Author | Tokens | Token Proportion | Commits | Commit Proportion |
---|---|---|---|---|
Serge Semin | 1270 | 98.76% | 3 | 42.86% |
Zhang Changzhong | 7 | 0.54% | 1 | 14.29% |
Kees Cook | 4 | 0.31% | 1 | 14.29% |
Tian Tao | 3 | 0.23% | 1 | 14.29% |
Qilong Zhang | 2 | 0.16% | 1 | 14.29% |
Total | 1286 | 7 |
// SPDX-License-Identifier: GPL-2.0-only // // Copyright (C) 2020 BAIKAL ELECTRONICS, JSC // // Authors: // Ramil Zaripov <Ramil.Zaripov@baikalelectronics.ru> // Serge Semin <Sergey.Semin@baikalelectronics.ru> // // Baikal-T1 DW APB SPI and System Boot SPI driver // #include <linux/clk.h> #include <linux/cpumask.h> #include <linux/err.h> #include <linux/interrupt.h> #include <linux/module.h> #include <linux/mux/consumer.h> #include <linux/of.h> #include <linux/of_platform.h> #include <linux/platform_device.h> #include <linux/pm_runtime.h> #include <linux/property.h> #include <linux/slab.h> #include <linux/spi/spi-mem.h> #include <linux/spi/spi.h> #include "spi-dw.h" #define BT1_BOOT_DIRMAP 0 #define BT1_BOOT_REGS 1 struct dw_spi_bt1 { struct dw_spi dws; struct clk *clk; struct mux_control *mux; #ifdef CONFIG_SPI_DW_BT1_DIRMAP void __iomem *map; resource_size_t map_len; #endif }; #define to_dw_spi_bt1(_ctlr) \ container_of(spi_controller_get_devdata(_ctlr), struct dw_spi_bt1, dws) typedef int (*dw_spi_bt1_init_cb)(struct platform_device *pdev, struct dw_spi_bt1 *dwsbt1); #ifdef CONFIG_SPI_DW_BT1_DIRMAP static int dw_spi_bt1_dirmap_create(struct spi_mem_dirmap_desc *desc) { struct dw_spi_bt1 *dwsbt1 = to_dw_spi_bt1(desc->mem->spi->controller); if (!dwsbt1->map || !dwsbt1->dws.mem_ops.supports_op(desc->mem, &desc->info.op_tmpl)) return -EOPNOTSUPP; /* * Make sure the requested region doesn't go out of the physically * mapped flash memory bounds and the operation is read-only. */ if (desc->info.offset + desc->info.length > dwsbt1->map_len || desc->info.op_tmpl.data.dir != SPI_MEM_DATA_IN) return -EOPNOTSUPP; return 0; } /* * Directly mapped SPI memory region is only accessible in the dword chunks. * That's why we have to create a dedicated read-method to copy data from there * to the passed buffer. */ static void dw_spi_bt1_dirmap_copy_from_map(void *to, void __iomem *from, size_t len) { size_t shift, chunk; u32 data; /* * We split the copying up into the next three stages: unaligned head, * aligned body, unaligned tail. */ shift = (size_t)from & 0x3; if (shift) { chunk = min_t(size_t, 4 - shift, len); data = readl_relaxed(from - shift); memcpy(to, (char *)&data + shift, chunk); from += chunk; to += chunk; len -= chunk; } while (len >= 4) { data = readl_relaxed(from); memcpy(to, &data, 4); from += 4; to += 4; len -= 4; } if (len) { data = readl_relaxed(from); memcpy(to, &data, len); } } static ssize_t dw_spi_bt1_dirmap_read(struct spi_mem_dirmap_desc *desc, u64 offs, size_t len, void *buf) { struct dw_spi_bt1 *dwsbt1 = to_dw_spi_bt1(desc->mem->spi->controller); struct dw_spi *dws = &dwsbt1->dws; struct spi_mem *mem = desc->mem; struct dw_spi_cfg cfg; int ret; /* * Make sure the requested operation length is valid. Truncate the * length if it's greater than the length of the MMIO region. */ if (offs >= dwsbt1->map_len || !len) return 0; len = min_t(size_t, len, dwsbt1->map_len - offs); /* Collect the controller configuration required by the operation */ cfg.tmode = DW_SPI_CTRLR0_TMOD_EPROMREAD; cfg.dfs = 8; cfg.ndf = 4; cfg.freq = mem->spi->max_speed_hz; /* Make sure the corresponding CS is de-asserted on transmission */ dw_spi_set_cs(mem->spi, false); dw_spi_enable_chip(dws, 0); dw_spi_update_config(dws, mem->spi, &cfg); dw_spi_umask_intr(dws, DW_SPI_INT_RXFI); dw_spi_enable_chip(dws, 1); /* * Enable the transparent mode of the System Boot Controller. * The SPI core IO should have been locked before calling this method * so noone would be touching the controller' registers during the * dirmap operation. */ ret = mux_control_select(dwsbt1->mux, BT1_BOOT_DIRMAP); if (ret) return ret; dw_spi_bt1_dirmap_copy_from_map(buf, dwsbt1->map + offs, len); mux_control_deselect(dwsbt1->mux); dw_spi_set_cs(mem->spi, true); ret = dw_spi_check_status(dws, true); return ret ?: len; } #endif /* CONFIG_SPI_DW_BT1_DIRMAP */ static int dw_spi_bt1_std_init(struct platform_device *pdev, struct dw_spi_bt1 *dwsbt1) { struct dw_spi *dws = &dwsbt1->dws; dws->irq = platform_get_irq(pdev, 0); if (dws->irq < 0) return dws->irq; dws->num_cs = 4; /* * Baikal-T1 Normal SPI Controllers don't always keep up with full SPI * bus speed