Author | Tokens | Token Proportion | Commits | Commit Proportion |
---|---|---|---|---|
Christopher Bostic | 223 | 43.81% | 2 | 11.11% |
Jeremy Kerr | 188 | 36.94% | 5 | 27.78% |
Benjamin Herrenschmidt | 63 | 12.38% | 7 | 38.89% |
Joel Stanley | 29 | 5.70% | 1 | 5.56% |
Edward A. James | 3 | 0.59% | 1 | 5.56% |
Thomas Gleixner | 2 | 0.39% | 1 | 5.56% |
Luo Xueqin | 1 | 0.20% | 1 | 5.56% |
Total | 509 | 18 |
/* SPDX-License-Identifier: GPL-2.0-only */ /* * FSI master definitions. These comprise the core <--> master interface, * to allow the core to interact with the (hardware-specific) masters. * * Copyright (C) IBM Corporation 2016 */ #ifndef DRIVERS_FSI_MASTER_H #define DRIVERS_FSI_MASTER_H #include <linux/device.h> #include <linux/mutex.h> /* * Master registers * * These are used by hardware masters, such as the one in the FSP2, AST2600 and * the hub master in POWER processors. */ /* Control Registers */ #define FSI_MMODE 0x0 /* R/W: mode */ #define FSI_MDLYR 0x4 /* R/W: delay */ #define FSI_MCRSP 0x8 /* R/W: clock rate */ #define FSI_MENP0 0x10 /* R/W: enable */ #define FSI_MLEVP0 0x18 /* R: plug detect */ #define FSI_MSENP0 0x18 /* S: Set enable */ #define FSI_MCENP0 0x20 /* C: Clear enable */ #define FSI_MAEB 0x70 /* R: Error address */ #define FSI_MVER 0x74 /* R: master version/type */ #define FSI_MSTAP0 0xd0 /* R: Port status */ #define FSI_MRESP0 0xd0 /* W: Port reset */ #define FSI_MESRB0 0x1d0 /* R: Master error status */ #define FSI_MRESB0 0x1d0 /* W: Reset bridge */ #define FSI_MSCSB0 0x1d4 /* R: Master sub command stack */ #define FSI_MATRB0 0x1d8 /* R: Master address trace */ #define FSI_MDTRB0 0x1dc /* R: Master data trace */ #define FSI_MECTRL 0x2e0 /* W: Error control */ /* MMODE: Mode control */ #define FSI_MMODE_EIP 0x80000000 /* Enable interrupt polling */ #define FSI_MMODE_ECRC 0x40000000 /* Enable error recovery */ #define FSI_MMODE_RELA 0x20000000 /* Enable relative address commands */ #define FSI_MMODE_EPC 0x10000000 /* Enable parity checking */ #define FSI_MMODE_P8_TO_LSB 0x00000010 /* Timeout value LSB */ /* MSB=1, LSB=0 is 0.8 ms */ /* MSB=0, LSB=1 is 0.9 ms */ #define FSI_MMODE_CRS0SHFT 18 /* Clk rate selection 0 shift */ #define FSI_MMODE_CRS0MASK 0x3ff /* Clk rate selection 0 mask */ #define FSI_MMODE_CRS1SHFT 8 /* Clk rate selection 1 shift */ #define FSI_MMODE_CRS1MASK 0x3ff /* Clk rate selection 1 mask */ /* MRESB: Reset bridge */ #define FSI_MRESB_RST_GEN 0x80000000 /* General reset */ #define FSI_MRESB_RST_ERR 0x40000000 /* Error Reset */ /* MRESP: Reset port */ #define FSI_MRESP_RST_ALL_MASTER 0x20000000 /* Reset all FSI masters */ #define FSI_MRESP_RST_ALL_LINK 0x10000000 /* Reset all FSI port contr. */ #define FSI_MRESP_RST_MCR 0x08000000 /* Reset FSI master reg. */ #define FSI_MRESP_RST_PYE 0x04000000 /* Reset FSI parity error */ #define FSI_MRESP_RST_ALL 0xfc000000 /* Reset any error */ /* MECTRL: Error control */ #define FSI_MECTRL_EOAE 0x8000 /* Enable machine check when */ /* master 0 in error */ #define FSI_MECTRL_P8_AUTO_TERM 0x4000 /* Auto terminate */ #define FSI_HUB_LINK_OFFSET 0x80000 #define FSI_HUB_LINK_SIZE 0x80000 #define FSI_HUB_MASTER_MAX_LINKS 8 /* * Protocol definitions * * These