Release 4.7 drivers/tty/serial/ifx6x60.h
/****************************************************************************
*
* Driver for the IFX spi modem.
*
* Copyright (C) 2009, 2010 Intel Corp
* Jim Stanley <jim.stanley@intel.com>
*
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*
* You should have received a copy of the GNU General Public License
* along with this program; if not, write to the Free Software
* Foundation, Inc., 51 Franklin Street, Fifth Floor, Boston, MA 02110-1301,
* USA
*
*
*
*****************************************************************************/
#ifndef _IFX6X60_H
#define _IFX6X60_H
#define DRVNAME "ifx6x60"
#define TTYNAME "ttyIFX"
#define IFX_SPI_MAX_MINORS 1
#define IFX_SPI_TRANSFER_SIZE 2048
#define IFX_SPI_FIFO_SIZE 4096
#define IFX_SPI_HEADER_OVERHEAD 4
#define IFX_RESET_TIMEOUT msecs_to_jiffies(50)
/* device flags bitfield definitions */
#define IFX_SPI_STATE_PRESENT 0
#define IFX_SPI_STATE_IO_IN_PROGRESS 1
#define IFX_SPI_STATE_IO_READY 2
#define IFX_SPI_STATE_TIMER_PENDING 3
#define IFX_SPI_STATE_IO_AVAILABLE 4
/* flow control bitfields */
#define IFX_SPI_DCD 0
#define IFX_SPI_CTS 1
#define IFX_SPI_DSR 2
#define IFX_SPI_RI 3
#define IFX_SPI_DTR 4
#define IFX_SPI_RTS 5
#define IFX_SPI_TX_FC 6
#define IFX_SPI_RX_FC 7
#define IFX_SPI_UPDATE 8
#define IFX_SPI_PAYLOAD_SIZE (IFX_SPI_TRANSFER_SIZE - \
IFX_SPI_HEADER_OVERHEAD)
#define IFX_SPI_IRQ_TYPE DETECT_EDGE_RISING
#define IFX_SPI_GPIO_TARGET 0
#define IFX_SPI_GPIO0 0x105
#define IFX_SPI_STATUS_TIMEOUT (2000*HZ)
/* values for bits in power status byte */
#define IFX_SPI_POWER_DATA_PENDING 1
#define IFX_SPI_POWER_SRDY 2
struct ifx_spi_device {
/* Our SPI device */
struct spi_device *spi_dev;
/* Port specific data */
struct kfifo tx_fifo;
spinlock_t fifo_lock;
unsigned long signal_state;
/* TTY Layer logic */
struct tty_port tty_port;
struct device *tty_dev;
int minor;
/* Low level I/O work */
struct tasklet_struct io_work_tasklet;
unsigned long flags;
dma_addr_t rx_dma;
dma_addr_t tx_dma;
int modem; /* Modem type */
int use_dma; /* provide dma-able addrs in SPI msg */
long max_hz; /* max SPI frequency */
spinlock_t write_lock;
int write_pending;
spinlock_t power_lock;
unsigned char power_status;
unsigned char *rx_buffer;
unsigned char *tx_buffer;
dma_addr_t rx_bus;
dma_addr_t tx_bus;
unsigned char spi_more;
unsigned char spi_slave_cts;
struct timer_list spi_timer;
struct spi_message spi_msg;
struct spi_transfer spi_xfer;
struct {
/* gpio lines */
unsigned short srdy; /* slave-ready gpio */
unsigned short mrdy; /* master-ready gpio */
unsigned short reset; /* modem-reset gpio */
unsigned short po; /* modem-on gpio */
unsigned short reset_out; /* modem-in-reset gpio */
/* state/stats */
int unack_srdy_int_nb;
}
gpio;
/* modem reset */
unsigned long mdm_reset_state;
#define MR_START 0
#define MR_INPROGRESS 1
#define MR_COMPLETE 2
wait_queue_head_t mdm_reset_wait;
void (*swap_buf)(unsigned char *buf, int len, void *end);
};
#endif /* _IFX6X60_H */
Overall Contributors
| Person | Tokens | Prop | Commits | CommitProp |
russ gorby | russ gorby | 288 | 92.60% | 2 | 50.00% |
chao bi | chao bi | 23 | 7.40% | 2 | 50.00% |
| Total | 311 | 100.00% | 4 | 100.00% |
Information contained on this website is for historical information purposes only and does not indicate or represent copyright ownership.