| Author | Tokens | Token Proportion | Commits | Commit Proportion |
|---|---|---|---|---|
| Yoshihiro Shimoda | 398 | 64.61% | 1 | 5.88% |
| Bastian Hecht | 175 | 28.41% | 8 | 47.06% |
| Magnus Damm | 13 | 2.11% | 2 | 11.76% |
| Wagner Ferenc | 13 | 2.11% | 1 | 5.88% |
| Peter Hüwe | 8 | 1.30% | 1 | 5.88% |
| Boris Brezillon | 5 | 0.81% | 2 | 11.76% |
| Arnd Bergmann | 3 | 0.49% | 1 | 5.88% |
| Kuninori Morimoto | 1 | 0.16% | 1 | 5.88% |
| Total | 616 | 17 |
/* SPDX-License-Identifier: GPL-2.0 * * SuperH FLCTL nand controller * * Copyright © 2008 Renesas Solutions Corp. */ #ifndef __SH_FLCTL_H__ #define __SH_FLCTL_H__ #include <linux/completion.h> #include <linux/mtd/mtd.h> #include <linux/mtd/rawnand.h> #include <linux/mtd/partitions.h> #include <linux/pm_qos.h> /* FLCTL registers */ #define FLCMNCR(f) (f->reg + 0x0) #define FLCMDCR(f) (f->reg + 0x4) #define FLCMCDR(f) (f->reg + 0x8) #define FLADR(f) (f->reg + 0xC) #define FLADR2(f) (f->reg + 0x3C) #define FLDATAR(f) (f->reg + 0x10) #define FLDTCNTR(f) (f->reg + 0x14) #define FLINTDMACR(f) (f->reg + 0x18) #define FLBSYTMR(f) (f->reg + 0x1C) #define FLBSYCNT(f) (f->reg + 0x20) #define FLDTFIFO(f) (f->reg + 0x24) #define FLECFIFO(f) (f->reg + 0x28) #define FLTRCR(f) (f->reg + 0x2C) #define FLHOLDCR(f) (f->reg + 0x38) #define FL4ECCRESULT0(f) (f->reg + 0x80) #define FL4ECCRESULT1(f) (f->reg + 0x84) #define FL4ECCRESULT2(f) (f->reg + 0x88) #define FL4ECCRESULT3(f) (f->reg + 0x8C) #define FL4ECCCR(f) (f->reg + 0x90) #define FL4ECCCNT(f) (f->reg + 0x94) #define FLERRADR(f) (f->reg + 0x98) /* FLCMNCR control bits */ #define _4ECCCNTEN (0x1 << 24) #define _4ECCEN (0x1 << 23) #define _4ECCCORRECT (0x1 << 22) #define SHBUSSEL (0x1 << 20) #define SEL_16BIT (0x1 << 19) #define SNAND_E (0x1 << 18) /* SNAND (0=512 1=2048)*/ #define QTSEL_E (0x1 << 17) #define ENDIAN (0x1 << 16) /* 1 = little endian */ #define FCKSEL_E (0x1 << 15) #define ACM_SACCES_MODE (0x01 << 10) #define NANWF_E (0x1 << 9) #define SE_D (0x1 << 8) /* Spare area disable */ #define CE1_ENABLE (0x1 << 4) /* Chip Enable 1 */ #define CE0_ENABLE (0x1 << 3) /* Chip Enable 0 */ #define TYPESEL_SET (0x1 << 0) /* * Clock settings using the PULSEx registers from FLCMNCR * * Some hardware uses bits called PULSEx instead of FCKSEL_E and QTSEL_E * to control the clock divider used between the High-Speed Peripheral Clock * and the FLCTL internal clock. If so, use CLK_8_BIT_xxx for connecting 8 bit * and CLK_16_BIT_xxx for connecting 16 bit bus bandwith NAND chips. For the 16 * bit version the divider is seperate for the pulse width of high and low * signals. */ #define PULSE3 (0x1 << 27) #define PULSE2 (0x1 << 17) #define PULSE1 (0x1 << 15) #define PULSE0 (0x1 << 9) #define CLK_8B_0_5 PULSE1 #define CLK_8B_1 0x0 #define CLK_8B_1_5 (PULSE1 | PULSE2) #define CLK_8B_2 PULSE0 #define CLK_8B_3 (PULSE0 | PULSE1 | PULSE2) #define CLK_8B_4 (PULSE0 | PULSE2) #define CLK_16B_6L_2H PULSE0 #define CLK_16B_9L_3H (PULSE0 | PULSE1 | PULSE2) #define CLK_16B_12L_4H (PULSE0 | PULSE2) /* FLCMDCR control bits */ #define ADRCNT2_E (0x1 << 31) /* 5byte address enable */ #define ADRMD_E (0x1 << 26) /* Sector address access */ #define CDSRC_E (0x1 << 25) /* Data buffer selection */ #define