| Author | Tokens | Token Proportion | Commits | Commit Proportion |
|---|---|---|---|---|
| Daniel Golle | 1018 | 96.68% | 2 | 66.67% |
| Russell King | 35 | 3.32% | 1 | 33.33% |
| Total | 1053 | 3 |
// SPDX-License-Identifier: GPL-2.0 // Copyright (c) 2018-2019 MediaTek Inc. /* A library for MediaTek SGMII circuit * * Author: Sean Wang <sean.wang@mediatek.com> * Author: Alexander Couzens <lynxis@fe80.eu> * Author: Daniel Golle <daniel@makrotopia.org> * */ #include <linux/mdio.h> #include <linux/of.h> #include <linux/pcs/pcs-mtk-lynxi.h> #include <linux/phylink.h> #include <linux/regmap.h> /* SGMII subsystem config registers */ /* BMCR (low 16) BMSR (high 16) */ #define SGMSYS_PCS_CONTROL_1 0x0 #define SGMII_BMCR GENMASK(15, 0) #define SGMII_BMSR GENMASK(31, 16) #define SGMSYS_PCS_DEVICE_ID 0x4 #define SGMII_LYNXI_DEV_ID 0x4d544950 #define SGMSYS_PCS_ADVERTISE 0x8 #define SGMII_ADVERTISE GENMASK(15, 0) #define SGMII_LPA GENMASK(31, 16) #define SGMSYS_PCS_SCRATCH 0x14 #define SGMII_DEV_VERSION GENMASK(31, 16) /* Register to programmable link timer, the unit in 2 * 8ns */ #define SGMSYS_PCS_LINK_TIMER 0x18 #define SGMII_LINK_TIMER_MASK GENMASK(19, 0) #define SGMII_LINK_TIMER_VAL(ns) FIELD_PREP(SGMII_LINK_TIMER_MASK, \ ((ns) / 2 / 8)) /* Register to control remote fault */ #define SGMSYS_SGMII_MODE 0x20 #define SGMII_IF_MODE_SGMII BIT(0) #define SGMII_SPEED_DUPLEX_AN BIT(1) #define SGMII_SPEED_MASK GENMASK(3, 2) #define SGMII_SPEED_10 FIELD_PREP(SGMII_SPEED_MASK, 0) #define SGMII_SPEED_100 FIELD_PREP(SGMII_SPEED_MASK, 1) #define SGMII_SPEED_1000 FIELD_PREP(SGMII_SPEED_MASK, 2) #define SGMII_DUPLEX_HALF BIT(4) #define SGMII_REMOTE_FAULT_DIS BIT(8) /* Register to reset SGMII design */ #define SGMSYS_RESERVED_0 0x34 #define SGMII_SW_RESET BIT(0) /* Register to set SGMII speed, ANA RG_ Control Signals III */ #define SGMII_PHY_SPEED_MASK GENMASK(3, 2) #define SGMII_PHY_SPEED_1_25G FIELD_PREP(SGMII_PHY_SPEED_MASK, 0) #define SGMII_PHY_SPEED_3_125G FIELD_PREP(SGMII_PHY_SPEED_MASK, 1) /* Register to power up QPHY */ #define SGMSYS_QPHY_PWR_STATE_CTRL 0xe8 #define SGMII_PHYA_PWD BIT(4) /* Register to QPHY wrapper control */ #define SGMSYS_QPHY_WRAP_CTRL 0xec #define SGMII_PN_SWAP_MASK GENMASK(1, 0) #define SGMII_PN_SWAP_TX_RX (BIT(0) | BIT(1)) /* struct mtk_pcs_lynxi - This structure holds each sgmii regmap andassociated * data * @regmap: The register map pointing at the range used to setup * SGMII modes * @dev: Pointer to device owning the PCS * @ana_rgc3: The offset of register ANA_RGC3 relative to regmap * @interface: Currently configured interface mode * @pcs: Phylink PCS structure * @flags: Flags indicating hardware properties */ struct mtk_pcs_lynxi { struct regmap *regmap; u32 ana_rgc3; phy_interface_t interface; struct phylink_pcs pcs; u32 flags; }; static struct mtk_pcs_lynxi *pcs_to_mtk_pcs_lynxi(struct phylink_pcs *pcs) { return