Contributors: 14
| Author |
Tokens |
Token Proportion |
Commits |
Commit Proportion |
| Ivo van Doorn |
891 |
70.05% |
27 |
55.10% |
| Gertjan van Wingerde |
144 |
11.32% |
2 |
4.08% |
| Stanislaw Gruszka |
135 |
10.61% |
2 |
4.08% |
| Helmut Schaa |
27 |
2.12% |
3 |
6.12% |
| Lars Ericsson |
24 |
1.89% |
2 |
4.08% |
| John Li |
11 |
0.86% |
1 |
2.04% |
| Stanislaw W. Gruszka |
9 |
0.71% |
1 |
2.04% |
| Johannes Berg |
9 |
0.71% |
5 |
10.20% |
| Karl Beldan |
9 |
0.71% |
1 |
2.04% |
| Fred Chou |
6 |
0.47% |
1 |
2.04% |
| Andrey Yurovsky |
3 |
0.24% |
1 |
2.04% |
| Thomas Gleixner |
2 |
0.16% |
1 |
2.04% |
| Mattias Nissler |
1 |
0.08% |
1 |
2.04% |
| Lucas De Marchi |
1 |
0.08% |
1 |
2.04% |
| Total |
1272 |
|
49 |
|
// SPDX-License-Identifier: GPL-2.0-or-later
/*
Copyright (C) 2004 - 2009 Ivo van Doorn <IvDoorn@gmail.com>
<http://rt2x00.serialmonkey.com>
*/
/*
Module: rt2x00lib
Abstract: rt2x00 generic configuration routines.
*/
#include <linux/kernel.h>
#include <linux/module.h>
#include "rt2x00.h"
#include "rt2x00lib.h"
void rt2x00lib_config_intf(struct rt2x00_dev *rt2x00dev,
struct rt2x00_intf *intf,
enum nl80211_iftype type,
const u8 *mac, const u8 *bssid)
{
struct rt2x00intf_conf conf;
unsigned int flags = 0;
conf.type = type;
switch (type) {
case NL80211_IFTYPE_ADHOC:
conf.sync = TSF_SYNC_ADHOC;
break;
case NL80211_IFTYPE_AP:
case NL80211_IFTYPE_MESH_POINT:
case NL80211_IFTYPE_WDS:
conf.sync = TSF_SYNC_AP_NONE;
break;
case NL80211_IFTYPE_STATION:
conf.sync = TSF_SYNC_INFRA;
break;
default:
conf.sync = TSF_SYNC_NONE;
break;
}
/*
* Note that when NULL is passed as address we will send
* 00:00:00:00:00 to the device to clear the address.
* This will prevent the device being confused when it wants
* to ACK frames or considers itself associated.
*/
memset(conf.mac, 0, sizeof(conf.mac));
if (mac)
memcpy(conf.mac, mac, ETH_ALEN);
memset(conf.bssid, 0, sizeof(conf.bssid));
if (bssid)
memcpy(conf.bssid, bssid, ETH_ALEN);
flags |= CONFIG_UPDATE_TYPE;
if (mac || (!rt2x00dev->intf_ap_count && !rt2x00dev->intf_sta_count))
flags |= CONFIG_UPDATE_MAC;
if (bssid || (!rt2x00dev->intf_ap_count && !rt2x00dev->intf_sta_count))
flags |= CONFIG_UPDATE_BSSID;
rt2x00dev->ops->lib->config_intf(rt2x00dev, intf, &conf, flags);
}
void rt2x00lib_config_erp(struct rt2x00_dev *rt2x00dev,
struct rt2x00_intf *intf,
struct ieee80211_bss_conf *bss_conf,
u32 changed)
{
struct rt2x00lib_erp erp;
memset(&erp, 0, sizeof(erp));
erp.short_preamble = bss_conf->use_short_preamble;
erp.cts_protection = bss_conf->use_cts_prot;
erp.slot_time = bss_conf->use_short_slot ? SHORT_SLOT_TIME : SLOT_TIME;
erp.sifs = SIFS;
erp.pifs = bss_conf->use_short_slot ? SHORT_PIFS : PIFS;
