Author | Tokens | Token Proportion | Commits | Commit Proportion |
---|---|---|---|---|
Christophe Branchereau | 1659 | 100.00% | 1 | 100.00% |
Total | 1659 | 1 |
// SPDX-License-Identifier: GPL-2.0 /* * Orisetech OTA5601A TFT LCD panel driver * * Copyright (C) 2021, Christophe Branchereau <cbranchereau@gmail.com> */ #include <linux/bits.h> #include <linux/delay.h> #include <linux/device.h> #include <linux/gpio/consumer.h> #include <linux/media-bus-format.h> #include <linux/module.h> #include <linux/of.h> #include <linux/of_device.h> #include <linux/regmap.h> #include <linux/regulator/consumer.h> #include <linux/spi/spi.h> #include <drm/drm_modes.h> #include <drm/drm_panel.h> #define OTA5601A_CTL 0x01 #define OTA5601A_CTL_OFF 0x00 #define OTA5601A_CTL_ON BIT(0) struct ota5601a_panel_info { const struct drm_display_mode *display_modes; unsigned int num_modes; u16 width_mm, height_mm; u32 bus_format, bus_flags; }; struct ota5601a { struct drm_panel drm_panel; struct regmap *map; struct regulator *supply; const struct ota5601a_panel_info *panel_info; struct gpio_desc *reset_gpio; }; static inline struct ota5601a *to_ota5601a(struct drm_panel *panel) { return container_of(panel, struct ota5601a, drm_panel); } static const struct reg_sequence ota5601a_panel_regs[] = { { 0xfd, 0x00 }, /* Page Shift */ { 0x02, 0x00 }, /* Reset */ { 0x18, 0x00 }, /* Interface Sel: RGB 24 Bits */ { 0x34, 0x20 }, /* Undocumented */ { 0x0c, 0x01 }, /* Contrast set by CMD1 == within page 0x00 */ { 0x0d, 0x48 }, /* R Brightness */ { 0x0e, 0x48 }, /* G Brightness */ { 0x0f, 0x48 }, /* B Brightness */ { 0x07, 0x40 }, /* R Contrast */ { 0x08, 0x33 }, /* G Contrast */ { 0x09, 0x3a }, /* B Contrast */ { 0x16, 0x01 }, /* NTSC Sel */ { 0x19, 0x8d }, /* VBLK */ { 0x1a, 0x28 }, /* HBLK */ { 0x1c, 0x00 }, /* Scan Shift Dir. */ { 0xfd, 0xc5 }, /* Page Shift */ { 0x82, 0x0c }, /* PWR_CTRL Pump */ { 0xa2, 0xb4 }, /* PWR_CTRL VGH/VGL */ { 0xfd, 0xc4 }, /* Page Shift - What follows is listed as "RGB 24bit Timing Set" */ { 0x82, 0x45 }, { 0xfd, 0xc1 }, { 0x91, 0x02 }, { 0xfd, 0xc0 }, { 0xa1, 0x01 }, { 0xa2, 0x1f }, { 0xa3, 0x0b }, { 0xa4, 0x38 }, { 0xa5, 0x00 }, { 0xa6, 0x0a }, { 0xa7, 0x38 }, { 0xa8, 0x00 }, { 0xa9, 0x0a }, { 0xaa, 0x37 }, { 0xfd, 0xce }, { 0x81, 0x18 }, { 0x82, 0x43 }, { 0x83, 0x43 }, { 0x91, 0x06 }, { 0x93, 0x38 }, { 0x94, 0x02 }, { 0x95, 0x06 }, { 0x97, 0x38 }, { 0x98, 0x02 }, { 0x99, 0x06 }, { 0x9b, 0x38 }, { 0x9c, 0x02 }, { 0xfd, 0x00 }, /* Page Shift */ }; static const struct regmap_config ota5601a_regmap_config = { .reg_bits = 8, .val_bits = 8, }; static int ota5601a_prepare(struct drm_panel *drm_panel) { struct ota5601a *panel = to_ota5601a(drm_panel); int err; err = regulator_enable(panel->supply); if (err) { dev_err(drm_panel->dev, "Failed to enable power supply: %d\n", err); return err; } /* Reset to be held low for 10us min according to the doc, 10ms before sending commands */ gpiod_set_value_cansleep(panel->reset_gpio, 1); usleep_range(10, 30); gpiod_set_value_cansleep(panel->reset_gpio, 0); usleep_range(10000, 20000); /* Init all registers. */ err = regmap_multi_reg_write(panel->map, ota5601a_panel_regs, ARRAY_SIZE(ota5601a_panel_regs)); if (err) { dev_err(drm_panel->dev, "Failed to init registers: %d\n", err); goto err_disable_regulator; } msleep(120); return 0; err_disable_regulator: regulator_disable(panel->supply); return err; } static int ota5601a_unprepare(struct drm_panel *drm_panel) { struct ota5601a *panel = to_ota5601a(drm_panel); gpiod_set_value_cansleep(panel->reset_gpio, 1); regulator_disable(panel->supply); return 0; } static int ota5601a_enable(struct drm_panel *drm_panel) { struct ota5601a *panel = to_ota5601a(drm_panel); int err; err = regmap_write(panel->map, OTA5601A_CTL, OTA5601A_CTL_ON); if (err) { dev_err(drm_panel->dev, "Unable to enable panel: %d\n", err); return err; } if (drm_panel->backlight) { /* Wait for the picture to be ready before enabling backlight */ msleep(120); } return 0; } static int ota5601a_disable(struct drm_panel *drm_panel) { struct ota5601a *panel = to_ota5601a(drm_panel); int err; err = regmap_write(panel->map, OTA5601A_CTL, OTA5601A_CTL_OFF); if (err) { dev_err(drm_panel->dev, "Unable to disable panel: %d\n", err); return err; } return 0; } static int ota5601a_get_modes(struct drm_panel *drm_panel, struct