW	0

#define SMSC911X_IRQ_POLARITY_ACTIVE_HIGH	1

/* Constants for platform_device irq type configuration */

#define SMSC911X_IRQ_TYPE_OPEN_DRAIN		0

#define SMSC911X_IRQ_TYPE_PUSH_PULL		1

/* Constants for flags */

#define SMSC911X_USE_16BIT 			(BIT(0))

#define SMSC911X_USE_32BIT 			(BIT(1))

#define SMSC911X_FORCE_INTERNAL_PHY		(BIT(2))

#define SMSC911X_FORCE_EXTERNAL_PHY 		(BIT(3))

#define SMSC911X_SAVE_MAC_ADDRESS		(BIT(4))

/*
 * SMSC911X_SWAP_FIFO:
 * Enables software byte swap for fifo data. Should only be used as a
 * "last resort" in the case of big endian mode on boards with incorrectly
 * routed data bus to older devices such as LAN9118. Newer devices such as
 * LAN9221 can handle this in hardware, there are registers to control
 * this swapping but the driver doesn't currently use them.
 */

#define SMSC911X_SWAP_FIFO			(BIT(5))

#endif /* __LINUX_SMSC911X_H__ */

Overall Contributors

PersonTokensPropCommitsCommitProp
Steve Glendinning7379.35%450.00%
Manuel Lauss66.52%112.50%
Magnus Damm55.43%112.50%
Mathieu J. Poirier44.35%112.50%
Joe Perches44.35%112.50%
Total92100.00%8100.00%
Directory: include/linux
Information contained on this website is for historical information purposes only and does not indicate or represent copyright ownership.
Created with cregit.