container_of(pcs, struct mtk_pcs_lynxi, pcs); } static void mtk_pcs_lynxi_get_state(struct phylink_pcs *pcs, struct phylink_link_state *state) { struct mtk_pcs_lynxi *mpcs = pcs_to_mtk_pcs_lynxi(pcs); unsigned int bm, adv; /* Read the BMSR and LPA */ regmap_read(mpcs->regmap, SGMSYS_PCS_CONTROL_1, &bm); regmap_read(mpcs->regmap, SGMSYS_PCS_ADVERTISE, &adv); phylink_mii_c22_pcs_decode_state(state, FIELD_GET(SGMII_BMSR, bm), FIELD_GET(SGMII_LPA, adv)); } static int mtk_pcs_lynxi_config(struct phylink_pcs *pcs, unsigned int neg_mode, phy_interface_t interface, const unsigned long *advertising, bool permit_pause_to_mac) { struct mtk_pcs_lynxi *mpcs = pcs_to_mtk_pcs_lynxi(pcs); bool mode_changed = false, changed; unsigned int rgc3, sgm_mode, bmcr; int advertise, link_timer; advertise = phylink_mii_c22_pcs_encode_advertisement(interface, advertising); if (advertise < 0) return advertise; /* Clearing IF_MODE_BIT0 switches the PCS to BASE-X mode, and * we assume that fixes it's speed at bitrate = line rate (in * other words, 1000Mbps or 2500Mbps). */ if (interface == PHY_INTERFACE_MODE_SGMII) sgm_mode = SGMII_IF_MODE_SGMII; else sgm_mode = 0; if (neg_mode & PHYLINK_PCS_NEG_INBAND) sgm_mode |= SGMII_REMOTE_FAULT_DIS; if (neg_mode == PHYLINK_PCS_NEG_INBAND_ENABLED) { if (interface == PHY_INTERFACE_MODE_SGMII) sgm_mode |= SGMII_SPEED_DUPLEX_AN; bmcr = BMCR_ANENABLE; } else { bmcr = 0; } if (mpcs->interface != interface) { link_timer = phylink_get_link_timer_ns(interface); if (link_timer < 0) return link_timer; /* PHYA power down */ regmap_set_bits(mpcs->regmap, SGMSYS_QPHY_PWR_STATE_CTRL, SGMII_PHYA_PWD); /* Reset SGMII PCS state */ regmap_set_bits(mpcs->regmap, SGMSYS_RESERVED_0, SGMII_SW_RESET); if (mpcs->flags & MTK_SGMII_FLAG_PN_SWAP) regmap_update_bits(mpcs->regmap, SGMSYS_QPHY_WRAP_CTRL, SGMII_PN_SWAP_MASK, SGMII_PN_SWAP_TX_RX); if (interface == PHY_INTERFACE_MODE_2500BASEX) rgc3 = SGMII_PHY_SPEED_3_125G; else rgc3 = SGMII_PHY_SPEED_1_25G; /* Configure the underlying interface speed */ regmap_update_bits(mpcs->regmap, mpcs->ana_rgc3, SGMII_PHY_SPEED_MASK, rgc3); /* Setup the link timer */ regmap_write(mpcs->regmap, SGMSYS_PCS_LINK_TIMER, SGMII_LINK_TIMER_VAL(link_timer)); mpcs->interface = interface; mode_changed = true; } /* Update the advertisement, noting whether it has changed */ regmap_update_bits_check(mpcs->regmap, SGMSYS_PCS_ADVERTISE, SGMII_ADVERTISE, advertise, &changed); /* Update the sgmsys mode register */ regmap_update_bits(mpcs->regmap, SGMSYS_SGMII_MODE, SGMII_REMOTE_FAULT_DIS | SGMII_SPEED_DUPLEX_AN | SGMII_IF_MODE_SGMII, sgm_mode); /* Update the BMCR */ regmap_update_bits(mpcs->regmap, SGMSYS_PCS_CONTROL_1, BMCR_ANENABLE, bmcr); /* Release PHYA power down state * Only removing bit SGMII_PHYA_PWD isn't enough. * There are cases when the SGMII_PHYA_PWD register contains 0x9 which * prevents SGMII from working. The SGMII still shows link but no traffic * can flow. Writing 0x0 to the PHYA_PWD register fix the issue. 