drm_connector *connector) { struct ota5601a *panel = to_ota5601a(drm_panel); const struct ota5601a_panel_info *panel_info = panel->panel_info; struct drm_display_mode *mode; unsigned int i; for (i = 0; i < panel_info->num_modes; i++) { mode = drm_mode_duplicate(connector->dev, &panel_info->display_modes[i]); if (!mode) return -ENOMEM; drm_mode_set_name(mode); mode->type = DRM_MODE_TYPE_DRIVER; if (panel_info->num_modes == 1) mode->type |= DRM_MODE_TYPE_PREFERRED; drm_mode_probed_add(connector, mode); } connector->display_info.bpc = 8; connector->display_info.width_mm = panel_info->width_mm; connector->display_info.height_mm = panel_info->height_mm; drm_display_info_set_bus_formats(&connector->display_info, &panel_info->bus_format, 1); connector->display_info.bus_flags = panel_info->bus_flags; return panel_info->num_modes; } static const struct drm_panel_funcs ota5601a_funcs = { .prepare = ota5601a_prepare, .unprepare = ota5601a_unprepare, .enable = ota5601a_enable, .disable = ota5601a_disable, .get_modes = ota5601a_get_modes, }; static int ota5601a_probe(struct spi_device *spi) { const struct spi_device_id *id = spi_get_device_id(spi); struct device *dev = &spi->dev; struct ota5601a *panel; int err; panel = devm_kzalloc(dev, sizeof(*panel), GFP_KERNEL); if (!panel) return -ENOMEM; spi_set_drvdata(spi, panel); panel->panel_info = (const struct ota5601a_panel_info *)id->driver_data; if (!panel->panel_info) return -EINVAL; panel->supply = devm_regulator_get(dev, "power"); if (IS_ERR(panel->supply)) { dev_err(dev, "Failed to get power supply\n"); return PTR_ERR(panel->supply); } panel->reset_gpio = devm_gpiod_get(dev, "reset", GPIOD_OUT_HIGH); if (IS_ERR(panel->reset_gpio)) { dev_err(dev, "Failed to get reset GPIO\n"); return PTR_ERR(panel->reset_gpio); } spi->bits_per_word = 8; spi->mode = SPI_MODE_3 | SPI_3WIRE; err = spi_setup(spi); if (err) { dev_err(dev, "Failed to setup SPI\n"); return err; } panel->map = devm_regmap_init_spi(spi, &ota5601a_regmap_config); if (IS_ERR(panel->map)) { dev_err(dev, "Failed to init regmap\n"); return PTR_ERR(panel->map); } drm_panel_init(&panel->drm_panel, dev, &ota5601a_funcs, DRM_MODE_CONNECTOR_DPI); err = drm_panel_of_backlight(&panel->drm_panel); if (err) { if (err != -EPROBE_DEFER) dev_err(dev, "Failed to get backlight handle\n"); return err; } drm_panel_add(&panel->drm_panel); return 0; } static void ota5601a_remove(struct spi_device *spi) { struct ota5601a *panel = spi_get_drvdata(spi); drm_panel_remove(&panel->drm_panel); ota5601a_disable(&panel->drm_panel); ota5601a_unprepare(&panel->drm_panel); } static const struct drm_display_mode gpt3_display_modes[] = { { /* 60 Hz */ .clock = 27000, .hdisplay = 640, .hsync_start = 640 + 220, .hsync_end = 640 + 220 + 20, .htotal = 640 + 220 + 20 + 20, .vdisplay = 480, .vsync_start = 480 + 7, .vsync_end = 480 + 7 + 6, .vtotal = 480 + 7 + 6 + 7, .flags = DRM_MODE_FLAG_NHSYNC | DRM_MODE_FLAG_NVSYNC, }, { /* 50 Hz */ .clock = 24000, .hdisplay = 640, .hsync_start = 640 + 280, .hsync_end = 640 + 280 + 20, .htotal = 640 + 280 + 20 + 20, .vdisplay = 480, .vsync_start = 480 + 7, .vsync_end = 480 + 7 + 6, .vtotal = 480 + 7 + 6 + 7, .flags = DRM_MODE_FLAG_NHSYNC | DRM_MODE_FLAG_NVSYNC, }, }; static const struct ota5601a_panel_info gpt3_info = { .display_modes = gpt3_display_modes, .num_modes = ARRAY_SIZE(gpt3_display_modes), .width_mm = 71, .height_mm = 51, .bus_format = MEDIA_BUS_FMT_RGB888_1X24, .bus_flags = DRM_BUS_FLAG_PIXDATA_SAMPLE_POSEDGE, }; static const struct spi_device_id gpt3_id[] = { { "gpt3", (kernel_ulong_t)&gpt3_info }, { /* sentinel */ } }; MODULE_DEVICE_TABLE(spi, gpt3_id); static const struct of_device_id ota5601a_of_match[] = { { .compatible = "focaltech,gpt3" }, { /* sentinel */ } }; MODULE_DEVICE_TABLE(of, ota5601a_of_match); static struct spi_driver ota5601a_driver = { .driver = { .name = "ota5601a", .of_match_table = ota5601a_of_match, }, .id_table = gpt3_id, .probe = ota5601a_probe, .remove = ota5601a_remove, }; module_spi_driver(ota5601a_driver); MODULE_AUTHOR("Christophe Branchereau <cbranchereau@gmail.com>"); MODULE_LICENSE("GPL");
Information contained on this website is for historical information purposes only and does not indicate or represent copyright ownership.
Created with Cregit http://github.com/cregit/cregit
Version 2.0-RC1