cregit-Linux how code gets into the kernel

Release 4.7 drivers/atm/midway.h

Directory: drivers/atm
/* drivers/atm/midway.h - Efficient Networks Midway (SAR) description */
 
/* Written 1995-1999 by Werner Almesberger, EPFL LRC/ICA */
 

#ifndef DRIVERS_ATM_MIDWAY_H

#define DRIVERS_ATM_MIDWAY_H



#define NR_VCI		1024		
/* number of VCIs */

#define NR_VCI_LD	10		
/* log2(NR_VCI) */

#define NR_DMA_RX	512		
/* RX DMA queue entries */

#define NR_DMA_TX	512		
/* TX DMA queue entries */

#define NR_SERVICE	NR_VCI		
/* service list size */

#define NR_CHAN		8		
/* number of TX channels */

#define TS_CLOCK	25000000	
/* traffic shaper clock (cell/sec) */


#define MAP_MAX_SIZE	0x00400000	
/* memory window for max config */

#define EPROM_SIZE	0x00010000

#define	MEM_VALID	0xffc00000	
/* mask base address with this */

#define PHY_BASE	0x00020000	
/* offset of PHY register are */

#define REG_BASE	0x00040000	
/* offset of Midway register area */

#define RAM_BASE	0x00200000	
/* offset of RAM area */

#define RAM_INCREMENT	0x00020000	
/* probe for RAM every 128kB */


#define MID_VCI_BASE	RAM_BASE

#define MID_DMA_RX_BASE	(MID_VCI_BASE+NR_VCI*16)

#define MID_DMA_TX_BASE	(MID_DMA_RX_BASE+NR_DMA_RX*8)

#define MID_SERVICE_BASE (MID_DMA_TX_BASE+NR_DMA_TX*8)

#define MID_FREE_BASE	(MID_SERVICE_BASE+NR_SERVICE*4)


#define MAC_LEN 6 
/* atm.h */


#define MID_MIN_BUF_SIZE (1024)		
/*   1 kB is minimum */

#define MID_MAX_BUF_SIZE (128*1024)	
/* 128 kB is maximum */


#define RX_DESCR_SIZE	1		
/* RX PDU descr is 1 longword */

#define TX_DESCR_SIZE	2		
/* TX PDU descr is 2 longwords */

#define AAL5_TRAILER	(ATM_AAL5_TRAILER/4) 
/* AAL5 trailer is 2 longwords */


#define TX_GAP		8		
/* TX buffer gap (words) */

/*
 * Midway Reset/ID
 *
 * All values read-only. Writing to this register resets Midway chip.
 */


#define MID_RES_ID_MCON	0x00		
/* Midway Reset/ID */


#define MID_ID		0xf0000000	
/* Midway version */

#define MID_SHIFT	24

#define MID_MOTHER_ID	0x00000700	
/* mother board id */

#define MID_MOTHER_SHIFT 8

#define MID_CON_TI	0x00000080	
/* 0: normal ctrl; 1: SABRE */

#define MID_CON_SUNI	0x00000040	
/* 0: UTOPIA; 1: SUNI */

#define MID_CON_V6	0x00000020	
/* 0: non-pipel UTOPIA (required iff
                                           !CON_SUNI; 1: UTOPIA */

