cregit-Linux how code gets into the kernel

Release 4.7 drivers/tty/mxser.h

Directory: drivers/tty
#ifndef _MXSER_H

#define _MXSER_H

/*
 *      Semi-public control interfaces
 */

/*
 *      MOXA ioctls
 */


#define MOXA			0x400

#define MOXA_GETDATACOUNT	(MOXA + 23)

#define MOXA_DIAGNOSE		(MOXA + 50)

#define MOXA_CHKPORTENABLE	(MOXA + 60)

#define MOXA_HighSpeedOn	(MOXA + 61)

#define MOXA_GET_MAJOR		(MOXA + 63)

#define MOXA_GETMSTATUS		(MOXA + 65)

#define MOXA_SET_OP_MODE	(MOXA + 66)

#define MOXA_GET_OP_MODE	(MOXA + 67)


#define RS232_MODE		0

#define RS485_2WIRE_MODE	1

#define RS422_MODE		2

#define RS485_4WIRE_MODE	3

#define OP_MODE_MASK		3


#define MOXA_SDS_RSTICOUNTER	(MOXA + 69)

#define MOXA_ASPP_OQUEUE  	(MOXA + 70)

#define MOXA_ASPP_MON     	(MOXA + 73)

#define MOXA_ASPP_LSTATUS 	(MOXA + 74)

#define MOXA_ASPP_MON_EXT 	(MOXA + 75)

#define MOXA_SET_BAUD_METHOD	(MOXA + 76)

/* --------------------------------------------------- */


#define NPPI_NOTIFY_PARITY	0x01

#define NPPI_NOTIFY_FRAMING	0x02

#define NPPI_NOTIFY_HW_OVERRUN	0x04

#define NPPI_NOTIFY_SW_OVERRUN	0x08

#define NPPI_NOTIFY_BREAK	0x10


#define NPPI_NOTIFY_CTSHOLD         0x01	
/* Tx hold by CTS low */

#define NPPI_NOTIFY_DSRHOLD         0x02	
/* Tx hold by DSR low */

#define NPPI_NOTIFY_XOFFHOLD        0x08	
/* Tx hold by Xoff received */

#define NPPI_NOTIFY_XOFFXENT        0x10	
/* Xoff Sent */

/* follow just for Moxa Must chip define. */
/* */
/* when LCR register (offset 0x03) write following value, */
/* the Must chip will enter enchance mode. And write value */
/* on EFR (offset 0x02) bit 6,7 to change bank. */

#define MOXA_MUST_ENTER_ENCHANCE	0xBF

/* when enhance mode enable, access on general bank register */

#define MOXA_MUST_GDL_REGISTER		0x07

#define MOXA_MUST_GDL_MASK		0x7F

#define MOXA_MUST_GDL_HAS_BAD_DATA	0x80


#define MOXA_MUST_LSR_RERR		0x80	
/* error in receive FIFO */
/* enchance register bank select and enchance mode setting register */
/* when LCR register equal to 0xBF */

#define MOXA_MUST_EFR_REGISTER		0x02
/* enchance mode enable */

#define MOXA_MUST_EFR_EFRB_ENABLE	0x10
/* enchance reister bank set 0, 1, 2 */

#define MOXA_MUST_EFR_BANK0		0x00

#define MOXA_MUST_EFR_BANK1		0x40

#define MOXA_MUST_EFR_BANK2		0x80

#define MOXA_MUST_EFR_BANK3		0xC0

#define MOXA_MUST_EFR_BANK_MASK		0xC0

/* set XON1 value register, when LCR=0xBF and change to bank0 */

#define MOXA_MUST_XON1_REGISTER		0x04

/* set XON2 value register, when LCR=0xBF and change to bank0 */

#define MOXA_MUST_XON2_REGISTER		0x05

/* set XOFF1 value register, when LCR=0xBF and change to bank0 */

#define MOXA_MUST_XOFF1_REGISTER	0x06

/* set XOFF2 value register, when LCR=0xBF and change to bank0 */

#define MOXA_MUST_XOFF2_REGISTER	0x07


#define MOXA_MUST_RBRTL_REGISTER	0x04

#define MOXA_MUST_RBRTH_REGISTER	0x05

#define MOXA_MUST_RBRTI_REGISTER	0x06

#define MOXA_MUST_THRTL_REGISTER	0x07

#define MOXA_MUST_ENUM_REGISTER		0x04

#define MOXA_MUST_HWID_REGISTER		0x05

#define MOXA_MUST_ECR_REGISTER		0x06

#define MOXA_MUST_CSR_REGISTER		0x07

/* good data mode enable */

#define MOXA_MUST_FCR_GDA_MODE_ENABLE	0x20
/* only good data put into RxFIFO */

#define MOXA_MUST_FCR_GDA_ONLY_ENABLE	0x10

/* enable CTS interrupt */

#define MOXA_MUST_IER_ECTSI		0x80
/* enable RTS interrupt */

#define MOXA_MUST_IER_ERTSI		0x40
/* enable Xon/Xoff interrupt */

#define MOXA_MUST_IER_XINT		0x20
/* enable GDA interrupt */

#define MOXA_MUST_IER_EGDAI		0x10


#define MOXA_MUST_RECV_ISR		(UART_IER_RDI | MOXA_MUST_IER_EGDAI)

/* GDA interrupt pending */

#define MOXA_MUST_IIR_GDA		0x1C

#define MOXA_MUST_IIR_RDA		0x04

#define MOXA_MUST_IIR_RTO		0x0C

#define MOXA_MUST_IIR_LSR		0x06

/* received Xon/Xoff or specical interrupt pending */

#define MOXA_MUST_IIR_XSC		0x10

/* RTS/CTS change state interrupt pending */

#define MOXA_MUST_IIR_RTSCTS		0x20

#define MOXA_MUST_IIR_MASK		0x3E


#define MOXA_MUST_MCR_XON_FLAG		0x40

#define MOXA_MUST_MCR_XON_ANY		0x80

#define MOXA_MUST_MCR_TX_XON		0x08

/* software flow control on chip mask value */

#define MOXA_MUST_EFR_SF_MASK		0x0F
/* send Xon1/Xoff1 */

#define MOXA_MUST_EFR_SF_TX1		0x08
/* send Xon2/Xoff2 */

#define MOXA_MUST_EFR_SF_TX2		0x04
/* send Xon1,Xon2/Xoff1,Xoff2 */

#define MOXA_MUST_EFR_SF_TX12		0x0C
/* don't send Xon/Xoff */

#define MOXA_MUST_EFR_SF_TX_NO		0x00
/* Tx software flow control mask */

#define MOXA_MUST_EFR_SF_TX_MASK	0x0C
/* don't receive Xon/Xoff */

#define MOXA_MUST_EFR_SF_RX_NO		0x00
/* receive Xon1/Xoff1 */

#define MOXA_MUST_EFR_SF_RX1		0x02
/* receive Xon2/Xoff2 */

#define MOXA_MUST_EFR_SF_RX2		0x01
/* receive Xon1,Xon2/Xoff1,Xoff2 */

#define MOXA_MUST_EFR_SF_RX12		0x03
/* Rx software flow control mask */

#define MOXA_MUST_EFR_SF_RX_MASK	0x03

#endif

Overall Contributors

PersonTokensPropCommitsCommitProp
alan coxalan cox33589.57%133.33%
jiri slabyjiri slaby3810.16%133.33%
lucas de marchilucas de marchi10.27%133.33%
Total374100.00%3100.00%
Directory: drivers/tty
Information contained on this website is for historical information purposes only and does not indicate or represent copyright ownership.
{% endraw %}