| Author | Tokens | Token Proportion | Commits | Commit Proportion |
|---|---|---|---|---|
| Corentin Labbe | 821 | 99.76% | 1 | 50.00% |
| Herbert Xu | 2 | 0.24% | 1 | 50.00% |
| Total | 823 | 2 |
/* SPDX-License-Identifier: GPL-2.0 */ /* * sl3516-ce.h - hardware cryptographic offloader for cortina/gemini SoC * * Copyright (C) 2021 Corentin LABBE <clabbe@baylibre.com> * * General notes on this driver: * Called either Crypto Acceleration Engine Module, Security Acceleration Engine * or IPSEC module in the datasheet, it will be called Crypto Engine for short * in this driver. * The CE was designed to handle IPSEC and wifi(TKIP WEP) protocol. * It can handle AES, DES, 3DES, MD5, WEP, TKIP, SHA1, HMAC(MD5), HMAC(SHA1), * Michael cipher/digest suites. * It acts the same as a network hw, with both RX and TX chained descriptors. */ #include <crypto/aes.h> #include <crypto/engine.h> #include <crypto/scatterwalk.h> #include <crypto/skcipher.h> #include <linux/debugfs.h> #include <linux/hw_random.h> #define TQ0_TYPE_DATA 0 #define TQ0_TYPE_CTRL BIT(0) #define TQ1_CIPHER BIT(1) #define TQ2_AUTH BIT(2) #define TQ3_IV BIT(3) #define TQ4_KEY0 BIT(4) #define TQ5_KEY4 BIT(5) #define TQ6_KEY6 BIT(6) #define TQ7_AKEY0 BIT(7) #define TQ8_AKEY2 BIT(8) #define TQ9_AKEY2 BIT(9) #define ECB_AES 0x2 #define DESC_LAST 0x01 #define DESC_FIRST 0x02 #define IPSEC_ID 0x0000 #define IPSEC_STATUS_REG 0x00a8 #define IPSEC_RAND_NUM_REG 0x00ac #define IPSEC_DMA_DEVICE_ID 0xff00 #define IPSEC_DMA_STATUS 0xff04 #define IPSEC_TXDMA_CTRL 0xff08 #define IPSEC_TXDMA_FIRST_DESC 0xff0c #define IPSEC_TXDMA_CURR_DESC 0xff10 #define IPSEC_RXDMA_CTRL 0xff14 #define IPSEC_RXDMA_FIRST_DESC 0xff18 #define IPSEC_RXDMA_CURR_DESC 0xff1c #define IPSEC_TXDMA_BUF_ADDR 0xff28 #define IPSEC_RXDMA_BUF_ADDR 0xff38 #define IPSEC_RXDMA_BUF_SIZE 0xff30 #define CE_ENCRYPTION 0x01 #define CE_DECRYPTION 0x03 #define MAXDESC 6 #define DMA_STATUS_RS_EOFI BIT(22) #define DMA_STATUS_RS_PERR BIT(24) #define DMA_STATUS_RS_DERR BIT(25) #define DMA_STATUS_TS_EOFI BIT(27) #define DMA_STATUS_TS_PERR BIT(29) #define DMA_STATUS_TS_DERR BIT(30) #define TXDMA_CTRL_START BIT(31) #define TXDMA_CTRL_CONTINUE BIT(30) #define TXDMA_CTRL_CHAIN_MODE BIT(29) /* the burst value is not documented in the datasheet */ #define TXDMA_CTRL_BURST_UNK BIT(22) #define TXDMA_CTRL_INT_FAIL BIT(17) #define TXDMA_CTRL_INT_PERR BIT(16) #define RXDMA_CTRL_START BIT(31) #define RXDMA_CTRL_CONTINUE BIT(30) #define RXDMA_CTRL_CHAIN_MODE BIT(29) /* the burst value is not documented in the datasheet */ #define RXDMA_CTRL_BURST_UNK BIT(22) #define RXDMA_CTRL_INT_FINISH BIT(18) #define RXDMA_CTRL_INT_FAIL BIT(17) #define RXDMA_CTRL_INT_PERR BIT(16) #define RXDMA_CTRL_INT_EOD BIT(15) #define RXDMA_CTRL_INT_EOF BIT(14) #define CE_CPU 0 #define CE_DMA 1 /* * struct sl3516_ce_descriptor - descriptor for CE operations * @frame_ctrl: Information for the current descriptor * @flag_status: For send packet, describe flag of operations. * @buf_adr: pointer to a send/recv buffer for data packet * @next_desc: control linking to other descriptors */ struct descriptor { union { u32 raw; /* * struct desc_frame_ctrl - Information for the current descriptor * @buffer_size: the size of buffer at buf_adr * @desc_count: Upon completion of a DMA operation, DMA * write the number of descriptors used * for the current frame * @checksum: unknown * @authcomp: