Cregit: Linux 5.2: core.h

Contributors: 6
Author	Tokens	Token Proportion	Commits	Commit Proportion
Arend Van Spriel	374	63.50%	26	47.27%
Hante Meuleman	116	19.69%	17	30.91%
Franky Lin	55	9.34%	5	9.09%
Rafał Miłecki	37	6.28%	5	9.09%
Chung-Hsien Hsu	6	1.02%	1	1.82%
Matteo Croce	1	0.17%	1	1.82%
Total	589		55
/*
 * Copyright (c) 2010 Broadcom Corporation
 *
 * Permission to use, copy, modify, and/or distribute this software for any
 * purpose with or without fee is hereby granted, provided that the above
 * copyright notice and this permission notice appear in all copies.
 *
 * THE SOFTWARE IS PROVIDED "AS IS" AND THE AUTHOR DISCLAIMS ALL WARRANTIES
 * WITH REGARD TO THIS SOFTWARE INCLUDING ALL IMPLIED WARRANTIES OF
 * MERCHANTABILITY AND FITNESS. IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY
 * SPECIAL, DIRECT, INDIRECT, OR CONSEQUENTIAL DAMAGES OR ANY DAMAGES
 * WHATSOEVER RESULTING FROM LOSS OF USE, DATA OR PROFITS, WHETHER IN AN ACTION
 * OF CONTRACT, NEGLIGENCE OR OTHER TORTIOUS ACTION, ARISING OUT OF OR IN
 * CONNECTION WITH THE USE OR PERFORMANCE OF THIS SOFTWARE.
 */

/****************
 * Common types *
 */

#ifndef BRCMFMAC_CORE_H
#define BRCMFMAC_CORE_H

#include <net/cfg80211.h>
#include "fweh.h"

#define TOE_TX_CSUM_OL		0x00000001
#define TOE_RX_CSUM_OL		0x00000002

/* For supporting multiple interfaces */
#define BRCMF_MAX_IFS	16

/* Small, medium and maximum buffer size for dcmd
 */
#define BRCMF_DCMD_SMLEN	256
#define BRCMF_DCMD_MEDLEN	1536
#define BRCMF_DCMD_MAXLEN	8192

/* IOCTL from host to device are limited in length. A device can only handle
 * ethernet frame size. This limitation is to be applied by protocol layer.
 */
#define BRCMF_TX_IOCTL_MAX_MSG_SIZE	(ETH_FRAME_LEN+ETH_FCS_LEN)

#define BRCMF_AMPDU_RX_REORDER_MAXFLOWS		256

/* Length of firmware version string stored for
 * ethtool driver info which uses 32 bytes as well.
 */
#define BRCMF_DRIVER_FIRMWARE_VERSION_LEN	32

#define NDOL_MAX_ENTRIES	8

/**
 * struct brcmf_ampdu_rx_reorder - AMPDU receive reorder info
 *
 * @pktslots: dynamic allocated array for ordering AMPDU packets.
 * @flow_id: AMPDU flow identifier.
 * @cur_idx: last AMPDU index from firmware.
 * @exp_idx: expected next AMPDU index.
 * @max_idx: maximum amount of packets per AMPDU.
 * @pend_pkts: number of packets currently in @pktslots.
 */
struct brcmf_ampdu_rx_reorder {
	struct sk_buff **pktslots;
	u8 flow_id;
	u8 cur_idx;
	u8 exp_idx;
	u8 max_idx;
	u8 pend_pkts;
};

/* Forward decls for struct brcmf_pub (see below) */
struct brcmf_proto;	/* device communication protocol info */
struct brcmf_fws_info;	/* firmware signalling info */
struct brcmf_mp_device;	/* module paramateres, device specific */

/*
 * struct brcmf_rev_info
 *
 * The result field stores the error code of the
 * revision info request from firmware. For the
 * other fields see struct brcmf_rev_info_le in
 * fwil_types.h
 */
struct brcmf_rev_info {
	int result;
	u32 vendorid;
	u32 deviceid;
	u32 radiorev;
	u32 corerev;
	u32 boardid;
	u32 boardvendor;
	u32 boardrev;
	u32 driverrev;
	u32 ucoderev;
	u32 bus;
	char chipname[12];
	u32 phytype;
	u32 phyrev;
	u32 anarev;
	u32 chippkg;
	u32 nvramrev;
};

/* Common structure for module and instance linkage */
struct brcmf_pub {
	/* Linkage ponters */
	struct brcmf_bus *bus_if;
	struct brcmf_proto *proto;
	struct wiphy *wiphy;
	struct brcmf_cfg80211_info *config;

	/* Internal brcmf items */
	uint hdrlen;		/* Total BRCMF header length (proto + bus) */