especially when it comes to the concurrent access to the * APB bus resources. Thus we have no choice but to set a constraint on * the SPI bus frequency for the memory operations which require to * read/write data as fast as possible. */ dws->max_mem_freq = 20000000U; dw_spi_dma_setup_generic(dws); return 0; } static int dw_spi_bt1_sys_init(struct platform_device *pdev, struct dw_spi_bt1 *dwsbt1) { struct resource *mem __maybe_unused; struct dw_spi *dws = &dwsbt1->dws; /* * Baikal-T1 System Boot Controller is equipped with a mux, which * switches between the directly mapped SPI flash access mode and * IO access to the DW APB SSI registers. Note the mux controller * must be setup to preserve the registers being accessible by default * (on idle-state). */ dwsbt1->mux = devm_mux_control_get(&pdev->dev, NULL); if (IS_ERR(dwsbt1->mux)) return PTR_ERR(dwsbt1->mux); /* * Directly mapped SPI flash memory is a 16MB MMIO region, which can be * used to access a peripheral memory device just by reading/writing * data from/to it. Note the system APB bus will stall during each IO * from/to the dirmap region until the operation is finished. So don't * use it concurrently with time-critical tasks (like the SPI memory * operations implemented in the DW APB SSI driver). */ #ifdef CONFIG_SPI_DW_BT1_DIRMAP mem = platform_get_resource(pdev, IORESOURCE_MEM, 1); if (mem) { dwsbt1->map = devm_ioremap_resource(&pdev->dev, mem); if (!IS_ERR(dwsbt1->map)) { dwsbt1->map_len = resource_size(mem); dws->mem_ops.dirmap_create = dw_spi_bt1_dirmap_create; dws->mem_ops.dirmap_read = dw_spi_bt1_dirmap_read; } else { dwsbt1->map = NULL; } } #endif /* CONFIG_SPI_DW_BT1_DIRMAP */ /* * There is no IRQ, no DMA and just one CS available on the System Boot * SPI controller. */ dws->irq = IRQ_NOTCONNECTED; dws->num_cs = 1; /* * Baikal-T1 System Boot SPI Controller doesn't keep up with the full * SPI bus speed due to relatively slow APB bus and races for it' * resources from different CPUs. The situation is worsen by a small * FIFOs depth (just 8 words). It works better in a single CPU mode * though, but still tends to be not fast enough at low CPU * frequencies. */ if (num_possible_cpus() > 1) dws->max_mem_freq = 10000000U; else dws->max_mem_freq = 20000000U; return 0; } static int dw_spi_bt1_probe(struct platform_device *pdev) { dw_spi_bt1_init_cb init_func; struct dw_spi_bt1 *dwsbt1; struct resource *mem; struct dw_spi *dws; int ret; dwsbt1 = devm_kzalloc(&pdev->dev, sizeof(struct dw_spi_bt1), GFP_KERNEL); if (!dwsbt1) return -ENOMEM; dws = &dwsbt1->dws; dws->regs = devm_platform_get_and_ioremap_resource(pdev, 0, &mem); if (IS_ERR(dws->regs)) return PTR_ERR(dws->regs); dws->paddr = mem->start; dwsbt1->clk = devm_clk_get(&pdev->dev, NULL); if (IS_ERR(dwsbt1->clk)) return PTR_ERR(dwsbt1->clk); ret = clk_prepare_enable(dwsbt1->clk); if (ret) return ret; dws->bus_num = pdev->id; dws->reg_io_width = 4; dws->max_freq = clk_get_rate(dwsbt1->clk); if (!dws->max_freq) { ret = -EINVAL; goto err_disable_clk; } init_func = device_get_match_data(&pdev->dev); ret = init_func(pdev, dwsbt1); if (ret) goto err_disable_clk; pm_runtime_enable(&pdev->dev); ret = dw_spi_add_host(&pdev->dev, dws); if (ret) { pm_runtime_disable(&pdev->dev); goto err_disable_clk; } platform_set_drvdata(pdev, dwsbt1); return 0; err_disable_clk: clk_disable_unprepare(dwsbt1->clk); return ret; } static int dw_spi_bt1_remove(struct platform_device *pdev) { struct dw_spi_bt1 *dwsbt1 = platform_get_drvdata(pdev); dw_spi_remove_host(&dwsbt1->dws); pm_runtime_disable(&pdev->dev); clk_disable_unprepare(dwsbt1->clk); return 0; } static const struct of_device_id dw_spi_bt1_of_match[] = { { .compatible = "baikal,bt1-ssi", .data = dw_spi_bt1_std_init}, { .compatible = "baikal,bt1-sys-ssi", .data = dw_spi_bt1_sys_init}, { } }; MODULE_DEVICE_TABLE(of, dw_spi_bt1_of_match); static struct platform_driver dw_spi_bt1_driver = { .probe = dw_spi_bt1_probe, .remove = dw_spi_bt1_remove, .driver = { .name = "bt1-sys-ssi", .of_match_table = dw_spi_bt1_of_match, }, }; module_platform_driver(dw_spi_bt1_driver); MODULE_AUTHOR("Serge Semin <Sergey.Semin@baikalelectronics.ru>"); MODULE_DESCRIPTION("Baikal-T1 System Boot SPI Controller driver"); MODULE_LICENSE("GPL v2"); MODULE_IMPORT_NS(SPI_DW_CORE);
Information contained on this website is for historical information purposes only and does not indicate or represent copyright ownership.
Created with Cregit http://github.com/cregit/cregit
Version 2.0-RC1