#define DAUGTHER_ID	0x0000001f	
/* daugther board id */

/*
 * Interrupt Status Acknowledge, Interrupt Status & Interrupt Enable
 */


#define MID_ISA		0x01		
/* Interrupt Status Acknowledge */

#define MID_IS		0x02		
/* Interrupt Status */

#define MID_IE		0x03		
/* Interrupt Enable */


#define MID_TX_COMPLETE_7 0x00010000	
/* channel N completed a PDU */

#define MID_TX_COMPLETE_6 0x00008000	
/* transmission */

#define MID_TX_COMPLETE_5 0x00004000

#define MID_TX_COMPLETE_4 0x00002000

#define MID_TX_COMPLETE_3 0x00001000

#define MID_TX_COMPLETE_2 0x00000800

#define MID_TX_COMPLETE_1 0x00000400

#define MID_TX_COMPLETE_0 0x00000200

#define MID_TX_COMPLETE	0x0001fe00	
/* any TX */

#define MID_TX_DMA_OVFL	0x00000100	
/* DMA to adapter overflow */

#define MID_TX_IDENT_MISM 0x00000080	
/* TX: ident mismatch => halted */

#define MID_DMA_LERR_ACK 0x00000040	
/* LERR - SBus ? */

#define MID_DMA_ERR_ACK	0x00000020	
/* DMA error */

#define	MID_RX_DMA_COMPLETE 0x00000010	
/* DMA to host done */

#define MID_TX_DMA_COMPLETE 0x00000008	
/* DMA from host done */

#define MID_SERVICE	0x00000004	
/* something in service list */

#define MID_SUNI_INT	0x00000002	
/* interrupt from SUNI */

#define MID_STAT_OVFL	0x00000001	
/* statistics overflow */

/*
 * Master Control/Status
 */


#define MID_MC_S	0x04


#define MID_INT_SELECT	0x000001C0	
/* Interrupt level (000: off) */

#define MID_INT_SEL_SHIFT 6

#define	MID_TX_LOCK_MODE 0x00000020	
/* 0: streaming; 1: TX ovfl->lock */

#define MID_DMA_ENABLE	0x00000010	
/* R: 0: disable; 1: enable
                                           W: 0: no change; 1: enable */

#define MID_TX_ENABLE	0x00000008	
/* R: 0: TX disabled; 1: enabled
                                           W: 0: no change; 1: enable */

#define MID_RX_ENABLE	0x00000004	
/* like TX */

#define MID_WAIT_1MS	0x00000002	
/* R: 0: timer not running; 1: running
                                           W: 0: no change; 1: no interrupts
                                                               for 1 ms */

#define MID_WAIT_500US	0x00000001	
/* like WAIT_1MS, but 0.5 ms */

/*
 * Statistics
 *
 * Cleared when reading.
 */


#define MID_STAT		0x05


#define MID_VCI_TRASH	0xFFFF0000	
/* trashed cells because of VCI mode */

#define MID_VCI_TRASH_SHIFT 16

#define MID_OVFL_TRASH	0x0000FFFF	
/* trashed cells because of overflow */

/*
 * Address registers
 */


#define MID_SERV_WRITE	0x06	
/* free pos in service area (R, 10 bits) */

#define MID_DMA_ADDR	0x07	
/* virtual DMA address (R, 32 bits) */

#define MID_DMA_WR_RX	0x08	
/* (RW, 9 bits) */

#define MID_DMA_RD_RX	0x09

#define MID_DMA_WR_TX	0x0A

#define MID_DMA_RD_TX	0x0B

/*
 * Transmit Place Registers (0x10+4*channel)
 */


#define MID_TX_PLACE(c)	(0x10+4*(c))


#define MID_SIZE	0x00003800	
/* size, N*256 x 32 bit */

#define MID_SIZE_SHIFT	11

#define MID_LOCATION	0x000007FF	
/* location in adapter memory (word) */


#define MID_LOC_SKIP	8		
/* 8 bits of location are always zero
                                           (applies to all uses of location) */

/*
 * Transmit ReadPtr Registers (0x11+4*channel)
 */


#define MID_TX_RDPTR(c)	(0x11+4*(c))


#define MID_READ_PTR	0x00007FFF	
/* next word for PHY */

/*
 * Transmit DescrStart Registers (0x12+4*channel)
 */


#define MID_TX_DESCRSTART(c) (0x12+4*(c))


#define MID_DESCR_START	0x00007FFF	
/* seg buffer being DMAed */


#define ENI155_MAGIC	0xa54b872d


struct midway_eprom {
	

unsigned char mac[MAC_LEN],inv_mac[MAC_LEN];
	
unsigned char pad[36];
	

u32 serial,inv_serial;
	

u32 magic,inv_magic;
};