erp.difs = bss_conf->use_short_slot ? SHORT_DIFS : DIFS;
erp.eifs = bss_conf->use_short_slot ? SHORT_EIFS : EIFS;
erp.basic_rates = bss_conf->basic_rates;
erp.beacon_int = bss_conf->beacon_int;
/* Update the AID, this is needed for dynamic PS support */
rt2x00dev->aid = bss_conf->assoc ? bss_conf->aid : 0;
rt2x00dev->last_beacon = bss_conf->sync_tsf;
/* Update global beacon interval time, this is needed for PS support */
rt2x00dev->beacon_int = bss_conf->beacon_int;
if (changed & BSS_CHANGED_HT)
erp.ht_opmode = bss_conf->ht_operation_mode;
rt2x00dev->ops->lib->config_erp(rt2x00dev, &erp, changed);
}
void rt2x00lib_config_antenna(struct rt2x00_dev *rt2x00dev,
struct antenna_setup config)
{
struct link_ant *ant = &rt2x00dev->link.ant;
struct antenna_setup *def = &rt2x00dev->default_ant;
struct antenna_setup *active = &rt2x00dev->link.ant.active;
/*
* When the caller tries to send the SW diversity,
* we must update the ANTENNA_RX_DIVERSITY flag to
* enable the antenna diversity in the link tuner.
*
* Secondly, we must guarentee we never send the
* software antenna diversity command to the driver.
*/
if (!(ant->flags & ANTENNA_RX_DIVERSITY)) {
if (config.rx == ANTENNA_SW_DIVERSITY) {
ant->flags |= ANTENNA_RX_DIVERSITY;
if (def->rx == ANTENNA_SW_DIVERSITY)
config.rx = ANTENNA_B;
else
config.rx = def->rx;
}
} else if (config.rx == ANTENNA_SW_DIVERSITY)
config.rx = active->rx;
if (!(ant->flags & ANTENNA_TX_DIVERSITY)) {
if (config.tx == ANTENNA_SW_DIVERSITY) {
ant->flags |= ANTENNA_TX_DIVERSITY;
if (def->tx == ANTENNA_SW_DIVERSITY)
config.tx = ANTENNA_B;
else
config.tx = def->tx;
}
} else if (config.tx == ANTENNA_SW_DIVERSITY)
config.tx = active->tx;
/*
* Antenna setup changes require the RX to be disabled,
* else the changes will be ignored by the device.
*/
if (test_bit(DEVICE_STATE_ENABLED_RADIO, &rt2x00dev->flags))
rt2x00queue_stop_queue(rt2x00dev->rx);
/*
* Write new antenna setup to device and reset the link tuner.
* The latter is required since we need to recalibrate the
* noise-sensitivity ratio for the new setup.
*/
rt2x00dev->ops->lib->config_ant(rt2x00dev, &config);
rt2x00link_reset_tuner(rt2x00dev, true);
memcpy(active, &config, sizeof(config));
if (test_bit(DEVICE_STATE_ENABLED_RADIO, &rt2x00dev->flags))
rt2x00queue_start_queue(rt2x00dev->rx);
}
static u16 rt2x00ht_center_channel(struct rt2x00_dev *rt2x00dev,
struct ieee80211_conf *conf)
{
struct hw_mode_spec *spec = &rt2x00dev->spec;
int center_channel;
u16 i;
/*
* Initialize center channel to current channel.
*/
center_channel = spec->channels[conf->chandef.chan->hw_value].channel;
/*
* Adjust center channel to HT40+ and HT40- operation.
