Author | Tokens | Token Proportion | Commits | Commit Proportion |
---|---|---|---|---|
Linus Walleij | 1246 | 91.08% | 1 | 20.00% |
Uwe Kleine-König | 119 | 8.70% | 2 | 40.00% |
Thomas Gleixner | 2 | 0.15% | 1 | 20.00% |
Axel Lin | 1 | 0.07% | 1 | 20.00% |
Total | 1368 | 5 |
// SPDX-License-Identifier: GPL-2.0-only /* * Copyright (C) 2016 Linaro Ltd. * * Author: Linus Walleij <linus.walleij@linaro.org> */ #include <linux/bitops.h> #include <linux/delay.h> #include <linux/err.h> #include <linux/mfd/stmpe.h> #include <linux/module.h> #include <linux/of.h> #include <linux/platform_device.h> #include <linux/pwm.h> #include <linux/slab.h> #define STMPE24XX_PWMCS 0x30 #define PWMCS_EN_PWM0 BIT(0) #define PWMCS_EN_PWM1 BIT(1) #define PWMCS_EN_PWM2 BIT(2) #define STMPE24XX_PWMIC0 0x38 #define STMPE24XX_PWMIC1 0x39 #define STMPE24XX_PWMIC2 0x3a #define STMPE_PWM_24XX_PINBASE 21 struct stmpe_pwm { struct stmpe *stmpe; struct pwm_chip chip; u8 last_duty; }; static inline struct stmpe_pwm *to_stmpe_pwm(struct pwm_chip *chip) { return container_of(chip, struct stmpe_pwm, chip); } static int stmpe_24xx_pwm_enable(struct pwm_chip *chip, struct pwm_device *pwm) { struct stmpe_pwm *stmpe_pwm = to_stmpe_pwm(chip); u8 value; int ret; ret = stmpe_reg_read(stmpe_pwm->stmpe, STMPE24XX_PWMCS); if (ret < 0) { dev_err(chip->dev, "error reading PWM#%u control\n", pwm->hwpwm); return ret; } value = ret | BIT(pwm->hwpwm); ret = stmpe_reg_write(stmpe_pwm->stmpe, STMPE24XX_PWMCS, value); if (ret) { dev_err(chip->dev, "error writing PWM#%u control\n", pwm->hwpwm); return ret; } return 0; } static void stmpe_24xx_pwm_disable(struct pwm_chip *chip, struct pwm_device *pwm) { struct stmpe_pwm *stmpe_pwm = to_stmpe_pwm(chip); u8 value; int ret; ret = stmpe_reg_read(stmpe_pwm->stmpe, STMPE24XX_PWMCS); if (ret < 0) { dev_err(chip->dev, "error reading PWM#%u control\n", pwm->hwpwm); return; } value = ret & ~BIT(pwm->hwpwm); ret = stmpe_reg_write(stmpe_pwm->stmpe, STMPE24XX_PWMCS, value); if (ret) { dev_err(chip->dev, "error writing PWM#%u control\n", pwm->hwpwm); return; } } /* STMPE 24xx PWM instructions */ #define SMAX 0x007f #define SMIN 0x00ff #define GTS 0x0000 #define LOAD BIT(14) /* Only available on 2403 */ #define RAMPUP 0x0000 #define RAMPDOWN BIT(7) #define PRESCALE_512 BIT(14) #define STEPTIME_1 BIT(8) #define BRANCH (BIT(15) | BIT(13)) static int stmpe_24xx_pwm_config(struct pwm_chip *chip, struct pwm_device *pwm, int duty_ns, int period_ns) { struct stmpe_pwm *stmpe_pwm = to_stmpe_pwm(chip); unsigned int i, pin; u16 program[3] = { SMAX, GTS, GTS, }; u8 offset; int ret; /* Make sure we are disabled */ if (pwm_is_enabled(pwm)) { stmpe_24xx_pwm_disable(chip, pwm); } else { /* Connect the PWM to the pin */ pin = pwm->hwpwm; /* On STMPE2401 and 2403 pins 21,22,23 are used */ if (stmpe_pwm->stmpe->partnum == STMPE2401 || stmpe_pwm->stmpe->partnum == STMPE2403) pin += STMPE_PWM_24XX_PINBASE; ret = stmpe_set_altfunc(stmpe_pwm->stmpe, BIT(pin), STMPE_BLOCK_PWM); if (ret) { dev_err(chip->dev, "unable to connect PWM#%u to pin\n", pwm->hwpwm); return ret; } } /* STMPE24XX */ switch (pwm->hwpwm) { case 0: offset = STMPE24XX_PWMIC0; break; case 1: offset = STMPE24XX_PWMIC1; break; case 2: offset = STMPE24XX_PWMIC2; break; default: /* Should not happen as npwm is 3 */ return -ENODEV; } dev_dbg(chip->dev, "PWM#%u: config duty %d ns, period %d ns\n", pwm->hwpwm, duty_ns, period_ns); if (duty_ns == 0) { if (stmpe_pwm->stmpe->partnum == STMPE2401) program[0] = SMAX; /* off all the time */ if (stmpe_pwm->stmpe->partnum == STMPE2403) program[0] = LOAD | 0xff; /* LOAD 0xff */ stmpe_pwm->last_duty = 0x00; } else if (duty_ns == period_ns) { if (stmpe_pwm->stmpe->partnum == STMPE2401) program[0] = SMIN; /* on all the time */ if (stmpe_pwm->stmpe->partnum == STMPE2403) program[0] = LOAD | 