Contributors: 7
Author Tokens Token Proportion Commits Commit Proportion
Linus Walleij 207 85.54% 5 41.67%
Andy Shevchenko 14 5.79% 2 16.67%
Stephen Warren 7 2.89% 1 8.33%
Bartosz Golaszewski 6 2.48% 1 8.33%
Frank Li 5 2.07% 1 8.33%
Thomas Gleixner 2 0.83% 1 8.33%
Viresh Kumar 1 0.41% 1 8.33%
Total 242 12 


/* SPDX-License-Identifier: GPL-2.0-only */
/*
 * Interface the pinmux subsystem
 *
 * Copyright (C) 2011 ST-Ericsson SA
 * Written on behalf of Linaro for ST-Ericsson
 * Based on bits of regulator core, gpio core and clk core
 *
 * Author: Linus Walleij <linus.walleij@linaro.org>
 */
#ifndef __LINUX_PINCTRL_PINMUX_H
#define __LINUX_PINCTRL_PINMUX_H

#include <linux/types.h>

struct pinctrl_dev;
struct pinctrl_gpio_range;

/**
 * struct pinmux_ops - pinmux operations, to be implemented by pin controller
 * drivers that support pinmuxing
 * @request: called by the core to see if a certain pin can be made
 *	available for muxing. This is called by the core to acquire the pins
 *	before selecting any actual mux setting across a function. The driver
 *	is allowed to answer "no" by returning a negative error code
 * @free: the reverse function of the request() callback, frees a pin after
 *	being requested
 * @get_functions_count: returns number of selectable named functions available
 *	in this pinmux driver
 * @get_function_name: return the function name of the muxing selector,
 *	called by the core to figure out which mux setting it shall map a
 *	certain device to
 * @get_function_groups: return an array of groups names (in turn
 *	referencing pins) connected to a certain function selector. The group
 *	name can be used with the generic @pinctrl_ops to retrieve the
 *	actual pins affected. The applicable groups will be returned in
 *	@groups and the number of groups in @num_groups
 * @function_is_gpio: determine if the indicated function selector passed
 *	corresponds to the GPIO function which is used by the accelerated GPIO
 *	functions @gpio_request_enable, @gpio_disable_free and
 *	@gpio_set_direction. When the pin control core can properly determine
 *	if a function is a GPIO function, it is easier to use the @strict mode
 *	on the pin controller. Since a single function is passed, this is
 *	only useful on pin controllers that use a specific function for GPIO,
 *	and that usually presupposes that a one-group-per-pin approach is
 *	used, so that a single function can be set on a single pin to turn
 *	it to GPIO mode.
 * @set_mux: enable a certain muxing function with a certain pin group. The
 *	driver does not need to figure out whether enabling this function
 *	conflicts some other use of the pins in that group, such collisions
 *	are handled by the pinmux subsystem. The @func_selector selects a
 *	certain function whereas @group_selector selects a certain set of pins
 *	to be used. On simple controllers the latter argument may be ignored
 * @release_mux: Release software resources acquired by @set_mux. This callback
 *	must not change hardware state to avoid glitches when switching mux.
 * @gpio_request_enable: requests and enables GPIO on a certain pin.
 *	Implement this only if you can mux every pin individually as GPIO. The
 *	affected GPIO range is passed along with an offset(pin number) into that
 *	specific GPIO range - function selectors and pin groups are orthogonal
 *	to this, the core will however make sure the pins do not collide.
 * @gpio_disable_free: free up GPIO muxing on a certain pin, the reverse of
 *	@gpio_request_enable
 * @gpio_set_direction: Since controllers may need different configurations
 *	depending on whether the GPIO is configured as input or output,
 *	a direction selector function may be implemented as a backing
 *	to the GPIO controllers that need pin muxing.
 * @strict: do not allow simultaneous use of the same pin for GPIO and another
 *	function. Check both gpio_owner and mux_owner strictly before approving
 *	the pin request.
 */
struct pinmux_ops {
	int (*request) (struct pinctrl_dev *pctldev, unsigned int offset);
	int (*free) (struct pinctrl_dev *pctldev, unsigned int offset);
	int (*get_functions_count) (struct pinctrl_dev *pctldev);
	const char *(*get_function_name) (struct pinctrl_dev *pctldev,
					  unsigned int selector);
	int (*get_function_groups) (struct pinctrl_dev *pctldev,
				    unsigned int selector,
				    const char * const **groups,
				    unsigned int *num_groups);
	bool (*function_is_gpio) (struct pinctrl_dev *pctldev,
				  unsigned int selector);
	int (*set_mux) (struct pinctrl_dev *pctldev, unsigned int func_selector,
			unsigned int group_selector);
	void (*release_mux) (struct pinctrl_dev *pctldev,
			     unsigned int func_selector,
			     unsigned int group_selector);
	int (*gpio_request_enable) (struct pinctrl_dev *pctldev,
				    struct pinctrl_gpio_range *range,
				    unsigned int offset);
	void (*gpio_disable_free) (struct pinctrl_dev *pctldev,
				   struct pinctrl_gpio_range *range,
				   unsigned int offset);
	int (*gpio_set_direction) (struct pinctrl_dev *pctldev,
				   struct pinctrl_gpio_range *range,
				   unsigned int offset,
				   bool input);
	bool strict;
};

#endif /* __LINUX_PINCTRL_PINMUX_H */