*/
if (conf_is_ht40_plus(conf))
center_channel += 2;
else if (conf_is_ht40_minus(conf))
center_channel -= (center_channel == 14) ? 1 : 2;
for (i = 0; i < spec->num_channels; i++)
if (spec->channels[i].channel == center_channel)
return i;
WARN_ON(1);
return conf->chandef.chan->hw_value;
}
void rt2x00lib_config(struct rt2x00_dev *rt2x00dev,
struct ieee80211_conf *conf,
unsigned int ieee80211_flags)
{
struct rt2x00lib_conf libconf;
u16 hw_value;
u16 autowake_timeout;
u16 beacon_int;
u16 beacon_diff;
memset(&libconf, 0, sizeof(libconf));
libconf.conf = conf;
if (ieee80211_flags & IEEE80211_CONF_CHANGE_CHANNEL) {
if (!conf_is_ht(conf))
set_bit(CONFIG_HT_DISABLED, &rt2x00dev->flags);
else
clear_bit(CONFIG_HT_DISABLED, &rt2x00dev->flags);
if (conf_is_ht40(conf)) {
set_bit(CONFIG_CHANNEL_HT40, &rt2x00dev->flags);
hw_value = rt2x00ht_center_channel(rt2x00dev, conf);
} else {
clear_bit(CONFIG_CHANNEL_HT40, &rt2x00dev->flags);
hw_value = conf->chandef.chan->hw_value;
}
memcpy(&libconf.rf,
&rt2x00dev->spec.channels[hw_value],
sizeof(libconf.rf));
memcpy(&libconf.channel,
&rt2x00dev->spec.channels_info[hw_value],
sizeof(libconf.channel));
/* Used for VCO periodic calibration */
rt2x00dev->rf_channel = libconf.rf.channel;
}
if (rt2x00_has_cap_flag(rt2x00dev, REQUIRE_PS_AUTOWAKE) &&
(ieee80211_flags & IEEE80211_CONF_CHANGE_PS))
cancel_delayed_work_sync(&rt2x00dev->autowakeup_work);
/*
* Start configuration.
*/
rt2x00dev->ops->lib->config(rt2x00dev, &libconf, ieee80211_flags);
if (conf->flags & IEEE80211_CONF_PS)
set_bit(CONFIG_POWERSAVING, &rt2x00dev->flags);
else
clear_bit(CONFIG_POWERSAVING, &rt2x00dev->flags);
if (conf->flags & IEEE80211_CONF_MONITOR)
set_bit(CONFIG_MONITORING, &rt2x00dev->flags);
else
clear_bit(CONFIG_MONITORING, &rt2x00dev->flags);
rt2x00dev->curr_band = conf->chandef.chan->band;
rt2x00dev->curr_freq = conf->chandef.chan->center_freq;
rt2x00dev->tx_power = conf->power_level;
rt2x00dev->short_retry = conf->short_frame_max_tx_count;
rt2x00dev->long_retry = conf->long_frame_max_tx_count;
/*
* Some configuration changes affect the link quality
* which means we need to reset the link tuner.
*/
if (ieee80211_flags & IEEE80211_CONF_CHANGE_CHANNEL)
rt2x00link_reset_tuner(rt2x00dev, false);
if (test_bit(DEVICE_STATE_PRESENT, &rt2x00dev->flags) &&
rt2x00_has_cap_flag(rt2x00dev, REQUIRE_PS_AUTOWAKE) &&
(ieee80211_flags & IEEE80211_CONF_CHANGE_PS) &&
(conf->flags & IEEE80211_CONF_PS)) {
beacon_diff = (long)jiffies - (long)rt2x00dev->last_beacon;
beacon_int = msecs_to_jiffies(rt2x00dev->beacon_int);
if (beacon_diff > beacon_int)
beacon_diff = 0;
autowake_timeout = (conf->ps_dtim_period * beacon_int) - beacon_diff;
queue_delayed_work(rt2x00dev->workqueue,
&rt2x00dev->autowakeup_work,
autowake_timeout - 15);
}
}