	/* Dongle media info */
	char fwver[BRCMF_DRIVER_FIRMWARE_VERSION_LEN];
	u8 mac[ETH_ALEN];		/* MAC address obtained from dongle */

	struct mac_address addresses[BRCMF_MAX_IFS];

	struct brcmf_if *iflist[BRCMF_MAX_IFS];
	s32 if2bss[BRCMF_MAX_IFS];
	struct brcmf_if *mon_if;

	struct mutex proto_block;
	unsigned char proto_buf[BRCMF_DCMD_MAXLEN];

	struct brcmf_fweh_info fweh;

	struct brcmf_ampdu_rx_reorder
		*reorder_flows[BRCMF_AMPDU_RX_REORDER_MAXFLOWS];

	u32 feat_flags;
	u32 chip_quirks;

	struct brcmf_rev_info revinfo;
#ifdef DEBUG
	struct dentry *dbgfs_dir;
#endif

	struct notifier_block inetaddr_notifier;
	struct notifier_block inet6addr_notifier;
	struct brcmf_mp_device *settings;

	struct work_struct bus_reset;

	u8 clmver[BRCMF_DCMD_SMLEN];
};

/* forward declarations */
struct brcmf_cfg80211_vif;
struct brcmf_fws_mac_descriptor;

/**
 * enum brcmf_netif_stop_reason - reason for stopping netif queue.
 *
 * @BRCMF_NETIF_STOP_REASON_FWS_FC:
 *	netif stopped due to firmware signalling flow control.
 * @BRCMF_NETIF_STOP_REASON_FLOW:
 *	netif stopped due to flowring full.
 * @BRCMF_NETIF_STOP_REASON_DISCONNECTED:
 *	netif stopped due to not being connected (STA mode).
 */
enum brcmf_netif_stop_reason {
	BRCMF_NETIF_STOP_REASON_FWS_FC = BIT(0),
	BRCMF_NETIF_STOP_REASON_FLOW = BIT(1),
	BRCMF_NETIF_STOP_REASON_DISCONNECTED = BIT(2)
};

/**
 * struct brcmf_if - interface control information.
 *
 * @drvr: points to device related information.
 * @vif: points to cfg80211 specific interface information.
 * @ndev: associated network device.
 * @multicast_work: worker object for multicast provisioning.
 * @ndoffload_work: worker object for neighbor discovery offload configuration.
 * @fws_desc: interface specific firmware-signalling descriptor.
 * @ifidx: interface index in device firmware.
 * @bsscfgidx: index of bss associated with this interface.
 * @mac_addr: assigned mac address.
 * @netif_stop: bitmap indicates reason why netif queues are stopped.
 * @netif_stop_lock: spinlock for update netif_stop from multiple sources.
 * @pend_8021x_cnt: tracks outstanding number of 802.1x frames.
 * @pend_8021x_wait: used for signalling change in count.
 * @fwil_fwerr: flag indicating fwil layer should return firmware error codes.
 */
struct brcmf_if {
	struct brcmf_pub *drvr;
	struct brcmf_cfg80211_vif *vif;
	struct net_device *ndev;
	struct work_struct multicast_work;
	struct work_struct ndoffload_work;
	struct brcmf_fws_mac_descriptor *fws_desc;
	int ifidx;
	s32 bsscfgidx;
	u8 mac_addr[ETH_ALEN];
	u8 netif_stop;
	spinlock_t netif_stop_lock;
	atomic_t pend_8021x_cnt;
	wait_queue_head_t pend_8021x_wait;
	struct in6_addr ipv6_addr_tbl[NDOL_MAX_ENTRIES];
	u8 ipv6addr_idx;
	bool fwil_fwerr;
};

int brcmf_netdev_wait_pend8021x(struct brcmf_if *ifp);

/* Return pointer to interface name */
char *brcmf_ifname(struct brcmf_if *ifp);
struct brcmf_if *brcmf_get_ifp(struct brcmf_pub *drvr, int ifidx);
void brcmf_configure_arp_nd_offload(struct brcmf_if *ifp, bool enable);
int brcmf_net_attach(struct brcmf_if *ifp, bool rtnl_locked);
struct brcmf_if *brcmf_add_if(struct brcmf_pub *drvr, s32 bsscfgidx, s32 ifidx,
			      bool is_p2pdev, const char *name, u8 *mac_addr);
void brcmf_remove_interface(struct brcmf_if *ifp, bool rtnl_locked);
void brcmf_txflowblock_if(struct brcmf_if *ifp,
			  enum brcmf_netif_stop_reason reason, bool state);
void brcmf_txfinalize(struct brcmf_if *ifp, struct sk_buff *txp, bool success);
void brcmf_netif_rx(struct brcmf_if *ifp, struct sk_buff *skb);
void brcmf_netif_mon_rx(struct brcmf_if *ifp, struct sk_buff *skb);
void brcmf_net_setcarrier(struct brcmf_if *ifp, bool on);
int __init brcmf_core_init(void);
void __exit brcmf_core_exit(void);

#endif /* BRCMFMAC_CORE_H */