Author | Tokens | Token Proportion | Commits | Commit Proportion |
---|---|---|---|---|
Suzuki K. Poulose | 111 | 39.78% | 3 | 23.08% |
Steve Capper | 106 | 37.99% | 1 | 7.69% |
Ard Biesheuvel | 51 | 18.28% | 3 | 23.08% |
Will Deacon | 6 | 2.15% | 3 | 23.08% |
Thomas Gleixner | 2 | 0.72% | 1 | 7.69% |
Catalin Marinas | 2 | 0.72% | 1 | 7.69% |
Jun Yao | 1 | 0.36% | 1 | 7.69% |
Total | 279 | 13 |
/* SPDX-License-Identifier: GPL-2.0-only */ /* * Kernel page table mapping * * Copyright (C) 2015 ARM Ltd. */ #ifndef __ASM_KERNEL_PGTABLE_H #define __ASM_KERNEL_PGTABLE_H #include <asm/pgtable-hwdef.h> #include <asm/sparsemem.h> /* * The linear mapping and the start of memory are both 2M aligned (per * the arm64 booting.txt requirements). Hence we can use section mapping * with 4K (section size = 2M) but not with 16K (section size = 32M) or * 64K (section size = 512M). */ #ifdef CONFIG_ARM64_4K_PAGES #define ARM64_SWAPPER_USES_SECTION_MAPS 1 #else #define ARM64_SWAPPER_USES_SECTION_MAPS 0 #endif /* * The idmap and swapper page tables need some space reserved in the kernel * image. Both require pgd, pud (4 levels only) and pmd tables to (section) * map the kernel. With the 64K page configuration, swapper and idmap need to * map to pte level. The swapper also maps the FDT (see __create_page_tables * for more information). Note that the number of ID map translation levels * could be increased on the fly if system RAM is out of reach for the default * VA range, so pages required to map highest possible PA are reserved in all * cases. */ #if ARM64_SWAPPER_USES_SECTION_MAPS #define SWAPPER_PGTABLE_LEVELS (CONFIG_PGTABLE_LEVELS - 1) #define IDMAP_PGTABLE_LEVELS (ARM64_HW_PGTABLE_LEVELS(PHYS_MASK_SHIFT) - 1) #else #define SWAPPER_PGTABLE_LEVELS (CONFIG_PGTABLE_LEVELS) #define IDMAP_PGTABLE_LEVELS (ARM64_HW_PGTABLE_LEVELS(PHYS_MASK_SHIFT)) #endif /* * If KASLR is enabled, then an offset K is added to the kernel address * space. The bottom 21 bits of this offset are zero to guarantee 2MB * alignment for PA and VA. * * For each pagetable level of the swapper, we know that the shift will * be larger than 21 (for the 4KB granule case we use section maps thus * the smallest shift is actually 30) thus there is the possibility that * KASLR can increase the number of pagetable entries by 1, so we make * room for this extra entry. * * Note KASLR cannot increase the number of required entries for a level * by more than one because it increments both the virtual start and end * addresses equally (the extra entry comes from the case where the end * address is just pushed over a boundary and the start address isn't). */ #ifdef CONFIG_RANDOMIZE_BASE #define EARLY_KASLR (1) #else #define EARLY_KASLR (0) #endif #define EARLY_ENTRIES(vstart, vend, shift) (((vend) >> (shift)) \ - ((vstart) >> (shift)) + 1 + EARLY_KASLR) #define EARLY_PGDS(vstart, vend) (EARLY_ENTRIES(vstart, vend, PGDIR_SHIFT)) #if SWAPPER_PGTABLE_LEVELS > 3 #define EARLY_PUDS(vstart, vend) (EARLY_ENTRIES(vstart, vend, PUD_SHIFT)) #else #define EARLY_PUDS(vstart, vend) (0) #endif #if SWAPPER_PGTABLE_LEVELS > 2 #define EARLY_PMDS(vstart, vend) (EARLY_ENTRIES(vstart, vend, SWAPPER_TABLE_SHIFT)) #else #define EARLY_PMDS(vstart, vend) (0) #endif #define EARLY_PAGES(vstart, vend) ( 1 /* PGDIR page */ \ + EARLY_PGDS((vstart), (vend)) /* each PGDIR needs a next level page table */ \ + EARLY_PUDS((vstart), (vend)) /* each PUD needs a next level page table */ \ + EARLY_PMDS((vstart), (vend))) /* each PMD needs a next level page table */ #define INIT_DIR_SIZE (PAGE_SIZE * EARLY_PAGES(KIMAGE_VADDR, _end)) #define IDMAP_DIR_SIZE (IDMAP_PGTABLE_LEVELS * PAGE_SIZE) /* Initial memory map size */ #if ARM64_SWAPPER_USES_SECTION_MAPS #define SWAPPER_BLOCK_SHIFT SECTION_SHIFT #define SWAPPER_BLOCK_SIZE SECTION_SIZE #define SWAPPER_TABLE_SHIFT PUD_SHIFT #else #define SWAPPER_BLOCK_SHIFT PAGE_SHIFT #define SWAPPER_BLOCK_SIZE PAGE_SIZE #define SWAPPER_TABLE_SHIFT PMD_SHIFT #endif /* The size of the initial kernel direct mapping */ #define SWAPPER_INIT_MAP_SIZE (_AC(1, UL) << SWAPPER_TABLE_SHIFT) /* * Initial memory map attributes. */ #define SWAPPER_PTE_FLAGS (PTE_TYPE_PAGE | PTE_AF | PTE_SHARED) #define SWAPPER_PMD_FLAGS (PMD_TYPE_SECT | PMD_SECT_AF | PMD_SECT_S) #if ARM64_SWAPPER_USES_SECTION_MAPS #define SWAPPER_MM_MMUFLAGS (PMD_ATTRINDX(MT_NORMAL) | SWAPPER_PMD_FLAGS) #else #define SWAPPER_MM_MMUFLAGS (PTE_ATTRINDX(MT_NORMAL) | SWAPPER_PTE_FLAGS) #endif /* * To make optimal use of block mappings when laying out the linear * mapping, round down the base of physical memory to a size that can * be mapped efficiently, i.e., either PUD_SIZE (4k granule) or PMD_SIZE * (64k granule), or a multiple that can be mapped using contiguous bits * in the page tables: 32 * PMD_SIZE (16k granule) */ #if defined(CONFIG_ARM64_4K_PAGES) #define ARM64_MEMSTART_SHIFT PUD_SHIFT #elif defined(CONFIG_ARM64_16K_PAGES) #define ARM64_MEMSTART_SHIFT (PMD_SHIFT + 5) #else #define ARM64_MEMSTART_SHIFT PMD_SHIFT #endif /* * sparsemem vmemmap imposes an additional requirement on the alignment of * memstart_addr, due to the fact that the base of the vmemmap region * has a direct correspondence, and needs to appear sufficiently aligned * in the virtual address space. */ #if ARM64_MEMSTART_SHIFT < SECTION_SIZE_BITS #define ARM64_MEMSTART_ALIGN (1UL << SECTION_SIZE_BITS) #else #define ARM64_MEMSTART_ALIGN (1UL << ARM64_MEMSTART_SHIFT) #endif #endif /* __ASM_KERNEL_PGTABLE_H */
Information contained on this website is for historical information purposes only and does not indicate or represent copyright ownership.
Created with Cregit http://github.com/cregit/cregit
Version 2.0-RC1