0x00; /* LOAD 0x00 */ stmpe_pwm->last_duty = 0xff; } else { u8 value, last = stmpe_pwm->last_duty; unsigned long duty; /* * Counter goes from 0x00 to 0xff repeatedly at 32768 Hz, * (means a period of 30517 ns) then this is compared to the * counter from the ramp, if this is >= PWM counter the output * is high. With LOAD we can define how much of the cycle it * is on. * * Prescale = 0 -> 2 kHz -> T = 1/f = 488281.25 ns */ /* Scale to 0..0xff */ duty = duty_ns * 256; duty = DIV_ROUND_CLOSEST(duty, period_ns); value = duty; if (value == last) { /* Run the old program */ if (pwm_is_enabled(pwm)) stmpe_24xx_pwm_enable(chip, pwm); return 0; } else if (stmpe_pwm->stmpe->partnum == STMPE2403) { /* STMPE2403 can simply set the right PWM value */ program[0] = LOAD | value; program[1] = 0x0000; } else if (stmpe_pwm->stmpe->partnum == STMPE2401) { /* STMPE2401 need a complex program */ u16 incdec = 0x0000; if (last < value) /* Count up */ incdec = RAMPUP | (value - last); else /* Count down */ incdec = RAMPDOWN | (last - value); /* Step to desired value, smoothly */ program[0] = PRESCALE_512 | STEPTIME_1 | incdec; /* Loop eternally to 0x00 */ program[1] = BRANCH; } dev_dbg(chip->dev, "PWM#%u: value = %02x, last_duty = %02x, program=%04x,%04x,%04x\n", pwm->hwpwm, value, last, program[0], program[1], program[2]); stmpe_pwm->last_duty = value; } /* * We can write programs of up to 64 16-bit words into this channel. */ for (i = 0; i < ARRAY_SIZE(program); i++) { u8 value; value = (program[i] >> 8) & 0xff; ret = stmpe_reg_write(stmpe_pwm->stmpe, offset, value); if (ret) { dev_err(chip->dev, "error writing register %02x: %d\n", offset, ret); return ret; } value = program[i] & 0xff; ret = stmpe_reg_write(stmpe_pwm->stmpe, offset, value); if (ret) { dev_err(chip->dev, "error writing register %02x: %d\n", offset, ret); return ret; } } /* If we were enabled, re-enable this PWM */ if (pwm_is_enabled(pwm)) stmpe_24xx_pwm_enable(chip, pwm); /* Sleep for 200ms so we're sure it will take effect */ msleep(200); dev_dbg(chip->dev, "programmed PWM#%u, %u bytes\n", pwm->hwpwm, i); return 0; } static int stmpe_24xx_pwm_apply(struct pwm_chip *chip, struct pwm_device *pwm, const struct pwm_state *state) { int err; if (state->polarity != PWM_POLARITY_NORMAL) return -EINVAL; if (!state->enabled) { if (pwm->state.enabled) stmpe_24xx_pwm_disable(chip, pwm); return 0; } err = stmpe_24xx_pwm_config(pwm->chip, pwm, state->duty_cycle, state->period); if (err) return err; if (!pwm->state.enabled) err = stmpe_24xx_pwm_enable(chip, pwm); return err; } static const struct pwm_ops stmpe_24xx_pwm_ops = { .apply = stmpe_24xx_pwm_apply, .owner = THIS_MODULE, }; static int __init stmpe_pwm_probe(struct platform_device *pdev) { struct stmpe *stmpe = dev_get_drvdata(pdev->dev.parent); struct stmpe_pwm *stmpe_pwm; int ret; stmpe_pwm = devm_kzalloc(&pdev->dev, sizeof(*stmpe_pwm), GFP_KERNEL); if (!stmpe_pwm) return -ENOMEM; stmpe_pwm->stmpe = stmpe; stmpe_pwm->chip.dev = &pdev->dev; if (stmpe->partnum == STMPE2401 || stmpe->partnum == STMPE2403) { stmpe_pwm->chip.ops = &stmpe_24xx_pwm_ops; stmpe_pwm->chip.npwm = 3; } else { if (stmpe->partnum == STMPE1601) dev_err(&pdev->dev, "STMPE1601 not yet supported\n"); else dev_err(&pdev->dev, "Unknown STMPE PWM\n"); return -ENODEV; } ret = stmpe_enable(stmpe, STMPE_BLOCK_PWM); if (ret) return ret; ret = pwmchip_add(&stmpe_pwm->chip); if (ret) { stmpe_disable(stmpe, STMPE_BLOCK_PWM); return ret; } return 0; } static struct platform_driver stmpe_pwm_driver = { .driver = { .name = "stmpe-pwm", }, }; builtin_platform_driver_probe(stmpe_pwm_driver, stmpe_pwm_probe);
Information contained on this website is for historical information purposes only and does not indicate or represent copyright ownership.
Created with Cregit http://github.com/cregit/cregit
Version 2.0-RC1