DOSR_E (0x1 << 24) /* Status read check */ #define SELRW (0x1 << 21) /* 0:read 1:write */ #define DOADR_E (0x1 << 20) /* Address stage execute */ #define ADRCNT_1 (0x00 << 18) /* Address data bytes: 1byte */ #define ADRCNT_2 (0x01 << 18) /* Address data bytes: 2byte */ #define ADRCNT_3 (0x02 << 18) /* Address data bytes: 3byte */ #define ADRCNT_4 (0x03 << 18) /* Address data bytes: 4byte */ #define DOCMD2_E (0x1 << 17) /* 2nd cmd stage execute */ #define DOCMD1_E (0x1 << 16) /* 1st cmd stage execute */ /* FLINTDMACR control bits */ #define ESTERINTE (0x1 << 24) /* ECC error interrupt enable */ #define AC1CLR (0x1 << 19) /* ECC FIFO clear */ #define AC0CLR (0x1 << 18) /* Data FIFO clear */ #define DREQ0EN (0x1 << 16) /* FLDTFIFODMA Request Enable */ #define ECERB (0x1 << 9) /* ECC error */ #define STERB (0x1 << 8) /* Status error */ #define STERINTE (0x1 << 4) /* Status error enable */ /* FLTRCR control bits */ #define TRSTRT (0x1 << 0) /* translation start */ #define TREND (0x1 << 1) /* translation end */ /* * FLHOLDCR control bits * * HOLDEN: Bus Occupancy Enable (inverted) * Enable this bit when the external bus might be used in between transfers. * If not set and the bus gets used by other modules, a deadlock occurs. */ #define HOLDEN (0x1 << 0) /* FL4ECCCR control bits */ #define _4ECCFA (0x1 << 2) /* 4 symbols correct fault */ #define _4ECCEND (0x1 << 1) /* 4 symbols end */ #define _4ECCEXST (0x1 << 0) /* 4 symbols exist */ #define LOOP_TIMEOUT_MAX 0x00010000 enum flctl_ecc_res_t { FL_SUCCESS, FL_REPAIRABLE, FL_ERROR, FL_TIMEOUT }; struct dma_chan; struct sh_flctl { struct nand_chip chip; struct platform_device *pdev; struct dev_pm_qos_request pm_qos; void __iomem *reg; resource_size_t fifo; uint8_t done_buff[2048 + 64]; /* max size 2048 + 64 */ int read_bytes; unsigned int index; int seqin_column; /* column in SEQIN cmd */ int seqin_page_addr; /* page_addr in SEQIN cmd */ uint32_t seqin_read_cmd; /* read cmd in SEQIN cmd */ int erase1_page_addr; /* page_addr in ERASE1 cmd */ uint32_t erase_ADRCNT; /* bits of FLCMDCR in ERASE1 cmd */ uint32_t rw_ADRCNT; /* bits of FLCMDCR in READ WRITE cmd */ uint32_t flcmncr_base; /* base value of FLCMNCR */ uint32_t flintdmacr_base; /* irq enable bits */ unsigned page_size:1; /* NAND page size (0 = 512, 1 = 2048) */ unsigned hwecc:1; /* Hardware ECC (0 = disabled, 1 = enabled) */ unsigned holden:1; /* Hardware has FLHOLDCR and HOLDEN is set */ unsigned qos_request:1; /* QoS request to prevent deep power shutdown */ /* DMA related objects */ struct dma_chan *chan_fifo0_rx; struct dma_chan *chan_fifo0_tx; struct completion dma_complete; }; struct sh_flctl_platform_data { struct mtd_partition *parts; int nr_parts; unsigned long flcmncr_val; unsigned has_hwecc:1; unsigned use_holden:1; unsigned int slave_id_fifo0_tx; unsigned int slave_id_fifo0_rx; }; static inline struct sh_flctl *mtd_to_flctl(struct mtd_info *mtdinfo) { return container_of(mtd_to_nand(mtdinfo), struct sh_flctl, chip); } #endif /* __SH_FLCTL_H__ */
Information contained on this website is for historical information purposes only and does not indicate or represent copyright ownership.
Created with Cregit http://github.com/cregit/cregit
Version 2.0-RC1