unknown * @perr: Protocol error during processing this descriptor * @derr: Data error during processing this descriptor * @own: 0 if owned by CPU, 1 for DMA */ struct desc_frame_ctrl { u32 buffer_size :16; u32 desc_count :6; u32 checksum :6; u32 authcomp :1; u32 perr :1; u32 derr :1; u32 own :1; } bits; } frame_ctrl; union { u32 raw; /* * struct desc_flag_status - flag for this descriptor * @tqflag: list of flag describing the type of operation * to be performed. */ struct desc_tx_flag_status { u32 tqflag :10; u32 unused :22; } tx_flag; } flag_status; u32 buf_adr; union { u32 next_descriptor; /* * struct desc_next - describe chaining of descriptors * @sof_eof: does the descriptor is first (0x11), * the last (0x01), middle of a chan (0x00) * or the only one (0x11) * @dec: AHB bus address increase (0), decrease (1) * @eofie: End of frame interrupt enable * @ndar: Next descriptor address */ struct desc_next { u32 sof_eof :2; u32 dec :1; u32 eofie :1; u32 ndar :28; } bits; } next_desc; }; /* * struct control - The value of this register is used to set the * operation mode of the IPSec Module. * @process_id: Used to identify the process. The number will be copied * to the descriptor status of the received packet. * @auth_check_len: Number of 32-bit words to be checked or appended by the * authentication module * @auth_algorithm: * @auth_mode: 0:append 1:Check Authentication Result * @fcs_stream_copy: 0:enable 1:disable authentication stream copy * @mix_key_sel: 0:use rCipherKey0-3 1:use Key Mixer * @aesnk: AES Key Size * @cipher_algorithm: choice of CBC/ECE and AES/DES/3DES * @op_mode: Operation Mode for the IPSec Module */ struct pkt_control_header { u32 process_id :8; u32 auth_check_len :3; u32 un1 :1; u32 auth_algorithm :3; u32 auth_mode :1; u32 fcs_stream_copy :1; u32 un2 :2; u32 mix_key_sel :1; u32 aesnk :4; u32 cipher_algorithm :3; u32 un3 :1; u32 op_mode :4; }; struct pkt_control_cipher { u32 algorithm_len :16; u32 header_len :16; }; /* * struct pkt_control_ecb - control packet for ECB */ struct pkt_control_ecb { struct pkt_control_header control; struct pkt_control_cipher cipher; unsigned char key[AES_MAX_KEY_SIZE]; }; /* * struct sl3516_ce_dev - main container for all this driver information * @base: base address * @clks: clocks used * @reset: pointer to reset controller * @dev: the platform device * @engine: ptr to the crypto/crypto_engine * @complete: completion for the current task on this flow * @status: set to 1 by interrupt if task is done * @dtx: base DMA address for TX descriptors * @tx base address of TX descriptors * @drx: base DMA address for RX descriptors * @rx base address of RX descriptors * @ctx current used TX descriptor * @crx current used RX descriptor * @trng hw_random structure for RNG * @hwrng_stat_req number of HWRNG requests * @hwrng_stat_bytes total number of bytes generated by RNG * @stat_irq number of IRQ handled by CE * @stat_irq_tx number of TX IRQ handled by CE * @stat_irq_rx number of RX IRQ handled by CE * @stat_req number of requests handled by CE * @fallbak_sg_count_tx number of fallback due to destination SG count * @fallbak_sg_count_rx number of fallback due to source SG count * @fallbak_not_same_len number of fallback due to difference in SG length * @dbgfs_dir: Debugfs dentry for statistic directory * @dbgfs_stats: Debugfs dentry for statistic counters */ struct sl3516_ce_dev { void __iomem *base; struct clk *clks; struct reset_control *reset; struct device *dev; struct crypto_engine *engine; struct completion complete; int status; dma_addr_t dtx; struct descriptor *tx; dma_addr_t drx; struct descriptor *rx; int ctx; int crx; struct hwrng trng; unsigned long hwrng_stat_req; unsigned long hwrng_stat_bytes; unsigned long stat_irq; unsigned long stat_irq_tx; unsigned long stat_irq_rx; unsigned long stat_req; unsigned long fallback_sg_count_tx; unsigned long fallback_sg_count_rx; unsigned long fallback_not_same_len; unsigned long fallback_mod16; unsigned long fallback_align16; #ifdef CONFIG_CRYPTO_DEV_SL3516_DEBUG struct dentry *dbgfs_dir; struct dentry *dbgfs_stats; #endif void *pctrl; dma_addr_t dctrl; }; struct sginfo { u32 addr; u32 len; }; /* * struct sl3516_ce_cipher_req_ctx - context for a skcipher request * @t_src: list of mapped SGs with their size * @t_dst: list of mapped SGs with their size * @op_dir: direction (encrypt vs decrypt) for this request * @pctrllen: the length of the ctrl packet * @tqflag: the TQflag to set in data packet * @h pointer to the pkt_control_cipher header * @nr_sgs: number of source SG * @nr_sgd: number of destination SG * @fallback_req: request struct for invoking the fallback skcipher TFM */ struct sl3516_ce_cipher_req_ctx { struct sginfo t_src[MAXDESC]; struct sginfo t_dst[MAXDESC]; u32 op_dir; unsigned int pctrllen; u32 tqflag; struct pkt_control_cipher *h; int nr_sgs; int nr_sgd; struct skcipher_request fallback_req; // keep at the end }; /* * struct sl3516_ce_cipher_tfm_ctx - context for a skcipher TFM * @key: pointer to key data * @keylen: len of the key * @ce: pointer to the private data of driver handling this TFM * @fallback_tfm: pointer to the fallback TFM */ struct sl3516_ce_cipher_tfm_ctx { u32 *key; u32 keylen; struct sl3516_ce_dev *ce; struct crypto_skcipher *fallback_tfm; }; /* * struct sl3516_ce_alg_template - crypto_alg template * @type: the CRYPTO_ALG_TYPE for this template * @mode: value to be used in control packet for this algorithm * @ce: pointer to the sl3516_ce_dev structure associated with * this template * @alg: one of sub struct must be used * @stat_req: number of request done on this template * @stat_fb: number of request which has fallbacked * @stat_bytes: total data size done by this template */ struct sl3516_ce_alg_template { u32 type; u32 mode; struct sl3516_ce_dev *ce; union { struct skcipher_engine_alg skcipher; } alg; unsigned long stat_req; unsigned long stat_fb; unsigned long stat_bytes; }; int sl3516_ce_enqueue(struct crypto_async_request *areq, u32 type); int sl3516_ce_aes_setkey(struct crypto_skcipher *tfm, const u8 *key, unsigned int keylen); int sl3516_ce_cipher_init(struct crypto_tfm *tfm); void sl3516_ce_cipher_exit(struct crypto_tfm *tfm); int sl3516_ce_skdecrypt(struct skcipher_request *areq); int sl3516_ce_skencrypt(struct skcipher_request *areq); int sl3516_ce_run_task(struct sl3516_ce_dev *ce, struct sl3516_ce_cipher_req_ctx *rctx, const char *name); int sl3516_ce_rng_register(struct sl3516_ce_dev *ce); void sl3516_ce_rng_unregister(struct sl3516_ce_dev *ce); int sl3516_ce_handle_cipher_request(struct crypto_engine *engine, void *areq);
Information contained on this website is for historical information purposes only and does not indicate or represent copyright ownership.
Created with Cregit http://github.com/cregit/cregit
Version 2.0-RC1