/* * atmel platform data * * GPL v2 Only */ #ifndef __ATMEL_H__ #define __ATMEL_H__ #include <linux/mtd/nand.h> #include <linux/mtd/partitions.h> #include <linux/serial.h> /* Compact Flash */ struct at91_cf_data { int irq_pin; /* I/O IRQ */ int det_pin; /* Card detect */ int vcc_pin; /* power switching */ int rst_pin; /* card reset */ u8 chipselect; /* EBI Chip Select number */ u8 flags; #define AT91_CF_TRUE_IDE 0x01 #define AT91_IDE_SWAP_A0_A2 0x02 }; /* NAND / SmartMedia */ struct atmel_nand_data { int enable_pin; /* chip enable */ int det_pin; /* card detect */ int rdy_pin; /* ready/busy */ u8 rdy_pin_active_low; /* rdy_pin value is inverted */ u8 ale; /* address line number connected to ALE */ u8 cle; /* address line number connected to CLE */ u8 bus_width_16; /* buswidth is 16 bit */ u8 ecc_mode; /* ecc mode */ u8 on_flash_bbt; /* bbt on flash */ struct mtd_partition *parts; unsigned int num_parts; bool has_dma; /* support dma transfer */ /* default is false, only for at32ap7000 chip is true */ bool need_reset_workaround; }; /* Serial */ struct atmel_uart_data { int num; /* port num */ short use_dma_tx; /* use transmit DMA? */ short use_dma_rx; /* use receive DMA? */ void __iomem *regs; /* virt. base address, if any */ struct serial_rs485 rs485; /* rs485 settings */ }; /* FIXME: this needs a better location, but gets stuff building again */ extern int at91_suspend_entering_slow_clock(void); #endif /* __ATMEL_H__ */Overall Contributors
| Person | Tokens | Prop | Commits | CommitProp | |
| jean-christophe plagniol-villard | jean-christophe plagniol-villard | 141 | 92.76% | 3 | 50.00% |
| josh wu | josh wu | 8 | 5.26% | 2 | 33.33% |
| paul gortmaker | paul gortmaker | 3 | 1.97% | 1 | 16.67% |
| Total | 152 | 100.00% | 6 | 100.00% |