/*
 * VCI table entry
 */


#define MID_VCI_IN_SERVICE	0x00000001	
/* set if VCI is currently in
                                                   service list */

#define MID_VCI_SIZE		0x00038000	
/* reassembly buffer size,
                                                   2*<size> kB */

#define MID_VCI_SIZE_SHIFT	15

#define MID_VCI_LOCATION	0x1ffc0000	
/* buffer location */

#define MID_VCI_LOCATION_SHIFT	18

#define MID_VCI_PTI_MODE	0x20000000	
/* 0: trash, 1: preserve */

#define MID_VCI_MODE		0xc0000000

#define MID_VCI_MODE_SHIFT	30

#define MID_VCI_READ		0x00007fff

#define MID_VCI_READ_SHIFT	0

#define MID_VCI_DESCR		0x7fff0000

#define MID_VCI_DESCR_SHIFT	16

#define MID_VCI_COUNT		0x000007ff

#define MID_VCI_COUNT_SHIFT	0

#define MID_VCI_STATE		0x0000c000

#define MID_VCI_STATE_SHIFT	14

#define MID_VCI_WRITE		0x7fff0000

#define MID_VCI_WRITE_SHIFT	16


#define MID_MODE_TRASH	0

#define MID_MODE_RAW	1

#define MID_MODE_AAL5	2

/*
 * Reassembly buffer descriptor
 */


#define MID_RED_COUNT		0x000007ff

#define MID_RED_CRC_ERR		0x00000800

#define MID_RED_T		0x00001000

#define MID_RED_CE		0x00010000

#define MID_RED_CLP		0x01000000

#define MID_RED_IDEN		0xfe000000

#define MID_RED_SHIFT		25


#define MID_RED_RX_ID		0x1b		
/* constant identifier */

/*
 * Segmentation buffer descriptor
 */


#define MID_SEG_COUNT		MID_RED_COUNT

#define MID_SEG_RATE		0x01f80000

#define MID_SEG_RATE_SHIFT	19

#define MID_SEG_PR		0x06000000

#define MID_SEG_PR_SHIFT	25

#define MID_SEG_AAL5		0x08000000

#define MID_SEG_ID		0xf0000000

#define MID_SEG_ID_SHIFT	28

#define MID_SEG_MAX_RATE	63


#define MID_SEG_CLP		0x00000001

#define MID_SEG_PTI		0x0000000e

#define MID_SEG_PTI_SHIFT	1

#define MID_SEG_VCI		0x00003ff0

#define MID_SEG_VCI_SHIFT	4


#define MID_SEG_TX_ID		0xb		
/* constant identifier */

/*
 * DMA entry
 */


#define MID_DMA_COUNT		0xffff0000

#define MID_DMA_COUNT_SHIFT	16

#define MID_DMA_END		0x00000020

#define MID_DMA_TYPE		0x0000000f


#define MID_DT_JK	0x3

#define MID_DT_WORD	0x0

#define MID_DT_2W	0x7

#define MID_DT_4W	0x4

#define MID_DT_8W	0x5

#define MID_DT_16W	0x6

#define MID_DT_2WM	0xf

#define MID_DT_4WM	0xc

#define MID_DT_8WM	0xd

#define MID_DT_16WM	0xe

/* only for RX*/

#define MID_DMA_VCI		0x0000ffc0

#define	MID_DMA_VCI_SHIFT	6

/* only for TX */

#define MID_DMA_CHAN		0x000001c0

#define MID_DMA_CHAN_SHIFT	6


#define MID_DT_BYTE	0x1

#define MID_DT_HWORD	0x2

#endif

Overall Contributors

PersonTokensPropCommitsCommitProp
pre-gitpre-git728100.00%1100.00%
Total728100.00%1100.00%
Directory: drivers/atm
Information contained on this website is for historical information purposes only and does not indicate or represent copyright ownership.
{% endraw %}