0x0 was * taken from a good working state of the SGMII interface. * Unknown how much the QPHY needs but it is racy without a sleep. * Tested on mt7622 & mt7986. */ usleep_range(50, 100); regmap_write(mpcs->regmap, SGMSYS_QPHY_PWR_STATE_CTRL, 0); return changed || mode_changed; } static void mtk_pcs_lynxi_restart_an(struct phylink_pcs *pcs) { struct mtk_pcs_lynxi *mpcs = pcs_to_mtk_pcs_lynxi(pcs); regmap_set_bits(mpcs->regmap, SGMSYS_PCS_CONTROL_1, BMCR_ANRESTART); } static void mtk_pcs_lynxi_link_up(struct phylink_pcs *pcs, unsigned int neg_mode, phy_interface_t interface, int speed, int duplex) { struct mtk_pcs_lynxi *mpcs = pcs_to_mtk_pcs_lynxi(pcs); unsigned int sgm_mode; if (neg_mode != PHYLINK_PCS_NEG_INBAND_ENABLED) { /* Force the speed and duplex setting */ if (speed == SPEED_10) sgm_mode = SGMII_SPEED_10; else if (speed == SPEED_100) sgm_mode = SGMII_SPEED_100; else sgm_mode = SGMII_SPEED_1000; if (duplex != DUPLEX_FULL) sgm_mode |= SGMII_DUPLEX_HALF; regmap_update_bits(mpcs->regmap, SGMSYS_SGMII_MODE, SGMII_DUPLEX_HALF | SGMII_SPEED_MASK, sgm_mode); } } static void mtk_pcs_lynxi_disable(struct phylink_pcs *pcs) { struct mtk_pcs_lynxi *mpcs = pcs_to_mtk_pcs_lynxi(pcs); mpcs->interface = PHY_INTERFACE_MODE_NA; } static const struct phylink_pcs_ops mtk_pcs_lynxi_ops = { .pcs_get_state = mtk_pcs_lynxi_get_state, .pcs_config = mtk_pcs_lynxi_config, .pcs_an_restart = mtk_pcs_lynxi_restart_an, .pcs_link_up = mtk_pcs_lynxi_link_up, .pcs_disable = mtk_pcs_lynxi_disable, }; struct phylink_pcs *mtk_pcs_lynxi_create(struct device *dev, struct regmap *regmap, u32 ana_rgc3, u32 flags) { struct mtk_pcs_lynxi *mpcs; u32 id, ver; int ret; ret = regmap_read(regmap, SGMSYS_PCS_DEVICE_ID, &id); if (ret < 0) return NULL; if (id != SGMII_LYNXI_DEV_ID) { dev_err(dev, "unknown PCS device id %08x\n", id); return NULL; } ret = regmap_read(regmap, SGMSYS_PCS_SCRATCH, &ver); if (ret < 0) return NULL; ver = FIELD_GET(SGMII_DEV_VERSION, ver); if (ver != 0x1) { dev_err(dev, "unknown PCS device version %04x\n", ver); return NULL; } dev_dbg(dev, "MediaTek LynxI SGMII PCS (id 0x%08x, ver 0x%04x)\n", id, ver); mpcs = kzalloc(sizeof(*mpcs), GFP_KERNEL); if (!mpcs) return NULL; mpcs->ana_rgc3 = ana_rgc3; mpcs->regmap = regmap; mpcs->flags = flags; mpcs->pcs.ops = &mtk_pcs_lynxi_ops; mpcs->pcs.neg_mode = true; mpcs->pcs.poll = true; mpcs->interface = PHY_INTERFACE_MODE_NA; return &mpcs->pcs; } EXPORT_SYMBOL(mtk_pcs_lynxi_create); void mtk_pcs_lynxi_destroy(struct phylink_pcs *pcs) { if (!pcs) return; kfree(pcs_to_mtk_pcs_lynxi(pcs)); } EXPORT_SYMBOL(mtk_pcs_lynxi_destroy); MODULE_LICENSE("GPL");
Information contained on this website is for historical information purposes only and does not indicate or represent copyright ownership.
Created with Cregit http://github.com/cregit/cregit
Version 2.0-RC1