are used by low level masters that bit-bang out the protocol */ /* Various protocol delays */ #define FSI_ECHO_DELAY_CLOCKS 16 /* Number clocks for echo delay */ #define FSI_SEND_DELAY_CLOCKS 16 /* Number clocks for send delay */ #define FSI_PRE_BREAK_CLOCKS 50 /* Number clocks to prep for break */ #define FSI_BREAK_CLOCKS 256 /* Number of clocks to issue break */ #define FSI_POST_BREAK_CLOCKS 16000 /* Number clocks to set up cfam */ #define FSI_INIT_CLOCKS 5000 /* Clock out any old data */ #define FSI_MASTER_DPOLL_CLOCKS 50 /* < 21 will cause slave to hang */ #define FSI_MASTER_EPOLL_CLOCKS 50 /* Number of clocks for E_POLL retry */ /* Various retry maximums */ #define FSI_CRC_ERR_RETRIES 10 #define FSI_MASTER_MAX_BUSY 200 #define FSI_MASTER_MTOE_COUNT 1000 /* Command encodings */ #define FSI_CMD_DPOLL 0x2 #define FSI_CMD_EPOLL 0x3 #define FSI_CMD_TERM 0x3f #define FSI_CMD_ABS_AR 0x4 #define FSI_CMD_REL_AR 0x5 #define FSI_CMD_SAME_AR 0x3 /* but only a 2-bit opcode... */ /* Slave responses */ #define FSI_RESP_ACK 0 /* Success */ #define FSI_RESP_BUSY 1 /* Slave busy */ #define FSI_RESP_ERRA 2 /* Any (misc) Error */ #define FSI_RESP_ERRC 3 /* Slave reports master CRC error */ /* Misc */ #define FSI_CRC_SIZE 4 /* fsi-master definition and flags */ #define FSI_MASTER_FLAG_SWCLOCK 0x1 /* * Structures and function prototypes * * These are common to all masters */ struct fsi_master { struct device dev; int idx; int n_links; int flags; struct mutex scan_lock; int (*read)(struct fsi_master *, int link, uint8_t id, uint32_t addr, void *val, size_t size); int (*write)(struct fsi_master *, int link, uint8_t id, uint32_t addr, const void *val, size_t size); int (*term)(struct fsi_master *, int link, uint8_t id); int (*send_break)(struct fsi_master *, int link); int (*link_enable)(struct fsi_master *, int link, bool enable); int (*link_config)(struct fsi_master *, int link, u8 t_send_delay, u8 t_echo_delay); }; #define dev_to_fsi_master(d) container_of(d, struct fsi_master, dev) /** * fsi_master registration & lifetime: the fsi_master_register() and * fsi_master_unregister() functions will take ownership of the master, and * ->dev in particular. The registration path performs a get_device(), which * takes the first reference on the device. Similarly, the unregistration path * performs a put_device(), which may well drop the last reference. * * This means that master implementations *may* need to hold their own * reference (via get_device()) on master->dev. In particular, if the device's * ->release callback frees the fsi_master, then fsi_master_unregister will * invoke this free if no other reference is held. * * The same applies for the error path of fsi_master_register; if the call * fails, dev->release will have been invoked. */ extern int fsi_master_register(struct fsi_master *master); extern void fsi_master_unregister(struct fsi_master *master); extern int fsi_master_rescan(struct fsi_master *master); #endif /* DRIVERS_FSI_MASTER_H */
Information contained on this website is for historical information purposes only and does not indicate or represent copyright ownership.
Created with Cregit http://github.com/cregit/cregit
Version 2.0-RC1